Question about 2006 Jeep Grand Cherokee
Location of PCV Valve
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
You have 2 posibilities.there are 2 motors on the heater box that run the blend doors for each side.That side motor may be bad or worst case the blend door arm that connects to the motor is broken.If it is broken the whole dash has to be removed so the heater box can be taken out to replace the blend doors.Big job,do a heater core while your there if you fix it so you dont have to do it again.
Posted on Mar 09, 2009
If you have the owner's manual look up fuses in the index, good illustration. If you don't, I do. It shows a relay and a 15 amp fuse. Look at the passenger kick panel, pull the cover, and it is #2 fuse (second from the top on the left) The see the relay you may have to pull the panel (two screws and a clip) the relay is the third cavity down, third row from the firewal side.
Let me know if this works for you?
Posted on Apr 03, 2009
The idle air control valve is located on the back of the throttle body. It has an oval electrical connector and two torx screws holding it in. Unplug the connector, remove the two screws then lightly tap the body with a soft faced mallet to loosen it from the body.
Once you have it out and prior to installing a new valve clean the seat inside the throttle body where the idle control fits. This must be very clean! Installation is in the reverse order.
To save some cash, pull the valve out and clean it with throttle body cleaner, this usually fixes the problem for quite a while.
Good luck and hope this helps.
Posted on May 28, 2009
left rear of engine block,on transmission bell housing.best way from top under brake booster use a wrench,
Posted on Jun 13, 2009
remove the 7mm bolt in the centre top of lamp unit then with a big screwdriver just behind headlamp prise outwards quite firmly
Posted on Jul 03, 2009
Tips for a great answer:
May 15, 2017 | Cars & Trucks
Feb 07, 2013 | 2009 Jeep Grand Cherokee
Nov 14, 2012 | 1994 Jeep Grand Cherokee
Dec 29, 2010 | 2006 Jeep Grand Cherokee
Nov 10, 2010 | 2004 Jeep Grand Cherokee
May 20, 2010 | 2006 Jeep Grand Cherokee
Apr 08, 2010 | 2006 Jeep Grand Cherokee
Jun 17, 2009 | 1999 Jeep Grand Cherokee
May 30, 2009 | 2002 Isuzu Axiom
12 people viewed this question
Usually answered in minutes!