Question about 2000 Ford Mustang

1 Answer

P0192 Code, car stalling due to too much fuel pump duty cycle

Car is stalling/stumbling. P0192 code is popping up. Has a new frps and fuel filter. New fuel pump as well.

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Ford Master
  • 42,046 Answers

Code p0192 refers to fuel rail pressure (FRP) sensor ---low input===causes ---wiring short to ground---FRP sensor.
replace the sensor.

Posted on Feb 16, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

Car stalls when excelerating on vt 3.8 v6 comomodore


sounds like a injection problem have the OBD read will give you a code to where problem lies

Mar 30, 2014 | 1998 Holden VT Commodore

1 Answer

P0191 code - Intermittent stall - 2006 Ford Explorer 4.6


Sorry but you should take it to the dealer

Apr 18, 2017 | Cars & Trucks

1 Answer

P0192


P0192 - Fuel Rail Pressure Sensor Circuit Low Input

Possible causes- Excessive resistance in the circuit
- Low or no fuel
- Wiring harness connector of the fuel pressure sensor
- Fuel Rail Pressure Sensor
- Fuel Pump or fuel pump relay defective. I think this is the problem.

Oct 12, 2012 | Cars & Trucks

1 Answer

My car continues to stall while going down the road and after sitting a few minutes it will start again. I have replaced the fuel pump, fuel pump relay, fuel filter, plugs, plug wires, altenator, voltage...


OVP, MAF and have duty cycle set.

OVP's (Over Voltage Protection relay) are known issues in these cars.

Hop on over to benzworld.org to find out alot more.

Jul 29, 2010 | 1989 Mercedes-Benz 300-Class

2 Answers

HAVE A 99 GRAND PRIX WITH CODE P0171 SYSTEM LEAN-BANK 1. I REPLACED THE OXYGEN SENSOR ON THE REAR MANIFOLD THAT IS CHANGEABLE FROM TOPSIDE. LIGHT/CODE IS STILL COMING ON AND SHUTTING OFF BY ITSELF. CAR HAS...


po171 is a lean code, and could be likely caused by a plugged fuel filter, or a weak fuel pump, I would recommend changing the fuel filter first since its cheaper.. The filter is located under the rear of the vehicle by the fuel tank, if this doesn't help run, or have run a fuel pressure check to determine if that is the cause. Also look carefully under the hood for any hoses or lines disconnected causing a vacuum leak, this can also cause a lean code

Jan 09, 2010 | 1997 Pontiac Grand Prix

1 Answer

Car starts and stalls. Don't hear sound of fuel


The mechanic should check on the fuel pump and the Idle of the fuel pump . if the fuel pump is malfunctioning then you have to repair it.Then also the throttle if the throttle is being worn out or malfunctioning then you have to repair or replace it.The Idle should be adjusted because of the engine is stumbling .the reason why the engine is stumbling or the car over heats is that the fuel pump is not functioning good or there is a problem in the fuel pump.and also it is the reason why the engine light goes off when cold because of the engine problem is in the fuel pump.such fuel or is not entering or going to the engine.

Sep 12, 2009 | 2001 Mazda MX-5 Miata

1 Answer

03 f250SD 5.4 lt. starts runs 1 min shuts off over & over.


well you can check the ignition control module or crank sensor somtimes when they get hot they have a crack and will get worse when hot hope this helps

Aug 26, 2009 | 2002 Ford F250 Super Duty SuperCab

1 Answer

Car keeps stalling has all new parts


Run it into autozone or Pep Boys and get a free trouble code scan, and see what comes up, then we can go from there.

May 26, 2009 | 1997 Oldsmobile LSS

Not finding what you are looking for?
2000 Ford Mustang Logo

164 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75797 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22114 Answers

fordexpert

Level 3 Expert

5495 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...