Question about Hyundai Tucson

Open Question

Looking for ETACS location 2005 Hyundai Tucson

Trying to re-program a new remote and was instructions indicated a switch on the ETACS unit but can not locate it

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 566 Answers

SOURCE: Where is the location of the rear window washer

hi the pump for r/washer is at the lower end of w/sreen fluid bottle accessable from under neath it will be either a pump solely for rear wash and another pump for front wash? or it may be a combined dual pump for both which will have seperate supply pipes for front and rear use rear select ion to dtermin whether pump is operating or not then come back to board with update ? for advice on problem with rear wash in-op ?

Posted on Mar 08, 2009

ghost45
  • 1280 Answers

SOURCE: Where is the ETACS unit on my 2007 Santa Fe?

Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Posted on Oct 03, 2009

  • 15 Answers

SOURCE: I'm putting a new radio in a Hyundai 2005 Tucson

the original radio /cd should just remove with the 2 prong loops and the wiring is standard for most replacement cd/tuners {you may need a wiring loop to fit you new radio/cd available from most motor factors inc halfords
STRAKER1999

Posted on Dec 05, 2010

ghost45
  • 1280 Answers

SOURCE: where is backup light switch located on 2006

You didn't say if this vehicle was Automatic Transaxle or Manual Transaxle. No need

here are two photos: One is Manual, the other is Automatic. The manual trans has a separate switch (all by itself), however, the automatic (of both the 4 cylinder and 6 cylinder) use the trans range switch to provide power to the back up lamps

ghost45_6.jpg


ghost45_7.jpg


Hope this helps

Posted on Feb 16, 2011

  • 1 Answer

SOURCE: Hello. Where is that ETACS

I live in Australia so mine is a right-hand-drive Santa Fe 2001. I wonder if this is why so many people seem to have so much trouble locating this box. On a left-hand-drive the box may be more over the footwell instead of near the side wall. In my car it is actually behind the fuse box near the right-hand side-wall. The switch is actually not visible as it is located on the right hand side of the ETACS box (near the side-wall). I had to locate it by feel. Once thought I had located the switch I held my finger pressed up against it for a while, to litterally get an imprint of the switch. The position towards the driver appears to be the "off" position, and the position towards the front of the car the "set" position. I turned the ignition key on (2 clicks), flicked the switch to the "set" position, pressed the lock button (I watched the flash on the remote, but heard nothing from the car), turned the ignition key to "off" and pressed the remote lock button again, then reset the switch on the ETACS box back to it's original position. That's it. My remote is working now. Hope this helps someone else...

Posted on May 14, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 hyundia tucson


Search Results

    2005 Hyundai Tucson Recalls - Cars.com

    www.cars.com/recalls/hyundai/tucson/2005/

    Cars.comLook up all NHTSA vehicle safety recalls for your 2005 Hyundai Tucson, and contact a nearby service center for free repairs.

    2005 Hyundai Tucson Problems, Defects & Complaints

    www.carcomplaints.com/Hyundai/Tucson/2005/
    7 days ago - The 2005 Hyundai Tucson has 199 problems & defects reported by ...January 11: Hyundai Genesis Recalled to Replace Dangerous Tires ...

    Hyundai Tucson Recalls ' RepairPal

    repairpal.com > Recalls > Hyundai
    Other systems that may be affected include: cruise control, push-button start, gear shifter, and Electronic Stability Control (ESC) system. Dealers will replace the brake light switch to correct this concern. ... The stop lamp switch may fail, affecting many vehicle systems including ...

    2005 Hyundai Tucson Recall - Learn About Recalls for 2005 ...

    www.automd.com > Recalls and TSBs > Hyundai Recall > Tucson

Jan 28, 2016 | Cars & Trucks

1 Answer

Hello. Where is that ETACS box located under the dash on a 2001 hyundai santa fe? I have the fuse box panel off but cannot find the etacs box to sitch to off for remote programming.


I live in Australia so mine is a right-hand-drive Santa Fe 2001. I wonder if this is why so many people seem to have so much trouble locating this box. On a left-hand-drive the box may be more over the footwell instead of near the side wall. In my car it is actually behind the fuse box near the right-hand side-wall. The switch is actually not visible as it is located on the right hand side of the ETACS box (near the side-wall). I had to locate it by feel. Once thought I had located the switch I held my finger pressed up against it for a while, to litterally get an imprint of the switch. The position towards the driver appears to be the "off" position, and the position towards the front of the car the "set" position. I turned the ignition key on (2 clicks), flicked the switch to the "set" position, pressed the lock button (I watched the flash on the remote, but heard nothing from the car), turned the ignition key to "off" and pressed the remote lock button again, then reset the switch on the ETACS box back to it's original position. That's it. My remote is working now. Hope this helps someone else...

Jan 30, 2011 | 2001 Hyundai Santa Fe

1 Answer

Tryin to locate the keyless entry reciever and the Set/Off button


The ETACS unit, which controls the alarm, is bolted to the dash chassis and is located immediately behind the climate control cluster. You need to gain access to this unit to code a new remote. Technically, you are not coding the remote; what you are doing is re-programming the ETACS module to remember and accept the secret code transmitted by the remote. The ETACS unit is designed to remember and accept up to two remote codes. If you wish to add a third remote, the dealer must program the third remote to utilize the same code from one of the other two remotes (called code-saving). There is no way to do this yourself.

The Project

1) Remove the dash facia using the "Easy Dashboard Removal" DYI posted
here by member kmr327.

2) Remove the four screws securing the climate control cluster, pull it forward, and remove the wiring harness.

3) Using a flashlight, (and cramming your head), find the sticker that marks the location of the set switch on the ETACS unit. It is on the right side of the ETACS unit, below the antenna input (the antenna can be unplugged -- it utilizes the same type connecter as the AM/FM antenna). Note the positions on the sticker for "Off" and "Set". By default, the switch is in the "Off" position, which is the normal functioning position. Next to the sticker is a small piece of tape covering the recessed slider switch, which you can not actually see. Remove the tape with a razor blade or by picking at it with your fingernail.

4) Once the tape is removed, use a jeweler's screwdriver or other similar small tool to flip the switch into the "Set" position. (Note: if you unplugged the antenna from the ETACS unit, the antenna must be plugged into the ETACS unit at this point and the car's battery must be connected). You are now ready to code the remote. NOTE: When you code the new remote, you must re-code your old one at the same time or the old one will no longer work. To code the remote, press either the lock OR the unlock button of the remote once. Do the same thing for the second remote. Try to do the second remote within two seconds of the first one. Slide the switch back to the "Off" position. Verify that both remotes function. If they do not, set the switch to the "Set" position again and repeat the procedure. If you continually run into problems, try coding only one remote. I have heard on some of the forums that the second remote has to be pressed within a second of the first and that it may take several attempts to be successful. I did not encounter this problem.

5) Reassemble the dash facia.

Hope this information is useful!

Apr 24, 2010 | 2001 Hyundai Elantra

1 Answer

Where is the ETACS unit on my 2007 Santa Fe?


Go to www.hmaservice.com and register( Vehicle by VIN). Afterward, you have access to shop manuals, service bulletins, wiring diagrams, etc. about your vehicle.

Sep 28, 2009 | 2004 Hyundai Santa Fe

1 Answer

Hyundai sonata 2002 remote


There is a special (proprietary) programming electronics 'black box' for the keyless entry system on all Hyundai vehicles for programming the remotes. This programming is stored in either the BCM (body control module) or the ETACS module (Electronic Time and Control System).

May 22, 2009 | Hyundai Motor 2002 Sonata

2 Answers

Program factory remote keyless entry: 2003 Hyundai XG350


The procedures you list require the Hyundai Keyless Remote programming module, which you don't have. This module is proprietary - only Hyundai Dealerships have it. There is a 10 pin connector under the dash (next to the DLC - Data Link Connector) which is used to connect the Keyless Remote Programming Module. This module has two switch positions "Ready" and "SAVE". When the switch is place in the 'SAVE" position, that's when the keyless remotes are activated to send their 'codes' to the Electronic Time and Control System (ETACS). The module's switch is then set to "Ready" and the remote is tested to see if it works properly.

May 22, 2009 | Hyundai Motor 2003 XG350

1 Answer

Programming factory remote on 2003 Hyundai XG350


Again, the remotes can only be programmed by a Hyundai Technician (ETACS - Electronis Time and Alarm Control System).

May 22, 2009 | Hyundai Motor 2003 XG350

1 Answer

How to program keyless remote


I just had to buy one too and these are the instructions I was given by the guy I bought it from. I haven't tried them yet. Hopefully they work for us both :).

1.Find the ETACS unit under the steering wheel first,there is a small switch onit.
2.Once the switch is located make sure your key is not in the ignition and set the switch from off to set.
3.Press keyfobs door lock button for one second, this sends the codes to the ETACS and stores it.
4.Do the same thing if you have 2 remotes for the vehile.
5.Now set the ETACS switch from set to off.
6.Remotes should now be programed.

Jan 10, 2009 | 2007 Hyundai Santa Fe Limited

1 Answer

Had to buy keyless entry remote.2007 santa fe limited. What is procedure for programming


I just bought one for mine too! The guy who sold it to me gave me these directions but I haven't tried them yet! Am going to on my lunch hour! Hope they work for us both :)

Forgot to put prog. instructions.in with your fob so here they are.
1.Find the ETACS unit under the steering wheel first,there is a small switch onit.
2.Once the switch is located make sure your key is not in the ignition and set the switch from off to set.
3.Press keyfobs door lock button for one second, this sends the codes to the ETACS and stores it.
4.Do the same thing if you have 2 remotes for the vehile.
5.Now set the ETACS switch from set to off.
6.Remotes should now be programed.

Jan 10, 2009 | 2007 Hyundai Santa Fe Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

502 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...