Question about 2010 GMC Yukon XL

1 Answer

2001 gmc yukon engine revs up at 20 mph changed trans filter (screen) still have same problem

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • GMC Master
  • 5,313 Answers

If you mean it "flares" trans may have major issues. If you mean it fails to shift to next gear, likely bad shift solenoid, easily changed by dropping trans pan.

Posted on Jan 24, 2015

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: 2001 GMC Yukon SLT 5.3L V8 - whirring sound after engine is off

that is most likely your abs control module locate your 60 amp abs fuse under the hood and remove it if the noise stops you need to replace your control module

Posted on Dec 16, 2008

  • 409 Answers

SOURCE: wanting to know how to change knock sensor on 2001

Knock sensor is located on side of engine block screwed into a block coolant drain, your best access is from underneath the vehicle. Coolant will run out when you unscrew it so be sure the engine is cool. Just unplug the wire unscrew the sensor, screw in the new one and plug the wire back in. Also be sure to top off the radiator if you loose any coolant.

Posted on Mar 11, 2010

SOURCE: i have an engine code PO332 knock sensor 2 circuit

The most likely cause of your code is a bad rear knock sensor. You should check the knock sensor wiring harness for corrosion. But if that checks out the sensor will have to be replaced. The knock sensor is under the intake manifold, although it's not too difficult to remove. Both knock sensors should be replaced along with the wiring harness, just because of labor involved in gaining access to the sensors. You could try clearing the code, it may stay off for a long time.

Posted on May 23, 2010

  • 8 Answers

SOURCE: Where and how do you change the cabin air filter

I'm not sure but i think 03 and later yukons dont have them, I have an 05 yukon and pulled the cover off only to find solid plasic and nothing else to remove, certainly no clips to undue to remove anything. I looked and looked for about an hour. After some research on the net, it looks like there isn't one. strange they sell the part for my year. Either that or im looking in the wrong place.

Posted on Jun 30, 2010

  • 27 Answers

SOURCE: problems with acceleration - 2001 Yukon

Most likely it is due t5o dirty fuel injectors or bad mass air flow sensor

Posted on Jul 23, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 GMC Yukon 5.3l 4WD SUV is having (2) transmission problems. 1.) When cold, it shifts HARD from 1st into 2nd but after the 1st time while the engine is warm, it shifts smoothly. It started doing...


Does the trany fluid smell burnt? Might want to have the trany flushed - torque converter too - and replace the filter in the trans. FYI you may know this but it is not recomended that overdrive be enabled when pulling a trailer - especially a heavily loaded one. Does your town have lots of hills - this is an added stain on the trany.

Nov 18, 2010 | 2001 GMC Yukon XL

1 Answer

1998 Yukon high idle sound with bad gas mileage.


What you have is the torque converter clutch,cycling on and off.
When it is off.your rpm will go up and your milage will go down
First-check to see if your brake switch, on the back of the brake peddle, is loose or misadjusted. When you apply the brakes,the first thing to happen, is that you unlock the converter,so your trans is not connected directly to the motor,or you would stall. Then below 42 MPH,your trans is working off the converter, as a pressure multiplier ,based on rpm
Second- switch okey. You remove trans pan and change TCC Solenoid.

Let me know if if you need more guidance

May 08, 2010 | 1998 GMC Yukon

1 Answer

Why wont my 2001 gmc sierra 2500hd go into 4th gear?


There is a speed/shift sensor you could change, but if you haven't changed the fuel filter in a while, i'd go there first. Sometimes, in fact, often, plugged fuel filters can cause the engine to starve for fuel, and make it seem like the transmission is the problem.

Jul 25, 2009 | 2000 Hyundai Elantra

1 Answer

My GMC yukon XL 2001 engine runs after 4 times of cranking.


Try turning key to on only, not start, 2 or 3 times first then try to start. If it starts good first try, then I'd change my fuel filter & then have fuel pressure tested if fuel filter didn't help. You may be looking at a new pump, but lets do filter & test fuel pressure first.

Jul 06, 2009 | 2001 GMC Yukon XL

1 Answer

Loss of power, transmission not shifting


That orange signal is telling you that your air filter is almost clogged up and the engine is not getting enough air to run porperly. By all means change your air filter. Depending on dust conditions that you drive in, this should be changed every 18 months or so.

Aug 07, 2008 | 2001 GMC Yukon XL

1 Answer

I own a 1997 GMC Yukon 5.7 liter 4 wheel drive. This problem only happens in the summer when outside temp is above 60. Truck shifts very hard at 10 mph once it has been driven for at least a half hour. If...


The electrical harness between the steering column in these gmc units are troublesome. I just paid $500 (part $300) to have mine changed out on my 97 gmc yukon, but for 335,000 kilometers, no leaks, no oil consumption, not bad

Jul 24, 2008 | 1997 GMC Yukon

Not finding what you are looking for?
2010 GMC Yukon XL Logo

Related Topics:

71 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...