Question about 2009 Chevrolet Impala LS

Open Question

Mafunction indicator lamp went on after car starter would not work

What can I do to fix this problem never ha this happen before. light stays on

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

1999 vw passat turbo wont crank or turn lights on


- Switch on the head lamps for 5 minutes.
- Keeping the head lamps ON, start the engine.
If the lights die,
- Check the battery terminals.
- Check battery state of charge.
- Charging system.
If the lights still glow sharply,
- Check fuses and relays in under the hood fuse and relay box junction.
- Battery to starter motor cable.
- Battery to engine ground and chassis ground cable.
- Solenoid on starter motor.
- Starter motor.
- Wiring.
-Ignition switch.

Mar 02, 2014 | 1999 Volkswagen Passat

2 Answers

Malfunction Indicator Lamp


If you are not experiencing any running symptoms, you should be ok but take it in as soon as possible just in case it is serious which may end up costing more if you wait too long.

Dec 26, 2013 | 2003 Volkswagen New Beetle Convertible

1 Answer

Good morning, I have a 2003 lincoln ls v8 and the check advance trac has come on dashboard and the car has begain to sway above 30 miles an hour and feels like the gas peddle is sticking


You have a MIL Lamp (mafunction indicator fault code
for the ABS Braking System)

It could be a Wheel Speed Sensor or a half dozen
other issues.

Don't drive it more than a couple days, until your
able to schedule a diagnoses and repair

Mar 14, 2011 | 2003 Lincoln LS

1 Answer

Battery light is staying on. replaced the battery, alternator, and has a new starter, and serpentine belt


with engine control switch ON and engine running at amoderate speed, charge indicator lamp should be off, if lamp is not off, detach wiring harness at generator. iflamp goes off generator is faulty. if lamps stay on, check for grounded "L" terminal in wire harnes

Jun 19, 2010 | 1991 Chevrolet Corsica

1 Answer

2004 Dodge Durango electrical issue


the problem started because the battery was disconnected
try using a scan tool to reset the ECM program

Apr 29, 2017 | 2004 Dodge Durango

1 Answer

Brake light went out, I replaced all the bulbs, but its still out


Hi, have you checked to see if the eye level brake light is working, other than that check the wiring harness for the boot/tail gate within the rubber corrugated trunking on the right hand side near the boot hinge as it is quite common for the wires to break wear they always flex and check the multiplug on the back of the rear light unit as the earth terminal may have burned out, hope this helps, regards mark.

Feb 25, 2009 | 2003 BMW 330

1 Answer

Daewoo nubira 1998 cdx manual, malfunction indicator lamp is on


Does the car drive normally? Try removing the battery terminal(negative) and reconnecting it after 10 minutes and see what happens.
Let us know how you get on.
cheers

Nov 30, 2008 | 1999 Daewoo Nubira

1 Answer

Dash board,head light,tail ligts stays on when engine is off


The P0420 that you are getting may be an inoperative air/fuel sensor (the actual code is "catalyst system efficiency below threshold". This code will not affect the head/tail lamps or dash lights.
You may have a bad headlamp switch.

Jul 24, 2008 | 2000 Toyota Corolla

1 Answer

1991 pulsar speedo


speedo went to zero km, indicators in dash work opposite, taco isn't working either.

Jul 03, 2008 | 1990 Nissan Pulsar

Not finding what you are looking for?
2009 Chevrolet Impala LS Logo

Related Topics:

10 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...