Question about 1999 Toyota Camry

1 Answer

How do you adjust window angle 1999 Camry for better seal

The window is higher towards the front than the back and it's causing the weather stripping on the rear of the front window to not seal properly. This creates horrible wind noise.

Posted by on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

    Mayor:

    An expert whose answer gotĀ voted for 2 times.

  • Contributor
  • 35 Answers

You would need to remove the inner door panel. Loosen the bolts that hold the window regulator in place. Look for any slotted holes with the loosened bolt heads--those are your adjustment holes. Manually tip the window forward, noticing which bolts move and tighten accordingly.

Posted on Feb 16, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Murphybanton
  • 2004 Answers

SOURCE: 1999 toyota camry rear light seals

Yes.

Rate this.

Posted on Apr 15, 2009

SOURCE: Wind Buffeting on 2010 Toyota Camry

that is just the way the car is built, the newer cars with the aerodynamics set the way they are will have a buffering sound if only front or only rear windows are open, like you said the only way to negate that noise is to open the front windows a crack, its a characteristic of the vehicle, many new cars do that.

Posted on Jun 20, 2009

polarcycle
  • 1392 Answers

SOURCE: replacing rear struts on 1999 Camry

As long as you have the ready struts no. They come with the spring and mount already attached. If you don't, you better have a good spring compressor to remove the old strut and replace it with a new one.

Posted on Aug 12, 2009

Testimonial: "It's great to get a response this fast. I appreciate it. Thank you."

MNfisherman
  • 11896 Answers

SOURCE: 1999 toy camry front left, back rear brakes, don't

Either there is a leak in the lines, or there is air getting in master cylinder. Master cylinder must be bled first thing if it is new, then slave the brakes. You will most likely need to repeat the process a couple times. It would be good to have an electronic bleeder as well

Posted on Oct 01, 2009

  • 978 Answers

SOURCE: 1999 toyota camry blinker problem

get the back working it will no longer fast blink change bulb and check with metre see are you getting power to it also check grounds

Posted on Mar 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

What is causing my trunk to leak on my 1993 Honda accord?


Try checking the seals. If they are cracked or pieces missing. That will cause leaking.

Dec 30, 2014 | 1993 Honda Accord

1 Answer

How do I correct wind noise on drivers side door / window 1999 Camry?


There may be a torn, missing, or loose door gasket. If you inspect the seal and find torn or missing segments, repair or replace. If the seal is intact, the the most likely cause is a gap in the door seal near the top rear of the door. This happens over time because the door frame can actually get bent slightly outward. It is so little as to not be visible, but you can hear the wind noise. The way to get the noise to stop is to open the door and roll the window all the way down. Then, holding the door firmly, grasp the upper rear corner and pull it inward (toward to the car). A couple of sharp tugs will usually do the trick. I know it sounds silly, but it works. BE SURE TO HAVE THE WINDOW DOWN OR YOU COULD SHATTER THE GLASS!
The door frame is quite thin compared to other car body parts and will bow/bend if you pull on it. Start out carefully and if you don't get the results you want, try again with more force.

Nov 21, 2014 | 1999 Toyota Camry

1 Answer

Door on drivers side is noisy on 1998 Oldsmobile Bravada


I've seen the weather stripping unattached at the top right where the door angles down to the fender. Use some weather stripping adhesive to reattach.

May 13, 2014 | 1998 Oldsmobile Bravada

1 Answer

Need help with passenger window not aligned and not closing inside weatherstrip. How can I fix?


depending on what type of vehicle you have this could be an easy fix.
if your vehicle has a frame around the window, then the frame may be
sprung. roll the window all the way down, open the door, let the bottom inside of the door rest against your leg, then grab the frame at the top and pull it inward toward the vehicle. this will spring the frame back inward and help seal it against the weatherstripping. hope this helps....

Jan 28, 2013 | Cars & Trucks

1 Answer

How to install window weather strip on a 57 chevy 2 door hardtop? Where is the best place to start, quarter glass or front door?


start at front of car and work your way back DO NOT stretch the weather strip when driving water comes from the front right? Also if it's a hard top change the window flap springs before the install good luck thats my fav. car of all CJ

May 11, 2010 | Chevrolet Chevy Cars & Trucks

1 Answer

Driver side window you could hear it wishling


the window is not sealing against the weather stripping like it should. INspect the weather stripping for deterioration.

YOur motor could not be raising the window high enough either.

Mar 07, 2010 | 1996 Toyota Camry

2 Answers

Door leaks air rubber looks good


if air from upper window frame area let window down and with knee at door panel slightly pull in on upper door it will pull to seal if coming from lower door may need to have door lock/striker adjusted

Jan 21, 2010 | 2002 Chevrolet S-10

1 Answer

Where is the wind noise comming from?


You can get air leaks from the weather stripping around your side windows. You can also get a leak in your windshield Doors can also be out of adjustment so that they don't close correctly and cause air leaks around the foam seals.

Dec 05, 2009 | Land Rover Range Rover Cars & Trucks

1 Answer

Need a 1999 BMW Z3 Roadster owners manual, replacement back windo


I think you can ask this guy for the pdf file for your car, seems like he has everything
http://stores.ebay.com/Fancy-Motorcars?_rdc=1
let me know if you got it

Oct 26, 2009 | 1999 BMW Z3

1 Answer

Very loud wind noise around R/F passenger door


wind window down hold top of door frame put your knee on door and pull frame towards you this will give a tighter seal

Nov 18, 2008 | 2000 Chevrolet Silverado

Not finding what you are looking for?
1999 Toyota Camry Logo

88 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8210 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...