What caused this and how do I fix it?
SOURCE: Seat belt repair
first for the switch in window
the window switch is easy to test you just gotta remove switch out of the door leaving it hang there is a way to test with a guaged wire with fuse on it
take the main power wire and touch to the other connectors on the main switch if the window goes down or up the switch is the problem
im suggesting this way first with fuse cause its easier then testing the windows motor inside the door frame the switches should just pop out of the panel with out haveing to take panel off
now the seat belts there are 2 style that are common to chevy
one is inside the molding of the drivers panel you gotta pop off the panels easily and gently to get at the seat belt retractor this will be bolted to the metal under the molding
the other style is in the seat which you gotta unbolt the seat under the top half it will need to be unbolted at the bottom top half of seat
when you pull threw the top section of top half of seat remember to tie a string to the end so that when you pull threw top half the string will be there so you can connect too new belt and pull back threw with ease make the string long enough to hang
now the bottom half of seat what i call the "**** seat" you remove the molding at bottom around the belt retractor this will be bolted to floor bolt also pull belt threw molding once molding removed
disconnect any electric wires
now saftey issue involved with seat belt removal is for a reason i dont know of the dealer ship always discharges the belts and air bags once removed i guess because of static electricity becareful when you remove belt and replacing belts cause static elec. can set them off
once your seat belt is removed place in card board box and take to dealer after complition of installing new belt they will discharge your seat belt for you and then you can dispose of it properly
SOURCE: driver's door keyhole fell inside door
The only way to get the lock back is to take the door panel off the inside. There is a C-ring or E-ring that goes around the lock cylinder to hold it in the hole. Did some one punch it in to get the door open? There may be damage done. The lock cylinder may keep falling in if the hole is now to big. The lock cylinder goes in from the outside and the clip holds it from falling out of the door. It does not fall into the door very easily. If you take it to an auto glass place they can get the door panel off and on for you for a fair price. You do need a special tool to get the panel off without breaking the clips. You can rip it off and break the clips and purchase new ones from the dealer, an auto parts store or a window specialist. Hope this helps. If you have any more questions post them here I will check back again later.
SOURCE: 03 chevy tahoe
There are seperate blowers for the front and rear air. It is most likely either your blower motor or the resistor, both located under the passenger side dash. I got a blower from a salvage yard for $25, But ended up having to get the resister from the dealership for about $130. Hope this helps.
SOURCE: Driver side seat belt will not pull out, Help!!
Seat belt lock spring most likely failed causing it to stay locked. Requires seat belt replacement.
SOURCE: drivers side window switch not working on 2005
the drivers door switch is most likely bad, they get used the most and wear out first, the connector on the back of switch may have come loose and not making good electrical contact, remove switch and check connector and if still not working need new switch, the windows are all on same circuit and either all work or none work so not fuse. extremely rare is a short in wired but not likely.
144 views
Usually answered in minutes!
×