Question about Hyundai Cars & Trucks

Open Question

Hyundai Santa Fe 2008 Fault code P0003. Rough idle on start up, check engine light comes on, trans-axel flashes and cannot accelerate. Turn vehicle on and off several times and all is good. If vehicl

Check engine light goes out if vehicle is started several times in short period,or re set

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 Silverado rough idle, idles good after "check engine" light

Check your o2 sensor voltage, those trucks are real bad for o2 sensors, and yes if one sensor is reading 0mv, the others will start to drop out, and the vehicle will run very, rough. You also may check fuel system pressure, should be almost 60p.s.i. If its alot lower, Id be looking into a fuel pump. If that vehicle is drive-by-wire (no throttle cable), the throttle bodies get very dirty and cause that concern also. Id start by having the vehicle scantested.

Posted on Feb 07, 2009

  • 2039 Answers

SOURCE: Check engine light on and rough idle

1st get the car pass on a scanner so you can tell me the code that the first step to fix the trouble please dont rate thanks for trying pierre

Posted on Mar 01, 2009

  • 4 Answers

SOURCE: Will not rev over 2000 rpm 2003 hyundai santa fe 2.4 eng

get someone to rev the car and see if the exhaust note sounds muffled!!! i.e blocked or bent if it sounds normal chech fuel pressure and more importantly fuel flow the guy with air flow meter was proberbly right
regards ray w QLD OZ

Posted on Apr 06, 2009

goalie39
  • 469 Answers

SOURCE: ''check engine light'' illuminated, 1004 Hyundai, Santa Fe

If you live in the US, take it to qany Auto Zone store and thy will read the codes off for you, I would suspect any right thinking competitor would do the same, check if you don't have one near by.

Hope this is of some help.
Ed

Posted on Apr 21, 2009

  • 82 Answers

SOURCE: 2004 santa fe hyundai

it is probably going into a fail safe mode, get it to a dealer and have it scanned for dtc's

Posted on Apr 30, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Why my 2004 hyundai santa fe cuts off when i try to accelerate.starts and idles fine


You need to do a fault code test to see if any problems exist that could explain this. Also exactly when does it cut off.

Sep 29, 2016 | 2004 Hyundai Santa Fe

2 Answers

I have a 2003 hyundai Santa fe 3.7 L it will start but runs super rough and dies most of the time.what would cause this to happen?


check condition of spark plugs and confirm that its firing on all cylinders also check condition of fuel filter have diagnostic test done to see if engine coolant temp sensor comes up as fault

Jan 28, 2016 | Hyundai Cars & Trucks

1 Answer

My 2001 hyundai sante fe gl accelerates slow and seems not to shift out of gear i tried to do the manual shifting but it doesnt seem to help


You need to replace tranny, is your check engine light on? if so get codes read for free at Auto Zone parts store,,,Lots of miles on vehecle? Trans fluid should be changed at 40 thousand miles. Most folk dont do this and thats why trannys go out,,,and treating the trans bad like getting stuck in snow and driveing rough all cause bad trannys

Mar 16, 2011 | 2001 Hyundai Santa Fe

1 Answer

Hyunday Santa Fe 2008 3.3l Sudden loss of power while driving on the highway. Engine does not cut out but idles apparently normally. No response from engine when stepping on accelerator pedal. ESC and...


well, if check engine ligth on have the codes pull to find out the problem it may be mapp ,air ,sensor bad ..if engine ligth is on its picking up a a code..

Dec 20, 2010 | Hyundai Santa Fe Cars & Trucks

2 Answers

2001 Hyundai Santa Fe check engine light and transmision troubles


your guess is as good as anyones. Someone will have to look at this in person.

Nov 18, 2009 | 2001 Hyundai Santa Fe

1 Answer

Car will not accelerate in high gears, and does


Ok... do you have the maintenance history on this vehicle? Did the 'Check Engine' Light come ON? Whenever the 'CHECK ENGINE' light comes on, the ECU (Engine Control Unit) sets a Diagnostic Trouble Code (DTC). These codes identify the particular engine management system which caused the light to come on. You'll need to use/find an OBDII (On-Board Diagnostic) Scanner to retrieve any code which have been stored in the ECU computer. Afterward, we might be able to help you DIAGNOSE and perhaps eventually fix the problem.

Jul 31, 2009 | 2001 Hyundai Santa Fe

1 Answer

Stopped acceleration, santa fe 2007,2.7, v6


How many miles on this vehicle?... Still under warranty.

Jun 10, 2009 | 2007 Hyundai Santa Fe Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

55 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...