Question about 1997 Chevrolet Blazer

Open Question

Key On Engine Off / Cranking Bulb

Failed emissions due to Key On Engine Off / Cranking Bulb. Possible fixes?

Posted by Anonymous on

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1201 Answers

SOURCE: failed emission test because check engine light wont come on

You have to pull the front of the dashboard off, and take out the instrument cluster to get at it. If there ia an autozone near you, have them put a code scanner on the car, that will tell what is wrong.They don't charge anything to do it, and takes about 30 seconds.

Posted on Mar 11, 2009

  • 5 Answers

SOURCE: Check engine light wont come on 2003 Blazer

may be a blown light bulb

Posted on Jul 28, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2001 dodge intrepid failed emissions says due o excessive of readiness monitors 'Not Ready'


you must not clear codes or unhook battery after doing what they call a drive cycle which resets monitors to a ready state. http://www.lhforums.net/forums/showthread.php?2755-OBD-II-and-your-Next-State-Inspection
press helpful button

Dec 18, 2015 | 2001 Dodge Intrepid

1 Answer

Failed Emmission test


So you are saying the bulb for the check engine light is burned out and needs to be replaced ??
And the trouble codes you listed are for lean fuel mixture which could point to a vac leak or low fuel pressure.

Jan 14, 2013 | 1999 Ford Explorer

1 Answer

Ok the Guy.that ran the emissions test it don't


Check the help link
----



Vehicle smog test failed Due to NO MIL/check engine light?
http://schematicsdiagram.blogspot.com/2011/12/vehicle-smog-test-failed-due-to-no.html

----------

Dec 22, 2012 | Cars & Trucks

1 Answer

Check engine light was changed now doesnt go on at all


When you turn the key to the "on" position (engine not running), does it come on??? if not, replace bulb again...or test the light socket for electrical signal...

Jul 30, 2012 | 1997 GMC Sierra

3 Answers

They change an sensor on my 2003 suburban 1500 and this fixed the check engine light status. However they must of done something or not hooked something back up, since now the check engine light does not...


When you turn the key 'on' the Check Engine Light is supposed to illuminate-that is also a check for the system-they probably removed the CEL bulb or the fuse for it-not good, and easy enough to verify-if so I would register a complaint to any state agency that regulates auto repair or emission stations. A disabled CEL will not in and of itself cause a failure in most states,but a code will-You will need to have the car scanned to see what the code is, and then come back on here with the actual code for help.

May 23, 2011 | 2003 Chevrolet Suburban 1500

1 Answer

I just had my emission test done and it failed for the service engine soon light not turning on. What could the problem be and how can i fix it?


it is supposed to turn on when you turn on the key so you can verify the bulb is ok. If it is not turning on, the most common cause is just a bad bulb. easy to replace, just pull the 2 screws above the gauges, pull off the fascia and then pull the 4 T-15 torx screws that hold in the gauge cluster, the bulbs come out from the back. if this does not fix it, the next most likely cause is the ignition switch, it may not be energizing the "bulb check" wire.

May 19, 2010 | 2000 GMC Jimmy

1 Answer

86 gmc saburban failed emissions


there isn't much a person can do at home when it comes to repairing a emissions failue there are HC failures where there is unburned fuel
There is CO which is incomplete combustion poosr compression, valve problems ect.
NOX Oxsides of nitrogen which is usually over heating engine or EGR
O2 (oxygen) leak in the exhaust
Oh yea evap emissions where the fuel vapors escape into the atmosphere through a .020" hole in the fuel vapor recovery system somwhere between the fuel ank and the engine compartment Oh god you need a smoke machine to find those.
Oh god I repair emission and its so damn hard fix one thing and another reading goes wackey
There is NO WAY without a 5 gas analyzer you can hit it Please trust me I know money is tight but take it to an emissions qualified shop and be done with it cheaper and less hassle, sorry just being honest really.Here in Seattle you will find nearly no old vehicles like yours due to emissions they cant be made to pass so off to the wrecking yard they go thats the goal of the emissions program get rid of the GROSS POLLUTERS and make people buy new cars. Thats our wonderful Goverment.
But in Japan you have to my law change our engine at 40,000 mi due to their emissions laws or junk the car.
give me your phone Number and I'll call you or heres my number 253-691-6206 and try to explain it
But if I provided any helpful advice please give me a good rating

www.aceautomotive1.com

Aug 17, 2008 | 1986 GMC C1500

Not finding what you are looking for?
1997 Chevrolet Blazer Logo

Related Topics:

27 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7697 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...