Question about 1993 Lexus SC

Open Question

Fuel hose diagram for 1993 lexus sc300

Fuel hose routing to fuel rail cant remember how itok it off

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 29 Answers

SOURCE: 1992 sc300 lexus

it is under the vehicle, driver side, below the seating area, in front of the rear wheelwell, mounted on chassis in fuel line.

Posted on Sep 28, 2008

Ad
  • 1757 Answers

SOURCE: belt routing diagram for a 1993 lexus sc300

My apologies for the delayed response. I am going back to answer unanswered questions.
CLICK
on the following LINK. It has the Cam Alignment Mark Diagrams you will need.
If you would: Before Clicking let me know if this helped you, or if you have any additional information or questions. Feel Free to contact me at FixYa.com!
Again my sincerest apologies...
Thanks!

http://www.2carpros.com/car_repair_information/year/1993/make/lexus/model/sc_300/1993_lexus_sc_300_drive_belt_routing_diagram.htm

Posted on Mar 02, 2010

  • 1 Answer

SOURCE: where is the fuel filter located on a 1993 lexus

under the drivers side floorboard outside the car directly in front of the drivers side rear wheel

Posted on Jun 03, 2010

  • 1 Answer

SOURCE: 1993 lexus sc300 fuel pump

need to know exactly where the fuel pump relay is

Posted on Aug 03, 2010

Goofguyster
  • 379 Answers

SOURCE: where is fuel filter located for a 1993 lexus

yes and it located Under the drivers side floorboard outside the car directly in front of the drivers side rear wheel

Posted on Sep 16, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is crank shaft sensor location on 95 lexus sc300 please help


images for Where is crankshaft sensor location on 95 ...

eplaced engine on '97 SC300 now new engine does not have Crank ...

www.clublexus.com/.../633233-replaced-engine-on-97-sc300-now-new-...
May 4, 2012 - Location: arizona. Posts: 3 ... apparently 95-97s had an additional crank sensor. .... 1995 Lexus SC300 5spd Na-T ( TT Ecu Mod + a few others) 2jzge position sensor??
Nov 2, 2011
SC400 Crank Shaft Position Sensor. WHERE?????
Oct 11, 2011
SC300 No Spark
Oct 2, 2010
What happens if the Camshaft Position Sensor goes bad?
Jun 18, 2009
More results from www.clublexus.com

Lexus Crank Position Sensor ' LS400 SC300 ES300 GS300 ...

www.partsgeek.com > Crank Position Sensor > Lexus Parts & Accessories
Products 1 - 10 of 68 - 95 1995 Lexus LS400 Crank Position Sensor Denso NLA 7/13 ... 96 1996 Lexus SC300 Crank Position Sensor Denso Includes Pigtail.

Jan 27, 2016 | Lexus Cars & Trucks

1 Answer

Where is fuel filter located for a 1993 lexus


yes and it located Under the drivers side floorboard outside the car directly in front of the drivers side rear wheel

Sep 16, 2012 | 1993 Lexus SC

1 Answer

Fuel leak top of tank 2000 accent


did you remember to put the new o ring in, then is it seated right, next make sure none of the hoses came loose, my experiance is that one or more of the hoses fell off. make sure all hoses are routed to the proper hose connection

Jun 03, 2012 | 2000 Hyundai Accent

1 Answer

How to replace fuel pressure regulating valve


1991-94 Models - REMOVAL & INSTALLATION
  1. Remove the air intake tube and resonator assembly.
  2. Properly relieve the fuel system pressure.
  3. Remove the bolts from the fuel line clip.
  4. Using a 15 / 16 in. (24mm) backup wrench to prevent damage to the inlet port and bracket, disconnect the fuel inlet and return lines from the pressure regulator/fuel rail assembly.
If difficulty is encountered accessing the fuel return line nut, loosen and/or remove the fuel supply and rail attachment fasteners.
  1. Disengage the fuel pressure regulator vacuum hose.
zjlimited_1134.jpg

Fig. 6: Disengage the fuel pressure regulator vacuum hose

zjlimited_1135.jpg

Fig. 7: Use a suitable wrench to loosen ...

  1. Remove the regulator assembly attaching screw, then remove the regulator assembly. Plug the regulator port in the fuel rail with a clean rag to prevent system contamination.
zjlimited_1136.jpg

Fig. 8: ... and remove the mounting screw from the pressure regulator/fuel rail assembly

zjlimited_1137.jpg

Fig. 9: Remove the fuel pressure regulator assembly from the fuel rail
  1. Do not remove the O-ring from the retainer in the pressure regulator fuel outlet, unless it is damaged and requires replacing. Always remove and discard the O-ring from the fuel inlet.
To install:
  1. Lubricate the new fuel inlet O-ring and, if necessary, the new outlet O-ring with clean engine oil, then install the O-ring(s) in the pressure regulator assembly.
  2. Position the regulator assembly to the fuel rail. Coat the threads of the attaching bolt with Loctite® 242 or an equivalent threadlock, then install the bolt and tighten to 106 inch lbs. (12 Nm).
  3. Connect the fuel pressure regulator vacuum hose.
  4. Connect the fuel inlet and return lines, then tighten the lines to 133 inch lbs. (15 Nm) using a backup wrench to prevent port damage.
  5. Cycle the ignition switch to prime the fuel system, then start the engine and check for fuel leaks.
  6. Turn the ignition OFF and install the air intake tube and resonator assembly.

Hope this helps (remember to rate and comment this answer).

Apr 29, 2011 | 1993 Saturn SL2

1 Answer

Where is the fuel filter located?


the fuel filter is located in 1 of two places..

1.) under the hood, close to the firewall, look for a hose connecting to a cylinder type device and a hose leading from the device to the engine, If you cant find it, follow the hose from the engine fuel rail or fuel train, back to the firewall its along that connection.

2.) its on the line close to the tank, check a bit after the fuel pump connection along that same line.

Mar 31, 2011 | 1987 Cadillac Fleetwood

1 Answer

Cant find where the fuel line connects to the engine


If you find your fuel rails there should 2 lines.One is attached to the pulsation damper and feeds into the fuel rail which is usually in the front and on the top of the engine.The fuel then exits through the fuel rail,out the pressure relief valve and back to the tank.Most of your fuel lines are marked feed and return on the fuel hoses.If this doesn't work for you you can raise and support the front end .If you look on the frame on the driver side you should see the fuel lines that run from your fuel tank to your fuel rail or TBI (Throttle Body Injectors).Hope this helps you find it.

Feb 12, 2011 | 1997 Chevrolet Malibu

1 Answer

Where do I check the rubber hoses for a vacuum leak for the fuel rail pressure sensor. In other words where is it located? Thanks, Mike From previous post for code P0191 <<The fuel rail...


the fuel rail pressure sensor is located in between the high pressure line and the fuel rail on the passenger side. It will have 1 vacuum hose and one connector going to it.

I’m happy to assist further over the phone at https://www.6ya.com/expert/jeremy_d728a59f986299fa

Nov 30, 2010 | 2006 Ford Five Hundred

1 Answer

Belt diagram


This is for the 3.0 (SC300). If you have a SC400, please comment below and I'll get you the correct diagram.
e32d719.gif

Oct 25, 2010 | 1993 Lexus SC

1 Answer

Where Is the fuel filter on my 93 jeep Cherokee


your primary is in the tank connected to the fuel pump(but usually doesnt need change unless something goes wrong and u need to change your pump.)your 2ndary filter is on the frame rail on the drivers side, just above the rear tire. Two hose clamps and a 11mm bolt on the fuel filter strap.Remember to relieve the fuel pressure from the tank and test port on the fuel rail that connects the the injectors.

Sep 04, 2010 | 1993 Jeep Grand Cherokee

2 Answers

Where is the fuel pressure regulator on a 2004 explorer with v6


Along the fuel rail; after the fuel injectors...

faffc60.jpg

Fig. Fuel pressure relief valve-4.0L SOHC engine

Good luck (remember comment and rated this).

May 29, 2010 | 2004 Ford Explorer

Not finding what you are looking for?
1993 Lexus SC Logo

Related Topics:

94 people viewed this question

Ask a Question

Usually answered in minutes!

Top Lexus Experts

yadayada
yadayada

Level 3 Expert

80417 Answers

ROBERT GARCIA
ROBERT GARCIA

Level 3 Expert

918 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Are you a Lexus Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...