Question about 2007 Cadillac CTS-V

Open Question

Manual shifter, cruise control and door locks stopped working

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What is wrong 2007 HHR cruise cntrl and auto door lock function stopped working at the same time ?


Automatic Door Lock Operation
This BCM controlled feature can be personalized to driver preference.
The BCM will automatically lock the vehicle doors if the following conditions exist:
• All vehicles doors are closed.
• The ignition is in the ON position.
• The vehicle is shifted out of PARK.
The BCM will then unlock the doors when the ignition is placed in the OFF position. The body control module (BCM) monitors the signal circuit of the cruise control switches. The BCM relays the cruise control switch status to the engine control module (ECM) via the GMLAN serial data circuit. The ECM uses the status of the cruise control switch to determine when to capture and maintain the vehicle speed. The ECM monitors the vehicle speed signal circuit in order to determine and the desired vehicle speed. The ECM uses the throttle actuator control (TAC) motor in order to maintain the vehicle speed. For further information on the TAC system, refer to Throttle Actuator Control (TAC) System Description for the 2.2L (L61) engine or to Throttle Actuator Control (TAC) System Description for the 2.4L engine. Ignition voltage is supplied to the cruise control switch from the 2-amp EPS fuse located in the integrated BCM fuse block.
You should have the BCM checked for DTC'S

Jan 22, 2016 | Cars & Trucks

1 Answer

What is the most likely cause for non working cruise control?


the cause is but one. (you) no kidding....
"you forgot to scan the PCM"
after all , cruise mode is dangerous. and today the rules are more strict.
the new rules, cut the Cruise for any serious transmission/engine errors the drive train, or more, say some kid opens door on the fly.>? or bumps the shifter? or the brakes switch sticks on ,
more. too.
why not scan it first. the ask.
as you will have DTC errors you are ignoring, I BET.

the FSM book covers all this,
posted the link 100 times.
its $4 read. at suzuki pit stop plus, do so and win.

Jan 03, 2016 | 2007 Suzuki SX4

1 Answer

Stop lights, Shifting. Cruise control


Most likely you're looking at the switch by the brake pedal. (stop light switch)

That switch not only controls the rear brake lights, but also the solenoid that releases the shift lock for the shifter.

Oct 21, 2013 | 2002 Ford Taurus SES

1 Answer

My 2002 Impala is having electrical problems. The cruise control stopped working, the power locks makes clicking noises and sometimes will not work and the trunk opened on its own. What is wrong?


Could be a shorted out or damaged power door lock module. I had a 1990 Oldsmobile Cutlass Calais that had corrosion on the contacts of the module that when cleaned worked fine. Before that, the power door locks would lock the doors inexplicably.

For the cruise, I would check the fuse first.

Also, parts are probably still available for your car since it was made 8 years ago, which falls under the 10 year limit.

Jul 06, 2010 | 2002 Chevrolet Impala

1 Answer

Cruise control not working, when turning ignition


sounds to me as if you need a new ignition switch there is a metal rod that allows the locking of the shifter and as far as cruise is concerned the lever itself goes bad often but check to ensure the vacuum line going from thet intake to the round ball is in tact and not rotted out or disconnected but the shifter is locked from the ignition switch itself if you remove the plastic housing that surrounds it you should see the rod that runs down the steering column and look for the obvious anything thats come disconnected etc .

Sep 06, 2009 | 2004 Ford F150

1 Answer

Cant open rear doors from the inside; cruise control doesnt work


after cking the child lock, try locking and unlocking the manual locks to see if you can hear any movement inside the doors. if all else fails, you have to remove the door panels.. starting from the aft lower corner, (careful not to tear the plastic moisture sheeting, just peel it back), the door panels are normally held in by plastic plugs and screws under the armrest, etc. once inside the door cavity, ck the linkages for wear or any signs of them being disconnected. try all the lock mechanisms again to pinpoint the cause, its good practice to clear all the drain holes at the lower part of the cavity once you're in there.

Jun 02, 2009 | 1996 Audi A4

1 Answer

My Accord's shifter is stuck in ''Park'' ; Cruise doesn't work now


Most likely are. Check to see if your brake switch performs both functions. Does it do the cruise and the brake/park lock.

Mar 07, 2009 | 1994 Honda Accord

2 Answers

Power items on the fritz


Hi,

1. there should be a 5A fuse for the dashoard lights in the fuse panel. Yes it may be cause by the dimmer switch.

2. Cruise control stop working. this may seem funny to you but make sur all your rear brake lights work. The way Ford cruise control system works, it uses resistance to engage the cruise, with a burnt brake light, the resistance changes and the module will not recognise the input.

3. try replacing the relay box on top of the radiator.

Hope this helps you out

Oct 22, 2008 | 1992 Ford Taurus

Not finding what you are looking for?
2007 Cadillac CTS-V Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

75066 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7754 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...