Question about Ford Tractor Model 8N Operators Manual 1948-1952

Open Question

Find Chaffoteaux et Maury Bayard 10 manual - Ford Tractor Model 8N Operators Manual 1948-1952

Posted by Anonymous on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I adjust the emergency brake?


Hi Maury

Get underneath and tighten the emergency brake cable. Remove slackness

Aug 17, 2015 | 2004 Ford Focus

1 Answer

I bought a new astroflex remote starter and it won't program to my 2007 hummer h3


If its new it should still be covered by the warranty Astorstart support services will help you get it paired.

Technical Support: E-mail: support@astrostart.com Hours: 8:30 a.m.-7:30 p.m. ET, Monday-Friday 10 a.m.-2 p.m. ET, Saturday Find a Store (by phone): Find a Store (online): Store Locator

Nov 25, 2014 | 2007 Hummer H3X

1 Answer

How do I turn off traction control in a 99 alero, keep getting stuck in the snow, also I can't find a button for 4 ways, had this car 6 months and have spent over $2000 in repairs. Help!!


If your model is equipped with traction control, the button on the console marked ETS turns it on and off. Page 4-10
The hazard flasher button is in the middle of the dash with a triangle symbol.
Check your owners manual for details.

Feb 05, 2014 | Cars & Trucks

1 Answer

9@how to fix dtc p1178 and p1118 on a 2002 hyundai xg350


I live in Australia & have a Hyundai Grandeur XG 3LT V6 2002 model (US equivalent is Hyundai XG300).
Fault codes are P1118 (ETS motor fault) & P1178 (ETS motor battery voltage open). An intermittent fault.
The first code denotes general area of the fault & the second code denotes the specific fault.
So the specific fault is that the ETS-PCM computer is not receiving 12V on pin 2 with ignition on.
'Check engine' light remains on & car is in 'limp home mode' with very little power & poor performance.
I had purchased the Hyundai service manual online (ebook about $8) for the US model. Could not find any
manual for the Australian model. On page FLA-52 found the block diagram for the whole ETS system.
I am a retired electrical engineer so now it became easier for me to find the fault.
There are 2 computers behind the center console. PCM & ETS-PCM.
Pin 2 of the ETS-PCM should have 12V present when ignition is on.
In fault mode 12V was not present. This 12V is supplied from ETS 15A fuse (fuse box under dashboard)
via a relay (i will call this relay the ETS relay). The 15A fuse was OK but the 12V was only
intermittently being passed through the relay points. Relay is located near ignition switch on a
sub panel which has about 6 relays on it. ETS relay was at right bottom corner of sub panel.
Yellow wire feeds the 12V (which is always present even with ign. switch off) to the relay points.
White wire is the output wire from the relay points which feeds 12V to pin 2 of the ETS-PCM computer.
Measure if 12V is present at white wire when ign. switch is turned on (no need to start engine)
I only had the 12V present intermittently. So pulled out the ETS relay - tested contacts with
ohmmeter & found to be only making contact intermittently when relay lever depressed
- removed relay case by grinding away one corner of the case - cleaned the relay points with fine sandpaper.
replaced the relay case & taped with black insulating tape to keep out dust. Tested relay with ohmmeter & points
now OK. Fault is now cleared & car is operating normally.
Also had previously purchased on Ebay a Can OBD11 scanner for $15 which read the fault codes OK.
Hope this helps other people with similar problem.

Mar 15, 2011 | Hyundai Motor 2003 XG350

1 Answer

What is an ETS light keeps flashing what does this mean


This a technical bulletin for your car
Hope this helps, if it does please leave feedback
Good Luck



File In Section: 5 - Brakes
Bulletin No.: 63-50-09
Date: March, 1996
INFORMATION
Subject:
"ETS OFF" Indicator Lamp On with No DTC's Set Models:
1996 Buick Skylark
1996 Chevrolet Cavalier
1996 Oldsmobile Achieva
1996 Pontiac Grand Am, Sunfire On vehicles equipped with Enhanced Traction System (ETS), the "ETS OFF" indicator lamp may come on and ETS and Cruise Control might become disabled. There may be no ABS or PCM Diagnostic Trouble Codes (DTC's) stored and there may be no "Check Engine" lamp on. This condition has caused a high rate of unnecessary IPC replacements.
The PCM sets a Type "C" or "D" FAILURE RECORD which sends a message to the Electronic Brake Control Module (EBCM) to turn the "ETS OFF" indicator on and to disable ETS. The PCM can then disable Cruise Control, but may not turn on a corresponding "Check Engine" lamp. These Type "C" or "D" Failure Records are not stored in the normal Current or History menus.
41807575
The technician is instructed to check normal operation of the "ETS OFF" switch and the ETS system. The technician is then instructed to check for Failure Records and directed to Section 6E3-A of the Service Manual, see chart. When the PCM Failure Record is corrected, normal operation of the ETS system and Cruise Control should return.



Jan 01, 2011 | 1996 Pontiac Grand Am

1 Answer

I have 2002 xg350 and the water pump went out and then rolled the timing belt off and bent the valves. Pulled the heads and had repaired. reassembled and it ran fine for 24 hrs. and then it popped code...


Hi

The ETS limp home valve may be on. Clean the throttle body and intake runners with intake cleaner with engine running. Then do a ETS initialization as follows:

ETS INITIALIZATION PRCEDURE:
Turn the ignition key to the ON position (for less than one second) and quickly turn the ignition key back to the OFF position.
Wait 10 seconds in off position.The ETS Module performs the INITIALIZATION process and at completion you will hear a click from under dash. Turn the key on for 1 second then start the vehicle.

Hope this helps - Steve

Feb 20, 2010 | Hyundai XG350 Cars & Trucks

1 Answer

What is correct xmission dip stick length?


Not sure on the lenght but if you take the old one to a scrap yard and tell them what transmission it's out of, they should be able to fix you up. Use the old one to double check the length.

Jul 11, 2009 | Chevrolet Malibu Cars & Trucks

1 Answer

ETS LIGHT CAME ON THE PANAL, AND I DON'T KNOW WHAT IT IS FOR. I DO NOT HAVE A MANUAL


ETS light is traction control there is a fault code in the EBCM you will have to have diag

May 02, 2009 | Pontiac Sunfire Cars & Trucks

Not finding what you are looking for?
Ford Tractor Model 8N Operators Manual 1948-1952 Logo

Related Topics:

66 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

fordexpert

Level 3 Expert

5613 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...