Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There is a control computer for the wing under the passenger side dash. Check to make sure the connector to this computer did not come loose.
Posted on Feb 04, 2010
Sounds like a bad battery. Do not lock or unlock the doors until you verify the battery is good. If the alarm was on when the battery went dead, you may not be able to open the bonnet to jump the battery. The 1999 Boxster does not have a red jumper post on the fuse box. You may need to hook a male-to-male cigarette lighter between the car and another car. Do not try to start the car with the cigarette lighter connect. When charged, you should be able to reset the alarm and open the bonnet. You may will need to reset your radio when the battery is replaced: http://www.a2dvoices.com/realitycheck/porsche/
Posted on Apr 12, 2010
What you need to do is raise the spoiler via the switch to the full extent and place pieces of wood between the spoiler and body, then using a 'C' spanner to fit round the top of the rams and locate into the small hole (i found the multi purpose spanner that comes with pushbikes has just the right fitting) turn each ram 1/4 turn, but be careful because when it releases from the spoiler the ram will retract into its housing with great force taking the spanner with it and damaging the body. good luck!
Posted on Apr 29, 2010
Sounds like low speed coil in the Blower Fan resistor block has failed. The Blower Fan Resistor Block is usually located in the air ducting adjacent to the Blower Fan. The Resistor Block consists of 3 or 4 coils of special resistance wire attached to terminals which connect to the wiring that comes from the fan switch and then to the Blower Fan. The block is on the output side of the fan unit so that the airflow from the fan past the coils inside the duct assists in preventing them from overheating and burning out.
Access to the Resistor Block is from under the dash. To replace, remove the multi-pin connector and then undo the screws holding in the block. Check air duct for leaves and dirt which may have caused the coils to fail. .Replacement is the reverse procedure
Posted on Nov 27, 2010
Tips for a great answer:
Nov 26, 2017 | Pontiac Bonneville Cars & Trucks
Jul 02, 2014 | 2003 Porsche Boxster S
Feb 15, 2014 | 2005 Porsche 911
Sep 13, 2011 | 2005 Porsche 911
Jan 28, 2011 | Porsche 911 Cars & Trucks
Feb 09, 2010 | 2005 Porsche 911
Jan 23, 2010 | 1995 Porsche 911
Apr 20, 2009 | 2005 Chevrolet Equinox
Apr 04, 2009 | 2000 Volkswagen Beetle
Dec 15, 2017 | Chrysler Cars & Trucks
48 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: