Question about Hyundai Santa Fe

Open Question

Removing rear window defogger switch - Santa Fe Hyundai Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 2039 Answers

SOURCE: 2003 olds alero rear windoe defogger

the rear passager panel the one that cover the side rear window there a relay connector in there that were the power to window go that defectif that gonna FIXYA our post thank you pierre

Posted on Jul 06, 2008

adam_atkins
  • 14 Answers

SOURCE: Rear window defogger not working

make sure the wire connecting to the rear defogger is clean and connected properly

Posted on Dec 11, 2008

Tech jk
  • 102 Answers

SOURCE: 2002 Alero defogger

A common thing to fial on these- assumning the grid is ok, and wires are still attched to grid, is the rear def / antenna module. It is behind rt. rear quarter trim panel. The modules burn up, and also melt the connector. the module and connector would need to be replaced.

Posted on Jan 04, 2009

emissionwiz
  • 75814 Answers

SOURCE: Where is the fuse for the rear window defogger?

The rear defogger is fuse #14 (40 Amp fuse) in the underhood fuse box,no other fuses, I have the owners manual. If the fuse checks good test the heater grid of the rear defogger, it is most likely is an open circuit, it can be repaired by the dealer or u..

Posted on Jan 16, 2009

  • 1 Answer

SOURCE: Radio cuts out when rear window defogger is turned on(05' Altima)

I have the same problem in my 2003 Altima. I had a friend who works on cars check it out. I watched him and when he removed the panel under the steering wheel next to the driver's door you could hear a clicking noise. He said is sounds like my defogger relay/switch is bad. I located the part and it is not that expensive. I am going to purchase the part and have it put on. I will keep you posted to let you know if it solves my problem. If it does I will give you the name of the part so you can hopefully solve your issue.

Posted on Mar 23, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Which fuse box on the 2011 Chevy Malibu is the fuse for the rear defrost


Fuse box rear , fuse #23 30 amp ! Do you know where this is located ? There is also a relay for the Rear window defogger , located in the same rear fuse box .
Fuse Block - Rear
Left side of the luggage compartment, behind the left rear wheel well . But you really need to know how it works , you can check fuse an relay .
Rear Window Defogger Operation
Battery positive voltage is supplied through the BATT 1 fuse in the underhood fuse block to the rear defog relay switched input. When the rear defog switch button is pressed, the body control module (BCM) energizes the rear defog relay by providing a B+ to the control circuit of the rear defog relay. This allows battery positive voltage from the relay switched input through the switch contacts and out the relay switched output to the rear window defogger grid. The HVAC control module houses the rear defog switch and also illuminates the rear defog indicator on the switch button, upon this request. Ground for the rear window defogger grid is provided by G301 for the Sedan or G302 For the Extended Sedan.

Nov 23, 2016 | 2011 Chevrolet Malibu

1 Answer

Wiring diagram for rear window defogger 2005 silverado from dash to deffoger


Rear Window Defogger System Components
The rear window defogger system consist of the following components:
• HVAC control module
• Body control module (BCM)
• DEFOG relay
• Rear window defogger grid
Rear Window Defogger Operation
When you turn the ignition to the ON position, ignition voltage is supplied to the DEFOG relay coil. Battery positive voltage is supplied at all times to the DEFOG relay switched input. When the rear window defogger switch is depressed, the HVAC control module illuminates the rear window defogger indicator and sends a class 2 message to the BCM. The BCM energizes the DEFOG relay by grounding the control circuit of the relay. This allows battery positive voltage from the relay switched input through the switch contacts and out the relay switched output to the rear window defogger. Ground for the rear window defogger is provided by G306 or G390 (crew cab).
When you turn ON the ignition and press the rear window defogger switch for the first time, the defogger cycle lasts 10 minutes. Further operation results in 5 minute defogger cycles.

Do you know what your messing with ? What's the problem ?

Oct 30, 2016 | Cars & Trucks

2 Answers

Why is my rear defrost not working


Switch, fuse or maybe the wiring to the window has come loose or off, happens alot, kits are available at local auto parts stores...
I hope that helps...

Mar 02, 2015 | 2008 Chevrolet Malibu

1 Answer

Remove


Original equipment rear auto glass is not designed to have the "heating element" removed...these lines are imbedded into the glass during production. If your current rear defogger is not working, you have a few options. You can replace the entire rear glass (very costly), you can add a new aftermarket defogger strip and connect to original equipment wiring...(maybe to many lines for your viewing...or you can add a rear blower motor vent to the rear shelf...(most effective, aftermarket kits are vailable, probably your best choice to address a need for a rear window defogger. Hope this helps.

May 02, 2013 | Cars & Trucks

2 Answers

How do you turn on the defogger? Cant' find the button/switch. Owner manual has no info


Does the rear window have lines in it? If it doesn't the it is NOT equipped with a rear window defogger

Feb 01, 2011 | 2009 Saturn VUE

1 Answer

My 2004 6cfl. Trailblazer rear window defroster is not working. The wires appear to be making a good contact. The outside mirrors defrost ok using the same switch as the test window defroster. Is there...


There is a module that controls the rear window defogger grid . LGM/ EGM Liftgate or endgate module .Receive's message on class 2 serial data network from the HVAC control module to turn it on when button pressed . Fuse # 3 30 amp located in the rear fuse box . Do you know where the rear fuse box is ?
Rear Window Defogger Description and Operation
Rear Window Defogger System Components
The rear window defogger system consist of the following components:
• HVAC control module
• Liftgate module (LGM)/endgate module (EGM)
• Rear window defogger grid
Rear Window Defogger Operation (With LGM)
Battery positive voltage is supplied through the LGM 2 fuse to the LGM for the rear window defogger system. When the rear window defogger switch is depressed, the HVAC control module illuminates the rear window defogger indicator, and sends a class 2 message to the LGM to enable the rear window defogger. The LGM enables the rear window defogger by allowing battery positive voltage to the rear window defogger.
When the rear window defogger switch is pressed for the first time, the defogger cycle lasts 10 minutes. Further operation results in 10 minute defogger cycles.
Rear Window Defogger Operation (With EGM)
Battery positive voltage is supplied through the EGM 2 fuse to the EGM for the rear window defogger system. When the rear window defogger switch is depressed, the HVAC control module illuminates the rear window defogger indicator, and sends a class 2 message to the EGM to enable the rear window defogger. The EGM enables the rear window defogger by allowing battery positive voltage to the rear window defogger.
The following conditions must be met for rear window defogger to operate:
• The end gate glass position is not below the index position.
• The window express down movement is not requested.
• The window down movement is not requested.
If the end-gate glass is not fully closed, the DIC displays "Tailgate Glass Down" when the rear defogger operation is attempted.
When the rear window defogger switch is pressed for the first time, the defogger cycle lasts 10 minutes. Further operation results in 10 minute defogger cycles.

Fuse Block - Rear
Beneath the left rear seat

Jul 13, 2017 | Chevrolet TrailBlazer Cars & Trucks

1 Answer

1998 buick park ave. rear window defroster not working. fuse is good, has anyone replaced the black box located next to rear window where element plugs into along with the antenna. element on window is not...


Rear Defogger Inoperative, But Heated Mirrors Operate Correctly
1. Connect scan tool. Turn ignition switch to RUN position. Turn rear defogger on. Using scan tool, display BCM
outputs. If rear defogger is being requested on, go to next step. If rear defogger is not being requested on, go to
step 10).
2. Ensure ignition switch is in RUN position. Remove rear defogger relay from rear junction block, located on center
right rear of passenger compartment, under rear seat. Connect test light between ground and defogger relay
harness connector terminal F3 (Brown wire). If test light illuminates, go to next step. If test light does not
illuminate, go to step 11).
3. Connect test light between ground and defogger relay harness connector terminal A2 (Red wire). If test light
illuminates, go to next step. If test light does not illuminate, go to step 12).
4. Connect test light between defogger relay harness connector terminals A2 (Red wire) and B3 (Purple wire). If test
light illuminates, go to step 13). If light does not illuminate, go to next step.
5. Disconnect rear defogger positive and negative feed bus connectors. Connect a jumper wire between defogger
relay harness connector terminals F3 (Brown wire) and A4 (White wire). Connect test light between ground and
positive feed bus connector terminal "A" (Black wire). If test light illuminates, go to next step. If test light does not
illuminate, go to step 8).
6. Connect test light between positive feed bus connector terminal "A" (Black wire) and negative feed bus connector
terminal "B" (Black wire). If test light illuminates, go to next step. If test light does not illuminate, go to step 9).
7. Repair open in Black wire between rear defogger and ground. Recheck system operation.
8. Repair open in Purple wire between rear junction block and heated backlight antenna module. Recheck system
operation.
9. Check for proper terminal contact at rear defogger connectors. Repair as necessary. Recheck system operation.
10. Check for proper terminal contact at BCM. If terminal contact is okay, replace BCM. Recheck system operation.
11. Repair open in Brown wire between rear junction block and instrument panel junction block. Recheck system
operation.
12. Repair open in Red wire between rear junction block and underhood junction block (located in right front corner of
engine compartment, between battery and strut tower). Recheck system operation.
13. Connect test light between defogger relay harness connector terminals F3 (Brown wire) and A4 (White wire). If
test light illuminates, go to next step. If test light does not illuminate, go to step 16).
14. Reinstall defogger relay. Disconnect BCM 32-pin Pink connector C2. BCM is located behind right side of instrument
panel, near rear of glove box. Using DVOM, check voltage between ground and BCM harness connector C2
terminal A3 (White wire). If any voltage is present, go to next step. If no voltage is present, go to step 17).
15. Repair open or short to ground in White wire between rear junction block and BCM. Recheck system operation.
16. Check for poor connection at defogger relay terminals. If connections are okay, replace defogger relay. Recheck
system operation.
17. Check for proper terminal contact at BCM. If terminal contact is okay, replace BCM. Recheck system operation.

Feb 25, 2010 | 1998 Buick Park Avenue

6 Answers

Hyundai XG350 rear defogger doesn't work. I have changed the relays, checked all the fuses all good, dash switch works because I changed that too. checked the wire to the grid thats' ok too. now what?


The rear defogger is controlled by the Electronic Time and Alarm Control Module (ETACM). It receives a signal from the switch, and if the car is running, turns on the rear window defogger. Most frequently the problem is a blown 30A defogger fuse. Other common problems are the defogger switch itself or the switch not being plugged in properly, but there can also be a bad defogger relay, defective ETACM, or wiring issue. If you're capable of doing some electrical diagnosis, I'd encourage you to register for a free account at www.hmaservice.com (requires Internet Explorer and Adobe SVG Viewer) and print the schematic from the site. Also, does the indicator lamp come on when you depress the defogger button,I hope this help you in the right direction now you know how it works

Feb 12, 2010 | Hyundai XG350 Cars & Trucks

1 Answer

Rear window defogger dont work replaced relay & fuse still dont work


REAR WINDOW DEFOGGER SWITCH IS BAD OR YOUR REAR WINDOW HAS A BROKEN PLACE IN THE GRID.

Nov 01, 2009 | 1999 Oldsmobile Alero

1 Answer

Rear window defogger not working


make sure the wire connecting to the rear defogger is clean and connected properly

Dec 11, 2008 | 1993 Buick LeSabre

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...