Question about 1981 Chevrolet Corvette

Open Question

Problem with 1950 Chevy. Need diagram to replace fuel lines on a 1950 6cyl chevy pickup

1950 Chevy pick-up fuel system diagram

Posted by Anonymous on

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1596 Answers

SOURCE: I need to replace the fuel pump in my 1985 Chevy S10 Pickup.

EXACT PROCEDURE ! Please Rate Me Fairly for this!! Thank you And Good Luck !!


ELECTRIC PUMP

REMOVAL

  1. Before servicing the fuel pump the fuel system pressure must be relieved. See: Fuel Pressure Release
  2. Disconnect the negative battery cable.
  3. Raise the car on a hoist.
  4. Remove the fuel tank. See Fuel Tank / Service and Repair.
  5. Remove the fuel tank sending unit and pump assembly by turning the cam lock ring counterclockwise. Lift assembly from the fuel tank.
  6. Pull the fuel pump up into the attaching hose while pulling outward away from the bottom support. Take care to prevent damage to the rubber insulator and strainer during removal. After the pump assembly is clear of the bottom support, pull the pump assembly out of the rubber connector for removal. NOTE: Inspect the fuel pump attaching hose for any signs of deterioration. Also check the rubber sound insulator at the bottom of the pump. Replace damaged or deteriorated parts.
INSTALLATION
  1. Push the fuel pump assembly into the attaching hose.
  2. Position the fuel tank sending unit and pump assembly into the fuel tank. Use a new "O" ring seal. NOTE: Care should be taken not to fold over or twist the strainer when installing the sending unit as this will restrict the flow of fuel. Also, verify that the strainer does not block the full travel of the float arm.
  3. Install cam lock over the assembly and lock by turning clockwise.
  4. Reinstall fuel tank.
MECHANICAL PUMP

REMOVAL and INSTALLATION

NOTE: To ease pump installation, rotate the camshaft so the camshaft eccentric is out of the way of the fuel pump rocker arm.

  1. Disconnect fuel lines from fuel pump.
  2. Remove fuel pump mounting bolts and the fuel pump.
  3. Remove all gasket material from the pump and block gasket surfaces. Apply sealer to both sides of new gasket.
  4. Position gasket on pump flange and hold pump in position against its mounting surface. Make sure rocker arm is riding on camshaft eccentric.
  5. Press pump tight against its mounting. Install retaining screws and tighten them alternately.
  6. Connect fuel lines. Then operate engine and check for leaks.

Posted on Mar 22, 2009

  • 2002 Answers

SOURCE: need diagram of fuel system for 1995 chevy s10

The only way I know of to get the diagram you are looking for is to acquire a "build book". Even dealer service manuals don't have this diagram. I got one from faxonautoliterature for $49 plus shipping. A better bet would be to find a spot on either end of the leak where you can work on it easily and work from there. Hope this helps.

Posted on Dec 02, 2009

  • 152 Answers

SOURCE: need diagram to replace vacuum lines on a 1981

bc67920.gif Try this, sorry for the size, space limited in our posts.

Posted on Apr 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I changed the gas tank on my chevy s10 pickup 6cyl 2wd and i just replaced the gas filter recently because my truck basiclly stoped getting fuel the lines and pump are new also. but my truck was sitten for...


There is no need to bleed the fuel system. Do you want to drain the old gas? You can just disconnect the fuel line at the engine or if front of the tank and jump the pump relay socket to power up the pump.

Jul 21, 2017 | Cars & Trucks

1 Answer

Fuel pump wiring for 19980 chevy blazer


We have no wiring diagrams, they are copyrighted. Go here to purchase the rights to view them on line.

Sep 03, 2012 | Chevrolet Blazer Cars & Trucks

1 Answer

I need a schematic of engine too find fuel bleeder on a 1998 chevy s10 pick up


You will have a tough time looking for the fuel bleeder.
Fill your gas tank start the motor and run for a while
it will pull the air out of the lines and in turn bleed the lines of any air.

Jul 09, 2011 | 1998 Chevrolet S-10 Pickup

1 Answer

1997 chevy s-10 6cyl won't start with new battery. Engine turns, but it won't crank.


crank no start? I would check for fuel pressure on these models, the fuel pump module is quite often repalced. Then I would check ignition cap and rotor. Cap get white with corrosion and rotor green.

Nov 29, 2010 | 1997 Chevrolet S-10 Pickup

1 Answer

I dont know how to replace a fuel filter on my 1984 chevy s10 can you help me out


1984 Chevrolet Truck S10 P/U 4WD 2.8L 2BL 6cyl the Fuel Filter is located under hood, center, upper engine area, front of carburetor, mounted in fuel line.

First, release the fuel pressure by opening the fuel filler door. Then you replace it by squeezing the quick release plastic clip on the front and sliding the fuel line forward; you then use a wrench to loosen the nut on the back. Be prepared for some gas spillage with a container or some old rags. Once it is loosened, you remove it from its bracket, replace it, hook it back up (reverse of what you did) and it should be good to go.

Good luck.

May 19, 2010 | 1984 Chevrolet Chevy

1 Answer

Need diagram of fuel system for 1995 chevy s10


The only way I know of to get the diagram you are looking for is to acquire a "build book". Even dealer service manuals don't have this diagram. I got one from faxonautoliterature for $49 plus shipping. A better bet would be to find a spot on either end of the leak where you can work on it easily and work from there. Hope this helps.

Dec 02, 2009 | 1995 Chevrolet S-10 CA Edition

2 Answers

Need diagram to replace vacuum lines on a 1981 6cyl chevy pickup


bc67920.gif Try this, sorry for the size, space limited in our posts.

Nov 27, 2009 | 1981 Chevrolet Corvette

1 Answer

98 chevy 6cyl pickup standard trans sometime won't start ,sometimes when you turn engine of yoiu have to wait 20 minutes before it will start again. It has new plugs,new fuel pump,


You may have to inspect the starter relay or the starter. Also take a look at the wiring for some loose connections or bad wires that needs replacing.

Nov 02, 2009 | 1998 Chevrolet S-10 Pickup

1 Answer

Locating fuel filter on 97 chevy s-10


hi go to tank and follow lines to the fuel filter

Sep 07, 2009 | 1997 Chevrolet S-10 Pickup

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...