Question about 2001 BMW 5 Series

Open Question

Premio G D4 Engine. Light on, and car slows down until i press the fuel pedal hardly

The engine light becomes on, and slows speed until you press hard the fuel pedal. What to do?

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 149 Answers

SOURCE: My car is not accelerating when I depress the gas pedal

i would change the fuel filter

Posted on Nov 23, 2008

Ad
Louie_3006
  • 79 Answers

SOURCE: BMW 320TDI HARD TO START WHEN WARM

Probable Spark plugs have blown. I would do a good tune up and replace your fuel filter, plugs and wires, oil and oil filter, air filter. Your system builds enough fuel pressure when it's cold becuase there is technically less are in your combustion chamber when it's cold so it can build more fuel pressure to start. When it's warm there's less room to build pressure to start your motor. So do a good tune up for now and see if that works. Hope you the best!

Posted on May 20, 2009

  • 50 Answers

SOURCE: 98 bmw z3 gas pedal meets resistance

has some of the fire wall sound deadner falling behind the pedal near the top where it mounts

Posted on May 31, 2009

  • 1 Answer

SOURCE: BMW 320TDI HARD TO START WHEN WARM

I had the same problem on my 330d M-Sport Touring. My problem was identified as 2 faulty injectors al;lowing too much fuel to flow back into the fuel lines. This resulted in reduced common rail pressure and the ECU would not start the injectors. I recommend getting a leak back test done and this will confirm if the injectors are good or bad. Try and find a Bosch service centre as these guys will know how to do the test and also how to fit the injectors properly.
Good luck

Posted on Jun 05, 2009

  • 836 Answers

SOURCE: My '02 745 BMW will not accelerate under normal

You have a injection problem, whether it's a sensor or fuel feed . I wouln't drive the car untill you have issue addressed as you coul;d cause real expensive damage. The PCM will have to be scanned to find out the cause.

Posted on Feb 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

The speedometer on my 1998 toyota D4 corona premio, 3s engine, suddenly drops when i step on the accelerator with the intention of increasing my speed. when i try to speed up the vehicle almost stops but...


GAS
3s-fse-d4-engine???? 3s-GE OR GE WITH RED BEAM? "VVT"
M./T OR A/T (STICK OR AUTO)
the key factor is engine RPM
if it rises, but not speed, that is trans./clutch slip
if no rpm rise that is weak engine , BUT IS THE RED BEAM.?

LOW POWER, 101
1: NEVER TUNED UP. BAD SPARK CLOGGED FILTES X2
2: ENGINE ecu stuck in limphome, scan it, see errors, BINGO
3: engine misfiring, cause by low compression, weak spark or bad fueling (too rich or too lean) many tests, ask.
4: low fuel pressure or regulator not regulation per FsM PAGE
5:STUCK OPEN egr main valve (missing in some countries)
6: melted cat converter , vacuum gage reads real bad,
7: and more, i charge more for more, LOL vvt?

ask or tell?
i want wild guessing
or I want to do the tests. to find it.

Gue$$ or Test.
toss coin.?


Jan 08, 2015 | Toyota Cars & Trucks

1 Answer

Engine power reduced


check the engine OBD2 codes. you may have bad crank shaft or cam shaft sensors. replace them all ....

Oct 12, 2017 | 2010 Chevrolet Cobalt

1 Answer

Toyota 1996 camry check engine light on, Steering hard, engine off itself.. any idea?


The first thing to find out is what trouble code the car's computer is storing. The check engine light tells you that there is a code available to enable you to home in on the trouble.
If the car will not move, follow the procedure in here, p296, by using a short bit of wire to connect terminals TE1 and E1 in Relay Block 5 under the hood.

http://www.turboninjas.com/camry/eg1.pdf



Then look up the trouble code.

Feb 15, 2013 | 1996 Toyota Camry

1 Answer

No speed when gas pedal is to floor tranny light came on


With the oil light coming on and the brake pedal being hard to press I would say that the engine stopped hence no vacuum -no power assist from the booster.- hard brake pedal. The lock uo feeling may come from the engine seizing up while you were still in gear

Feb 02, 2013 | 2003 Jeep Liberty

1 Answer

I have legacy2003.when using air conditioner....speed slow and force of engine decreases...and press fuel pedal hard ...engine response is very low


would need to plug it in as i think this model uses a fly by wire system ,so it could have a fault with the pedal sensor

Aug 02, 2010 | 2003 Subaru Legacy

1 Answer

My engine light keeps flashing off and on then it stays steady


replace the sparkplug wires. and avoid large puddles
rank me

Dec 11, 2008 | 2001 Ford Windstar

Not finding what you are looking for?
2001 BMW 5 Series Logo

Related Topics:

10 people viewed this question

Ask a Question

Usually answered in minutes!

Top BMW Experts

Anthony Jones
Anthony Jones

Level 2 Expert

128 Answers

Frankie B

Level 2 Expert

65 Answers

Doberman

Level 2 Expert

254 Answers

Are you a BMW Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...