Question about Cars & Trucks

Open Question

Ford falcon ba traction control warning light

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Hentie
  • 18 Answers

SOURCE: after replacing the left front wheel bearing on a 2003 ford focus, the abs and traction warning light stay on

The bearings on the wheels has to be installed one way only, the rotor ring is built into the bearing and if installed the wrong way round the sensor cant pick up the wheel speed causing the ligt to be switched on in the cluster. The diagnostic equipment should pick this up as a fault once the car has been driven, it will see the sensor when you do the diagnostic if the car is standing still but once the car is moving and no signal is send from that wheel it would register a fault into the memory of the PCM that you would be able to retrieve later.
There is a way for you to test the sensor yourself by using a multimeter set on volts, you jack the vehicle up at that wheel, install a vehicle stand to support the vehicle to be safe, disconect the wheel speed sensor and probe the two wires into the sensor, spin the wheel by hand and a small amount of current will be produced meaning the the sensor is working and the wheel bearing is installed the correct way, you can also do a continuaty test on the sensor by switching the multimeter onto ohms, but be very carefull, if this sensor has three wires you cant do the continuaty test because of the integrated circuit in the sensor, the three wire sensors opperate on a voltage from 5Volt and it would be destroyed by the multimeter opperating on 9Volt.
If the continuaty test passes and the bearing is installed the correct way, the most comon fault would be a break in the wiring leading to the PCM
Hope this will be helpfull.

Posted on May 04, 2009

  • 64 Answers

SOURCE: 2006 Ford Five Hundred traction control light on all the time.

The traction light came on in my Ford 500 SEL along with the ABS light. If this happened, the problem was low battery power and a bad alternator. A fully charged battery fixed it for me after driving a couple of miles.

Posted on Jun 23, 2009

  • 3 Answers

SOURCE: Handbrake and Traction control warning lights illuminated amber

Had DTC warning light come on on my 120i (2005 reg). Without prompting dealer contacted BMW who agreed to pay for part and half the labour as it seems to be a common problem for 04-06 models.

Posted on Sep 17, 2009

  • 1 Answer

SOURCE: 03 Yukon Denali Traction Control/ ABS Problems

my 2000 yukon has the traction control light on and the abs light on any anwsers?

Posted on Nov 28, 2009

  • 24 Answers

SOURCE: need a diagram to change rear wheel bearings

if you are looking for a manual for this car, try this link... http://cgi.ebay.ph/Ford-Falcon-Ute-BA-series-Repair-Manual-2002-2005-on-CD_W0QQitemZ170423275380QQcmdZViewItemQQptZAU_Clothing_Merchandise_Media?hash=item27ae04cf74 For twenty bucks you can do it all yourself

Posted on Feb 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Need fuse diagram for ba?


Howdy howdy John Mullins,

Thanks for adding the 2003 CLUE... that verified what I was suspecting: I am guessing the "BA" FORD nomenclature is pretty obscure ... I had to LOOK that part up... also "Utes"... Cute!

Now I am understanding "BA" to be a series of "Falcon" Fords
indigenous to DOWN UNDER typically between 2002 and 2005
(or 2003 to 2008... else where on the internet).

Being a life long FORD owner... I can tell you for certain FORD Factory manuals were/are available from the dealers... Being old fashioned... I like the hard copies (and have too many cars not to be self reliant)... and they all have the wiring diagrams, circuit drawings... schematics FOR SURE (Volume 3 of 3 on my '04 Navigator & Volume 3 of 5 on my '75 Ranchero).

You are going to like the last (Cabulture AU, local) option the best... eBay.

Ford Falcon BA
Ford LTD BA Service Manual Download pdf
http://manuals43.hobsonjuiceplus.com/manual-ba-ford-v8-2003-yskfqvy.pdf


2003 BA FORD workshop MANUALS


FORD FAIRLANE GHIA BA 2003 2005 WORKSHOP MANUAL All Manuals 12

1974 FORD CAR LINCOLN MERCURY TORINO RANCHERO OEM SERVICE SHOP REPAIR...

Mar 11, 2016 | Cars & Trucks

1 Answer

My Falcon seems to take a while to start and I have to press the accelerator as well or it will stall, whats the deal?


My 2004 BA Falcon won't start. Apparently it's low - Fixya

www.fixya.com/cars/t12343045-2004_ba_falcon_start_apparently_s_low
Apr 8, 2012 - Apparently it's low on - Ford 2005 Falcon 4.0 question. ... Ba engine generally is strong, common fault is ecu, if hard starting when cold, pour hot water on computer and it ... If the headlights do not dim or go out, then the battery is likely ok..... Automatic 2004 BA Falcon stalls while driving ... Open Questions:.

My xr6 won't start. Comes up saying immobilized. - Fixya

www.fixya.com/.../t12430461-xr6_start_comes_up_saying_immobilized
Feb 6, 2012 - My xr6 won't start. ... Question about 2005 Ford Falcon 4.0 ... you will get airbag errors popping up for a few weeks then after a while it .... in a while it willstart and run for about 20 seconds, then it dies and won't start. ... Open Questions: ...You may NOT copy or distribute the content that appears on this site ...

Ford falcon sometimes won't start - Ford - Automotive - Whirlpool ...

forums.whirlpool.net.au > Automotive > Ford

WhirlpoolOct 26, 2010 - I have a EF Falcon that has an intermittent problem with starting. ... It might take a minute or 5 minutes or persistent retrying. ... Normally if you wiggle the T-Bar around it will then start. ... motor with a rebuilt unit, I had a remove starter on myalarm, and would use the remote start while using my jack-handle to ... Worst Car You Ever Owned
Jun 1, 2012
LPG conversion problems with stalling - Ford
Jan 16, 2012
More results from forums.whirlpool.net.au

2006 Ford Explorer Engine Stalls While Idling: 24 Complaints

www.carcomplaints.com/Ford/Explorer/.../engine_stalls_while_idling.sht...

Jan 27, 2016 | 2005 Ford Falcon 4.0

1 Answer

BA Falcon Ute Brake lights come on when headlights are on Any idea why


check with ford service centre as ford used a light module that controlled all light functions . the module is prone to failure if you have one

Feb 09, 2015 | Cars & Trucks

1 Answer

Ba ford xr6


it needs to be taken to the dealer

Oct 29, 2013 | 2005 Ford Falcon 4.0

2 Answers

I need a manual for a 2004 Ford Falcon BA Futura


Hello,
Please kindly follow the link below to get the manual you requsted for;
http://fitripdf.com/books/ba-gt-ford-falcon-service-manual-2.html


thank you for using fixya

Dec 19, 2010 | Ford Futura Cars & Trucks

5 Answers

BA Falcon 'door open' light is on, can't lock


Hi I have the same problem on my BA XT Falcon
Strangely it only happens after it's rained on my car (usually overnight) I then notice that the drivers lock is up and will not lock again until a nice sunny day comes and I leave all doors wide open for hours and hours!! Then all of a sudden once closing all doors normally the little dash door light turns off, and I can again lock the doors
?
Since it rained all last night here, guess what? It happened again!
So I've checked everywhere and cleaned and you name it, but nothing, I'm positive that when a warm sunny day comes again though, all will be ok.
Most annoying issue ever.
Where is this tiny bit of water that's causing this?
And which door?? Can I just disconnect one door at a time? I don't know it's driving me crazy!!!!

Jun 05, 2010 | 2005 Ford Futura

1 Answer

Need a diagram to change rear wheel bearings ford falcon ba ute


if you are looking for a manual for this car, try this link... http://cgi.ebay.ph/Ford-Falcon-Ute-BA-series-Repair-Manual-2002-2005-on-CD_W0QQitemZ170423275380QQcmdZViewItemQQptZAU_Clothing_Merchandise_Media?hash=item27ae04cf74 For twenty bucks you can do it all yourself

Feb 05, 2010 | 1999 Ford Taurus

1 Answer

Traction control


have the tyres speed balanced. your alignment might also be a bit messed up, have this check and corrected.

Apr 02, 2009 | 2003 Ford E250

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

32 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...