Question about 2000 Honda Civic

1 Answer

MIL gets on and scan indicates error code P1361

My Honda Civic 2000 when I am in traffic swithes on MIL. Scan indicated error code P1361. Sometimes the accelerator does not respond and if I press it further when it is not responding MIL switches on and car stops and I have to start again. The person who did the test gave me the result of the test and told me that a sensor should be changed. The problem is that I lost the result of the test (I remember the error code because I was doing a lot of search in internet) and because of that I can not go to the technician who tested the car. So I checked the service manual and found "TDC" sensor. I asked Honda for an invoice for TDC sensor and they gave me an invoice for "Sensor assy., TDC CYlinder". my question is: is TDC sensor the same as "sensor assy., TDC cylinder"? Other question is: does replacing the sensor solve the problem. or the problem can have another cause. Thank you very much. Cremildo

Posted by Anonymous on

1 Answer

  • Level 1:

    An expert who has achieved level 1.

  • Contributor
  • 1 Answer

WHERE THIS COMENT BOX

Posted on Feb 15, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 21 Answers

SOURCE: 94 honda civic not starting

is there any noise from starter at all?

Posted on Sep 14, 2008

  • 337 Answers

SOURCE: Replacing crank shaft position sensor on 2000 Honda Civic

http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c1528018f5b9

Posted on Dec 10, 2008

MNfisherman
  • 11896 Answers

SOURCE: i have a 2001 honda civic took it to autozone and

TDC top dead center sensor. Tells when the #1 piston is at top dead center position.
P1361 Intermittent Interruption In TDC 1 Sensor Circuit

Posted on Apr 03, 2009

  • 491 Answers

SOURCE: Replace crankshaft position sensor

Remove the left front wheel....(drivers side). Remove all accessory belts. Remove the crankshaft shaft pulley.......remove the plastic lower timing belt cover.....and there it is! It is mounted with one bolt.
The wiring runs down the right side of the timing cover while looking at it from the drivers side of the car.

Posted on Aug 17, 2009

Testimonial: "I ended up having my mechanic do the work. He did say he had to move all those parts to get to the sensor. "

bschilz
  • 2049 Answers

SOURCE: what is P1361 Intermittent Interruption In TDC 1

Check out the Top Dead Center (TDC) sensor, connector 124 (gray and on the distributor) check power and grounds. It's missing signal from the TDC sensor in the distributor and causing a misfire.

The codes states that it's an intermittent loss of sensor signal, definitely sounds like wiring. Check for the obvious visual stuff first, corrosion, any cuts or holes in the wiring insulation and then start using a multimeter to check the voltage drop, continuity and resistance for all the connectors and wiring.

I suspect this may be too technical, but you asked about how to fix the problem and this is the answer.
It may be time to take the car to a qualified mechanic.

http://ww2.justanswer.com/uploads/thebesthonda/2009-03-26_124632_4_cylinder_tdc_cyp_sensor_troubleshooting.pdf

Posted on Feb 20, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How do i fix code poa7f for Honda Civic 2011


DTC P0A7F indicates: Battery Module Deterioration.

General Description
The capacity of the battery module is defined by the upper and lower limits of the battery module voltage.
When the battery deteriorates, the limits of the battery capacity are narrowed. Under specific driving conditions, the battery condition monitor (BCM) module monitors the maximum and minimum voltage of the battery module. The BCM module computes the battery module electrical current value during operation to calculate the battery module capacity. If the calculated value is under the specification, a malfunction is detected and a DTC is stored.

Malfunction Threshold
The battery capacity is less than 10 % of 6.5 Ah.

Diagnosis Details
Conditions for illuminating the MIL
When a malfunction is detected, the MIL comes on and the DTC and the freeze frame data are stored in the PCM and BCM memory.

Conditions for clearing the MIL
The MIL will be cleared if the malfunction does not recur during three consecutive trips in which the diagnostic runs.
The MIL, the DTC, and the freeze frame data can be cleared by using the scan tool Clear command or by disconnecting the battery.


At this point you should bring it into your nearest honda dealer as the IMA battery will require replacement.

Talk to someone at the dealership about the IMA battery in-warranty exchange program.

I hope all this information helps you out.

Jun 26, 2015 | 2011 Honda Civic 1.4

1 Answer

Honda civic feria 2002 P1361


Here is what the code for that says. I would just recommend changing that sensor first to see if it will fix the issue completely. You'll need to disconnect your battery after you change the sensor. This will help your computers reset correctly, and more efficiently.

P1361 TDC Sensor Intermittent Interruption

here is a link that might help a little bit.

http://www.civicforums.com/forums/36-mechanical-problems-vehicle-issues-fix-forum/301242-p1361-code-engine-runs-half-power.html

Mar 15, 2014 | 2002 Honda Civic

1 Answer

I went to scan my toyota yaris car and the following codes were give ; temperature ckt low input po117


EOBD II Error Code: P0117
Fault Location:
Engine Coolant Temperature (ECT) Sensor (G62) - Low Input
Possible Cause:
Malfunction Indicator Lamp (MIL) Triggered on first occurrence.
Coolant thermostat.
Wiring short to earth.
Engine coolant temperature (ECT) sensor.

EOBD II Error Code: P0340
Fault Location:
Camshaft Position (CMP) Sensor A (G40), Bank 1 - Circuit Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) active.
Wiring from/to Camshaft Position Sensor (CMP) faulty.
Camshaft position (CMP) sensor faulty.
Timing misaligned.
Possible Solutions:
Check Wiring from/to Camshaft Position Sensor.
Check Camshaft Position Sensor.
Check Timing.

EOBD II Error Code: P0500
Fault Location:
Vehicle Speed Sensor (VSS) - Circuit Malfunction
Possible Cause:
Malfunction Indicator Lamp (MIL) Non Emission Fault - No warning light.
Wiring.
Vehicle speed sensor (VSS).
Engine control module (ECM).

Dec 13, 2012 | 2001 Toyota Yaris

1 Answer

1997 honda accord tranmission problem code p0700 drive 4 flashes


Many vehicles have a control module for the automatic transmission called a transmission control module (TCM). The engine control module (ECM) communicates with the TCM to monitor the automatic transmission for faults. If the TCM detects a fault in the automatic transmission and sets a transmission related fault code, the ECM is informed of this also and sets a P0700 in the ECM memory.
This illuminates the Malfunction Indicator Lamp (MIL) to let the driver know there is a problem. If this code is present and the MIL (Malfunction Indicator Lamp) is illuminated that basically means there is at least one transmission code set in the TCM's memory. P0700 is an informational code only. It doesn't point to a direct fault in the engine, only a general fault in the transmission. More diagnosis is necessary to identify what the transmission fault is. This requires a scan tool that will communicate with the transmission module.

Symptoms Symptoms of a P0700 DTC may include:
  • Malfunction Indicator Lamp (MIL) illumination
  • The transmission may exhibit drivability problems like slipping, etc.
Causes More often then not, the cause of this code is that there is a transmission problem of some kind. The TCM detected the problem and set a code. P0700 means that a fault code is stored in the TCM. However this doesn't rule out the possibility of a failed PCM or TCM (unlikely).
Possible Solutions For a P0700 the only real solution is to acquire a scan tool that will communicate with the transmission control module. Extracting this code from the TCM will be the first step in repairing the fault in the transmission.
If the TCM compatible scan tool will not communicate with the Transmission Control Module then that is a good indication that there may be a fault with the TCM itself.

Oct 20, 2012 | 1997 Honda Accord

1 Answer

Code p1361 on my 2000 civic


The code is for a problem with the sensor on top of the camshaft.
The sensor would need to be tested.
There is a tech service bulletin for the 2001 model.

Sep 10, 2012 | 2000 Honda Civic

1 Answer

My 02 civic showing codes P0118 and P1361 any answer


1) proceed according and fix it.
a) P0118 bad oxigen sensor see the diagram attached
b)P1361 TDC sensor intermittent see the diagram attached.
God bless you

5_22_2012_10_26_33_am.jpg5_22_2012_10_26_51_am.jpg5_22_2012_10_27_12_am.jpg

May 21, 2012 | 2002 Honda Civic

1 Answer

I have a 2000 honda civic I need to see what this code means po420


  • If this is the only code you are getting, for a 2000 Honda Civic, this code indicates you need to replace the Catalytic Converter.

Regards, Tony

May 19, 2011 | 2000 Honda Civic

2 Answers

Srs light stays on on my Honda civic


The most likely possibility is the connector for the airbag is not on securely. Check the connector first. But if the connector is connected properly then you will have to get the error codes to locate the exact problem for SRS light ON.
There is a way to pull the codes from the SRS control unit without a scan tool.
1. Turn the ignition switch OFF , and wait for ten seconds. Then connect the SCS service connector to the service check connector (2P). If you do not wait ten seconds, the SRS unit will not be completely reset and will not output DTCs.
2. Turn the ignition switch ON (II). The SRS indicator light comes on for about six seconds and goes off. Then it will indicate the DTC:
· The DTC consists of a main code and a sub-code.
· Including the most recent problem, up to three different malfunctions can be indicated.
· In case of a continuous failure, the DTC will be indicated repeatedly.
· In case of an intermittent failure, the SRS indicator light will indicate the DTC one time, and then it will stay on.
· If both a continuous and an intermittent failure occur, both DTCs will be indicated as continuous failures.
· In case the system is normal (no DTC), the SRS indicator light will stay on.
3. Read the DTC.
4. Turn the ignition switch OFF, and wait for ten seconds. Then disconnect the SCS service connector from the service check connector (2P).
The SCS Service Tool is nothing more than a jumper wire.
Thanks. you can rate this solution and show your appreciation.

May 19, 2010 | 2000 Honda Civic

2 Answers

Manual for honda civic ferio 1996. If you can download for my guide


Hi, is not the complet manual but have all the wiring diagrams about this model: Honda Civic 1997

I have long time ago one '97 Ferio and work for me.

Good luck, and remember rated this help.

Dec 04, 2009 | 1996 Honda Civic

1 Answer

Honda civic


An intermittant check engine light ( MIL, malfunction indicator lamp) usually means the system has noticed some trouble that has either corrected itself or has been compensated for. You can have a shop check the DTCs ( Diagnostic Trouble Codes), or for pending codes ( problems noticed but not enough to store a fault code)

Jul 02, 2008 | 2000 Honda Civic

Not finding what you are looking for?
2000 Honda Civic Logo

Related Topics:

123 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7726 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...