Question about 2006 Chrysler Sebring

1 Answer



Posted by on

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    A rookie expert who has answered 20 questions on their first day.


    An expert who has answered 20 or more questions within one hour.

  • Chrysler Expert
  • 189 Answers

Engin miss timed

Posted on Feb 28, 2014

4 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1033 Answers

SOURCE: oil sending unit on 2004 chrysler sebring V6

Should be located close to the oil filter. It will screw in like a spark plug. It has a harness plug. Easy to change, save yourself $70 in labor. You will need a fairly large wrench to remove

Posted on Jan 03, 2010

  • 1016 Answers

SOURCE: 2001 chrysler sebring leaking water beneath


This is called the water pump weep passage which is a sign that your seal in the water pump has failed.

You need to replace the water pump.

Posted on Sep 15, 2010

  • 17970 Answers

SOURCE: I would like to see a picture of a thermostat

Click over image for zoom...


Fig. Air bleed valve (1) and thermostat housing (2) 2.7L-engine

Hope this helps (remember to rate and comment this free answer).

Posted on May 26, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

Leaking coolant from a small 1/4 hole in the engine block just above the thermostat housing

So a cracked engine block then? not much you can do about that apart from replacing the engine.

Mar 26, 2015 | 2007 Chrysler Sebring 2.7

1 Answer

The car is rolling but it just wont start, its been in the shop twice for this problem and no one can figure it out, how often does this happen in these cars?

Car not starting or turning over indicates towards multiple possibilities. It can be issue with battery or weak battery. But if battery checks out ok, then it can be starter issue or faulty alternator or problem with low fuel pressure or no spark at spark plugs due to dirty spark plugs or faulty ignition coil or injectors getting cracked or dirty and needs to be cleaned.

To confirm the problem, the basic troubleshooting is required.

Click this link below and follow the troubleshooting:------


This will help.


Feb 29, 2012 | 1998 Chrysler Sebring

1 Answer

2002 chrysler sebring, the drivers tail light, running light portion of the bulb keeps blowing, brake and signal are fine.

Is your lense cracked where water can get into the housing? Are you absolutely certain that you are replacing it with the correct bulb? Are you using a good name brand bulb like Wagner or Sylvania? or some off-brand cheap bulb made in China?

Dec 18, 2010 | 2002 Chrysler Sebring

2 Answers

2001 chrysler sebring leaking water beneath thermostat housing through a factory hole , I changed thermostat and gasket no change


This is called the water pump weep passage which is a sign that your seal in the water pump has failed.

You need to replace the water pump.

Sep 15, 2010 | 2001 Chrysler Sebring

1 Answer

Thermostat housing repair guide 2006 Chrysler Sebring 2.7L

If HOUSING is broken, there is no repair, replace it. If you are replacing the thermostat, go to auto parts shop and they will show you where it is, and how to replace it. Just make sure you put thermostat in with the right side up, clean BOTH surfsces, and tighten down as specified. Having to go back and do it again will s@#k

Feb 03, 2010 | 2006 Chrysler Sebring

1 Answer

2002 Chrysler Sebring Convert wont turnover

If you're not hearing a click from the starter check for a starter relay. May be burned out! DO you hear the fuel pump kick in when you turn the key on? If not something might have triggered your security system and locked you out!

Jun 28, 2009 | 2002 Chrysler Sebring

2 Answers

2003 Chrysler Sebring won't start

Probably the switch that is made when you have it in park. there is a switch that tells the car its in park. try and put the transmission in Neutral and see if it will start. Most cars will allow you to start the engine inpark and neutral. If it starts in neutral all the time then its the switch.

Aug 05, 2008 | 2002 Chrysler Sebring

Not finding what you are looking for?
2006 Chrysler Sebring Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chrysler Experts


Level 3 Expert

75817 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8180 Answers

Are you a Chrysler Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides