Question about Cars & Trucks

Open Question

Toyota caldina high tension leads no spark

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Rx7City
  • 3 Answers

SOURCE: mazda rx7 motor won`t run unless i get the spark

http://www.rx7city.com/phpbb2/

Posted on Jun 01, 2009

  • 32 Answers

SOURCE: 97 Toyota Caldina starting problem

you could have a bad cylanod in your starter that's what is sounds like or you might need a new starter sence you have looked and tested everything else that's the only other peice of resenable equitment left and if thats not it you could try the O2 sencer in the car if that's bad or going out it will make a car act that way. if that's not it then your problem, lys in the corb. but i would try the cylanoid in the starter first and work your way up from there

Posted on Sep 21, 2009

  • 114 Answers

SOURCE: Toyota Caldina cambelt broke. Valve damage?

Sorry to say there is most likely quite expensive damage to the valve train and pistons. A new cam belt can be installed and the motor rotated to see if it is turning freely after which you would do a compression check (lack of compression will indicate bent or broken valves). I've never seen a diesel break a belt and avoid damage, virtually always a catastrophic failure.

Posted on Dec 22, 2009

  • 1 Answer

SOURCE: my toyota caldina engine rpm rattles and and

Were there any water leaks into the interior? Or did you ever jump start someone else's car? I had the same exact problem resulting from jump starting a friend's car. It spiked the electronic control unit (ECU) computer. I changed the ECU and the problem was fixed.

Posted on Feb 02, 2010

trebeopt
  • 4 Answers

SOURCE: Who can help me with service repair manual for Toyota Caldina?

You can download it instant from http://infoservicemanuals.com/toyota-service-manuals/

Posted on Dec 23, 2013

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Toyota voxy not starting while engine has no fault.


first you need to check if there is spark on the high tension leads. if spark is okay, check if the spark doesn't go off when you crank to start. if no fault, again check the fuel flow and supply to the injector rail, injectors or carburetor

Mar 18, 2016 | Toyota Cars & Trucks

1 Answer

What HT means.


HT means high tension. This refers to the leads to the spark plugs as they are called HT leads and carry a high current.

Oct 20, 2015 | Cars & Trucks

1 Answer

Hi tension lead from #6 spark plug to the coil


Should be simple to unhook by pulling off each end and then reconnecting by pushing the new lead on. Very simple to do!

Oct 14, 2014 | Cars & Trucks

1 Answer

87 Toyota p/u 4x4 turns over won't start no spark at coil coil has 12 volts on both wires why is this should I have 12 volts on wires going to pickup in the distributor if so which wires should be hot???


12 volts at the low tension wire , hundreds at HT (high tension ) leads , they go to each plug, dont try testing them with a volt meter you will blow it up , and your hand as well,take one plug out , put the ht lead on it rest plug against the engine block , get someone to crank engine and watch plug to make sure you have a good spark, if not change the ign coil/s

Jul 06, 2014 | Cars & Trucks

1 Answer

High consumption of fuel


If you have serviced the engine, changed oil and oil filter and air filter and spark plugs and cleaned the carburettor or cleaned your throttle body and injectors, and its still heavy on fuel then try the following. Adjust the carburettor air and fuel. Take off the distributor cap and clean the rotor and spark pionts in the cap of carbon build up by means of light sand paper. Same applies to the spark/ high tension leads and coil lead metal connection points. Check distributor timing as well. If the engine smokes, do a compression test. If results are beneath factory specifications, remove cylinder head, replace the valve stem seals and re-seat the valves and or replace the pistons and piston rings. Basically engine overhall

Apr 13, 2014 | 1999 Toyota Corolla

1 Answer

WHERE ARE THE SPARK PLUGS


Caldina GT-T spark plugs are centrally located in the head, in deep wells in the cam cover.
As the GT-T does not have a distributor, you won't see spark plug wires. The intercooler needs to be removed and the four COP (coil-on-plug) assemblies tagged and unpluged. Unbolt and remove the COP assemblies and then use a long extension with the correctly sized spark plug socket to remove the plugs.
Keep the COP assemblies in order to replace in the same positions as removed.

Mar 13, 2014 | 1998 Toyota Caldina GT-T

1 Answer

95 Honda civic stalls when I accelerate


Test your compression on all 4 cylinders. Test fuel pressure at the rail. Check your spark plugs and leads while doing the compression test. It's unlikely to be bad spark plugs, but it's possible, that when you increase the load, the spark plug high-tension leads are finding a shorter path to ground. Just a few ideas on where to start.

Jan 06, 2013 | Cars & Trucks

2 Answers

Toyota Caldina GT-T choking and backfiring


1998... I would change the spark plugs & wires, add in fuel injector cleaner, change fuel filter & air filter.
Could be many different things here.
Check the spark plugs for any sign of oil that would stop them from firing like they should.

Dec 06, 2012 | 1998 Toyota Caldina GT-T

1 Answer

I have 1992 toyota windom 3.0 litre and its very hard to start


Check the condition of the following and replace as necessary:

1) Air filter
2) Fuel filter
3) Spark plugs
4) High tension leads (spark plug leads)

Nov 04, 2012 | Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...