Question about 2004 Hyundai XG350

Open Question

How do I program my 2004 Hyundai XG350L garage door remote

Posted by Anonymous on

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

c17hydro
  • 2984 Answers

SOURCE: I need 2004 Hyundai XG350L Service/repair Manual

3.5L Engine

Remove or disconnect the following:

  1. Negative battery cable
  • Engine coolant
  • Water pump pulley bolts
  • Alternator bolt, loosen only
  • Water pump pulley and drive belts
  • Crankshaft pulley
  • Timing belt cover(s)
  1. Turn the crankshaft until the timing marks on the camshaft sprocket and cylinder head are aligned.
  2. Loosen the timing belt tensioner bolt and turn the tensioner counterclockwise as far as it will go. Tighten the adjusting bolt.
  3. Mark the timing belt with an arrow showing direction of rotation.
  4. Remove the timing belt.
  5. If defective, remove the timing belt tensioner.

9767b45.gif
Timing belt sprocket alignment mark positioning for belt removal and installation—3.5L engine

To install:
  1. If necessary, install the timing belt tensioner.
  2. Attach the top of the tensioner spring on the engine coolant pump pin. Ensure the hook on the pin is facing down and the hook on the tensioner is facing away from the engine
  3. Rotate the timing belt tensioner to the extreme counterclockwise position. Temporarily lock the tensioner in place.
  4. Align the timing marks of the camshaft and crankshaft sprockets.
  5. Install the timing belt on the crankshaft sprocket, then onto the rear camshaft sprocket.
  6. Route the belt to the coolant pump pulley, the front camshaft sprocket and the timing belt tensioner.
  7. Apply force counterclockwise to the rear camshaft sprocket with tension on the tight side of the belt and check that timing marks are aligned.
  8. Loosen the tensioner bolt 1–2 turns and tighten the timing belt to a tension of 57–84 lbs. (260–380 N).
  9. Turn the crankshaft two turns clockwise.
  10. Readjust the sprocket timing marks and tighten the tensioner bolts.
  11. Install the timing belt covers.
  12. Install the crankshaft pulley and tighten to 108–116 ft. lbs. (150–160 Nm).
  13. Install or connect the following:
    • Timing belt cover(s)
    • Crankshaft pulley
    • A/C compressor belt
    • Water pump pulley
    • V belt
    • Negative battery cable
    • Engine with coolant

Posted on Feb 10, 2010

cris_p
  • 62 Answers

SOURCE: cannot open fuel door with, driver side door remote actuator.

the fuse is probably bad

Posted on Feb 19, 2010

  • 510 Answers

SOURCE: how to program 2004 Hyundai Santa Fe Keyless Entry

Synchronization
When
System malfunction. Remote control added or replaced.
How
Access alarm system control module located under driver's side lower fascia Fig. 2 . Set memory switch to SET position. Press remote control lock or unlock button. Set memory switch to OFF position. Confirm synchronization has been successful by locking and unlocking vehicle. Repeat procedure for second remote control. Synchronization can also be carried out using diagnostic equipment.
NOTE: A maximum of 2 remote controls can be programmed. NOTE: If remote control fails, system can be deactivated as detailed in the owner's handbook.

Posted on Mar 23, 2010

swolfinor
  • 504 Answers

SOURCE: Can't program hyundai sonata to open garage door

GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.



HOPE THIS HELPS

Posted on May 26, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do I enable the factory alarm on my 2002 Hyundai XG350L?


did you try to cycle the key in the drivers door?

May 08, 2015 | 2002 Hyundai XG350 L

1 Answer

Sinc garage door opener with a 2009 Hyundai Sonata


Take your remote and hold it up towards your rear view mirror or your visor whitchever is the one with 3 buttons of your homelink , also make shure that your opener has a program button which come in different colors depending on the year of the machine, if you have a program button on your powerhead of your garage door opener then you can mostlikely program your car to it! The button on garage door opener comes in different colors such as yellow,green ,orange, black, grey and black ! make shure your opener has one of these buttons! Now take your remote and point it within a few inches of your visor/rearview mirror and hold the button down that oppens that door....now press the first button on your car mirror/visor until the door opens up , it take sometimes a few trys but remember to leave your car running while doing this and have it outside the front of your garage door while doing this!

Dec 03, 2013 | 2009 Hyundai Sonata

1 Answer

Disable alarm without remote on hyundai 2003 XG350L


You must have a spare key. When your alarm is going off have your key in the ignition, wait it out. When your alarm stops in approximately 30 seconds keep the key in the ignition exit the vehicle and lock the doors (don't forget your spare key). Go to the passenger door with the spare key and unlock the doors and turn the key that you left in the ignition and it should start right up. Just worked for me.

Apr 01, 2012 | Hyundai Motor 2003 XG350

1 Answer

Bought my Hyundai 2004 XG350L with 10,000 dealer demo miles on it and did normal maintenance on it the last 5 years. It has only 56,000 now and I turned the engine on this morning and engine light wouln't...


It may just be a sensor failing, or even as simple as a loose gas cap. You need to get it scanned to see what the error is that the computer found. (Some auto parts stores will do this for free, but they don't give a lot of information. Try that, if no luck, try a good garage.)

Jun 05, 2010 | 2004 Hyundai XG350

1 Answer

Can't program hyundai sonata to open garage door


GOTO HOMELINK.COM

THEY MAKE THE SYSTEM AND HAVE INSTRUCTIONS YOU CAN DOWNLOAD.



HOPE THIS HELPS

Sep 13, 2009 | 2008 Hyundai Sonata

1 Answer

Just moved, no garage remote, need to set the opener in my SUV.


The garage door opener is needed to use the HomeLink system that is in your vehicle. This design is so that no one can program theirs to gain access to your garage. You will have to obtain a working remote and it will have to be programmed at the garage door.

Jul 13, 2009 | 2004 Nissan Maxima

1 Answer

The buttons for garage will not program in my Lexus RX 330 2004


The buttons inside the vehicle are syncronized/programmed with the operatus that physically opens and closes your garage door, not the operner... The garage door opener needs to have a "programming" feature switch that must be set to "programming" before you can program the buttons inside the car...

There are step by step instructions in your owners manual... This could be a 2 person operation...

I have a 2004 RX and had the same problem, simply because I didn't follow the instructions precisely..

Good luck...Oz

Mar 22, 2009 | 2004 Lexus RX 330

1 Answer

Having trouble setting garage door opener to my 2004 trailblazer


1. Position vehicle within 10 feet of garage door- engine off and battery on.

2. Press/hold 2 outside buttons of Homelink transceiver until red indicator starts flashing rapidly, then release button. This should take about 20 seconds. This erases any previously learned codes.

3. Press/hold remote control and press/hold button of Homelink transceiver simultaneously. Slowly move remote control from 5" away to 1" away from Homelink transceiver. Release both buttons after red indicator starts blinking rapidly. This should take about 5 seconds. I discovered that the Homelink in my TL is a bit faulty because it took much longer to accomplish this than when programming the Homelink in my MDX. My TL's Homelink may "unlearn" it's code in the future and the needed proximity of the TL to the garage door may be much closer than desired until I get the Homelink fixed.

4. Press training button on garage door opener unit until the indicator lights illuminates- this should be immediate.

5. Within 30 seconds press/hold the Homelink button for 2-3 seconds until the red indicator starts flashing rapidly. Repeat a second time. It should now be programmed. Check it by pressing the programmed button on the Homelink receiver.

6. When programming more than 1 garage door opener unit, disconnect power from unit before programming more units. By not doing this the programmed unit could conflict with the unprogrammed units commands.

Problems:

1. The Battery in the garage door remote may be too weak to program Homelink. However, the battery may be strong enough to operate the garage door. One of my remote controls had a weak battery- my system was installed today, fresh out of the box. I had to use the second remote control for the programming of Homelink on my 2 vehicles.

2. Antenna on the garage door opener unit must be hanging down, fully extended.
source:chalkstar100 (fixya mate)

Thanks for using Fixya
Have a nice day!

Mar 07, 2009 | 2004 Chevrolet TrailBlazer

1 Answer

Garage door remote


First you have to clear any codes in there.
Hold down the outer 2 buttons until the red light blinks, could take a minute or less.
Then release the buttons, hold your garage door opener close to the button you want to program.
hold down the button on the garage door opener and the programing button until you get a blink from the little red light. That's it

Oct 10, 2008 | 2004 Jeep Grand Cherokee

Not finding what you are looking for?
2004 Hyundai XG350 Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...