Question about Kia Rio

Open Question

Car wont start without pressing clutch down - Rio Kia Cars & Trucks

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

jgwhomeequip
  • 1902 Answers

SOURCE: 97 escort clutch gets stuck down and wont let me shift

Sound like the flywheel fork is either broken or bent. or that the pressure plate is bad.

Posted on Feb 05, 2009

  • 834 Answers

SOURCE: clutch wont disengage and i can push the car when

That burnt smell is what used to be your clutch disk, and you will need to replace the clutch before you will be able to drive that vehicle again. You should purchase a complete clutch kit for your vehicle, and it should come with a new pressure plate, clutch disk, throw-out/release bearing, a pilot bearing, and a clutch disk alignment tool, and be sure that the pilot bearing is replaced when that new clutch is installed.

Posted on Jun 04, 2010

  • 1565 Answers

SOURCE: my 1991 Toyota mr2 won't start. battery is fine,

check your clutch safety switch. The car will not start if the clutch in not depressed. Look under dash at the clutch pedal arm. There is a switch that looks like this:

http://www.rockauto.com/catalog/raframecatalog.php?carcode=1432921&parttype=16665&partkey=933109&a=FRc1432921k933109-1847113

It may need to be adjusted or replaced.

Posted on Jan 14, 2011

bayyagg
  • 1672 Answers

SOURCE: megane wont start when l

Hi,

Thats how it works! Modern carshave to press the clutch/brake pedal. French cars are different, u have to press the brake pedal first to start the engine!

Posted on Jun 07, 2011

  • 514 Answers

SOURCE: car wont move

when car is not started brake is not operative cause needs boosters help and the booster operates with vacuum, produces by the engine. first you need to know what tire(s) are locking, if rear tires are drum type, check if springs are in possition, did you bleed or replace brakes lately? also front brakes, from master cylinder to certaine point is pipe and from there to the caliper is rubber hose, and due to time and use, this hose gets damage inside, and wont let the brake fluid release its pressure after been aplied to stop the car, and front brakes will be applied due to this phenomenon

Posted on Dec 03, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Car sometimes wont start even if just turned off replaced starter motor and ignition barrel


Try starting it with the shift lever in neutral, if it starts, the transmission switch is bad (automatics), or with the key to start position move the shift lever thru the range of gears. If a stick shift and the clutch pedal must be pressed down, the clutch switch may be going out if intermittent starts

Apr 12, 2014 | 1989 Toyota Camry

1 Answer

Car will not turn over but all the lights work


there is a switch that prevents the starter from engaging at certain times. (stick shift wont work without clutch pushed all the way down) (automatic wont work unless in park or neutral). ensure that clutch is pressed or transmission fully in park. the switch could also be bad, but is easy to replace.

Feb 07, 2014 | Hyundai Motor 2004 Sonata

1 Answer

Megane wont start when l press down the clutch only when l press brake pedal


Hi,

Thats how it works! Modern carshave to press the clutch/brake pedal. French cars are different, u have to press the brake pedal first to start the engine!

Jun 07, 2011 | Renault Le Car Cars & Trucks

1 Answer

I was driving on the reberse gear of my car on the very steep ramp but wasnt able to get it up after some time i tried the starting the car the car get starts in any gear even without pressing the clutch...


The sounds like two problems, first is starting an any gear means the neutral safty switch is bad the car should never start unless you have the clutch pedal down, next is the car will not move an any gear, this is due to a bad clutch, its burnt out and so its not connecting with the flywheel, the clutch needs replacing. hope this is helpful.

Aug 31, 2010 | 2006 Mitsubishi Lancer

1 Answer

Clutch wont disengage and i can push the car when


That burnt smell is what used to be your clutch disk, and you will need to replace the clutch before you will be able to drive that vehicle again. You should purchase a complete clutch kit for your vehicle, and it should come with a new pressure plate, clutch disk, throw-out/release bearing, a pilot bearing, and a clutch disk alignment tool, and be sure that the pilot bearing is replaced when that new clutch is installed.

Jun 04, 2010 | 1999 Saturn SL

2 Answers

Honda crx wont start


check the alternator

Aug 26, 2009 | 1991 Honda Civic

2 Answers

Power drain while depressing the clutch


it should have a clutch safty switch, what it does is if you try to start the car without the clutch pushed in it wont start. that switch could be trying to ground its self out. check where the clutch pedal is and you should see a form of push switch attached to it, check for exposed wiring on etc

Dec 10, 2008 | 1990 Suzuki Samurai

2 Answers

1998 Honda CRV Clutch Problem


hello with your clutch problem if its a hydraulic clutch i cant help you but if its a cable clutch either your cable has snapped or you might of snapped your clutch fork. common problem in holdens also

Nov 29, 2008 | 1998 Honda CR-V

1 Answer

Mitsuibishi lancer evo 4


im a little confused re clutch replacement normally in order to start a manual transmission car the clutch pedal needs to be pressed down all the way before the car will turnover . as you say it will start but you need to push down clutch am i right? but when you try to put it into gear grinding ?wont go in to gear yes is this whats hapinin?ok the way that these clutches work nowadays is that there is a system similar to brake system there is a resivoir for the oil and a slave cylinder that pushes the clutch throwout leaver so that the gears can be changed did you see a small cylinder that pushes against the clutch lever? does it have a hose coming from it ? this system needs to be bleed just like the brakes on your car . find the resivoir small resivoir open lid and fill with brake fluid now go under car and find slave cylinder it will be somewhere near the transmission and bellhousing there will be a hose attached there will also be a bleed nipple attached you need to open this a few turns and let it drip dont press clutch pedal when bleed screw is open it will bring air into system , you want to remove all the air in the system so get a friend to go into car and pump clutch pedal then hold it to the floor while its being held down you open bleed screw until clutch pedal hits the floor tighten bleed screw then tell friend to pump up again do this 5 or 6 times making shure clutch fluid level doesnt drop down too far keep topping it up with the fluid that squirts out while bleeding this way you dont waste fluid as well as keeping fluid from hitting the ground .anyhow after trying this slave cylinder bleeding proceedure .try to see if car will go into gear . also see that there is no adjustment on slave cylinder . also i hope that you put the clutch facing the correct direction flywheel side towards flywheel . let me know how you do with this project

Jul 03, 2008 | Mitsubishi Lancer Evolution Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Kia Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

yadayada
yadayada

Level 3 Expert

75822 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8215 Answers

Are you a Kia Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...