Question about 2008 Mercury Milan

Open Question

Car mercury milan is running rough

Is running rough when I press on the gas and idles high until over 30mp and the check eng light is on

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get to try the service completely Free afterwhich it costs $6 per call and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 63 Answers

SOURCE: 2007 mercury milan V6 Car wont start. Jumped it

Remove the lugs at the battery. Clean the posts and the lugs - then reconnect. Your battery won't charge (and the jumpers won't work) largely because of a film on the + post and lug. If you live in a hot summer area, (Arizona) the problem is especially troublesome.

Posted on Jul 15, 2009

Ad
  • 1201 Answers

SOURCE: after putting gas in the car started running rough and is chockin

It wouldn't hurt to change the filter, but it sounds like you got a bad batch of gas, if it was running good before you got gas.
Get a bottle of dry gas and put it in the tank, if there is any water in the gas, that will clear it out, also it wouldn't hurt to put a bottle of fuel injector cleaner in the tank, I use that stuff all the time to keep the fuel system clean.

Posted on Jul 17, 2009

  • 1 Answer

SOURCE: rough idle

Mercury had a recall on 3.0 duratech motors in 2000 and 2001. If you get a fuel smell at startup then you might have a bad lower intake gasket, it could cause a miss if seal is cracked. Article No. 01-4-3 you can get it on AllData.

Also, check the PC rubber L piece that runs from the PVC valve to under the throttle control - it could be busted.

Make sure ignition wires are not cracked. If you haven't tuned it up in over 30-40K consider doing that.

Posted on Sep 16, 2009

  • 1 Answer

SOURCE: Upgrading 2006 Mercury Milan's sound system with MP3 jack.

Even though your current radio has an AUX button the radio is not programmed to utilize it.
There is no 'easy' way to add the '07 Job 2 and later year model's factory Aux input.
You will need to buy an aftermarket solution. Something like this http://pac-audio.com/productDetails.aspx?ProductId=821&CategoryID=24

Posted on Jan 19, 2010

Keef2011
  • 160 Answers

SOURCE: 2006 mercury montego. DTC

These codes relate to an electronic throttle body fault. Normally its from dirt, hardening oil deposits jamming the throttle body movement. Try cleaning the throttle body first before going down the replacement route. Hope this helps....

Posted on Mar 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 1992 ford ranger 3.0 idle rough and the tail pipe is black and bad gas miles


check for clogged air filter and oxygen sensor if check eng light is on

Feb 28, 2015 | 1992 Ford Ranger

1 Answer

328 gts 1986 very rough idle, running rich you can smell the gas from the exhaust . runs fine once the throttle is pressed


you need to adjust your idle screw on your carb i could tell ya how on that type of car but your running to high of an idle and flooding your cylinders thats y it is idleing rough and you can smell the gas, adjust your idle screw back a little and then you might want to check your plugs and make sure you didnt fowl and of them with it running rich

Apr 21, 2011 | Ferrari 328 Cars & Trucks

1 Answer

I have a 2002 Mercury Sable w/ 3.0L DOHC. The Fuel Cap light keeps on, yesterday the engine started idleing rough, today it acts like a stuck throttle until the car is stoped and then it acts like it...


You have a vacuum leak some where. Engine uses vacuum to burn gas vapors in gas tank. This is the EVAP SYSTEM. This system can detect a small leak or large leak. (gas cap light.) But there are also other items on the car that use vacuum to do work. The PCV circuit . This vents the engine's crank case. Also power brakes and some ac/heater controls. Now it sound like a good size vacuum leak if car idle is "high". I would say open the hood and listen. When car first starts idle should be around 1500 rpm or so. If you have a tachometer in car. then as it starts to warm up the idle should start to go down. Then listen for a hiss around the center of engine compartment. the black tube and ribs looking thing is your intake where vacuum ports would start. Check line or hoses to see if cracked or broken. Ford/Mercury like to use hard plastic for lines and become brittle after a while and break.

Dec 19, 2010 | Mercury Sable Cars & Trucks

1 Answer

Where is the coolant thermostat on a 2006 mercury milan.


WELL YOU DID NOT GIVE ENG SIZE BUT THE ARE AT THE TOP OF ENG FOLLOW UPER RAD HOSE AND IT SHOUL LEAD YOU TO THE THERMOSAT HOUSING HOPE THIS HELPS

Mar 16, 2010 | 2006 Mercury Milan

1 Answer

98 Lincoln Navigator Check Eng light on


fuel pump is going out causing the truck to run lean and miss

Aug 22, 2009 | 1999 Lincoln Navigator

1 Answer

High/rough idle on Ford Expedition


i will check idle speed sensor, most likely this is the problem, and the fuel consumption problem can be related to O2 sensor which makes the car idle very badly, so i suggest you check both
thank you
good luck

Aug 17, 2009 | 2001 Ford Expedition

1 Answer

Engine runs rough after about ten minutes /idles really low


Just trowing some suggestions out there, but, I would check the idle air control valve (solenoid) or the throttle position sensor. If they check out then my last guess would be the map sensor or the vaccuum to the map sensor. Hope I was able to help. Best wishes.

Jan 16, 2009 | 1991 Plymouth Laser

2 Answers

Check engine light


Good Day,

The check engine light is part of the car's OBD(On-Board Diagnostic) system. The check engine light is turned on when a sensor becomes faulty or gets a false reading. Typically the check engine light will come on and stay on until the sensor that caused the fault is replaced. In your case you say it comes on while driving, so I am assuming when you first start the car the light is off. This would inicate that the faulty sensor is operational until it is heated up, then it is giving a fault. Have you noticed any thing strange while the light is on? As in lower gas mileage, running rough, running fast, low idle, high idle, overheating, anything at all that could help indicate what the cause maybe. Does the check engine light stay on until you park the car? If so you can have the "code" read from the OBD to pinpoint hte exact problem.


Hope this helps for now

Jul 07, 2008 | 1992 Mercury Grand Marquis

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

58 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mercury Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

fordexpert

Level 3 Expert

5530 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Are you a Mercury Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...