Question about 2005 Toyota 4 Runner

Open Question

How do I remove the rear view mirror in my 1992 toyota 4runner

I need to remove the rear view mirror mounted in the roof

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 20 Answers

SOURCE: How do I replace the drivers side-view mirror on my 1994 Toyota C

LITTLE BLACK COVER ON THE INSIDE JUST POPS OFF. THEN IITS 3 10MM BOLTS AND A WIRE CONNECTOR

Posted on Nov 27, 2008

  • 318 Answers

SOURCE: 2002 Toyota Rav4 remove door panel

There are some hidden screws around the door handle but you get under the panel and yank hard to pop the fasteners. Also remove the black piece behind the mirror. Alot of times it is seperate. 3 screws behind that and the connector and you are done.

Posted on Jul 22, 2009

  • 1 Answer

SOURCE: Replacing RH Side view mirror on a 2006 Toyota Sienna

I had to replace my passenger side mirror on my 2004 Sienna a while back. I took some pictures as I did it. Maybe this can help.http://time4nothing.blogspot.com/2008/03/fixing-04-sienna-passenger-side-mirror.html

Posted on Oct 04, 2009

  • 1 Answer

SOURCE: The internal rear view mirror

I know this post is almost a year old, but I just did this two minutes ago with a mirror from a 99 Avalon and I thought I could help out someone in the future. So...

First, you will need two slotted screwdrivers--one mini and one regular size. On the flat end of the button there is a small slot just left of center. Insert the mini screwdriver into the slot with the flat edge against the bottom of the button. Aim it towards the middle and push back--this releases the clip. Now, while holding the mini screwdriver in place, take the regular screw driver and push/pry from the curved end of the button. The button should slide right out. No problem!


Posted on Oct 10, 2009

jlisagearhea
  • 412 Answers

SOURCE: replace driver side mirror

The entire assembly has to be replaced, can not just replace the mirror.Remove the plastic trim on the inside of the door on the top part of the panel, either comes off with one screw or bolt or simply pull and it has pins in it.Then remove your bolts that hold the mirror in from the inside.If you have a power mirror remove the electrical pigtail, then simply reinstall.Hope I could help..HAPPY HOLIDAYS!!!

Posted on Dec 22, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

How to remove inside rear view mirror on 1999 pontiac grand prix


Most mirrors have a very small allen screw that you have to losen then the mirror will have to be slid up towards the roof of the car and it will slide off the metal piece that is glued to the windshield

Aug 27, 2010 | 1999 Pontiac Grand Prix

1 Answer

Need a diagram for installing a drivers side electric power mirror on a 1995 mercury villager van


here's 1996, all I have. Please rate.

Mirror, Power — Outside Rear View NOTE: This procedure applies to both RH and LH power outside rear view mirrors.

Removal
  1. Remove the front door trim panel (23942). Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws and the outside rear view mirror mounting hole cover (17K709) from the front door (20124).




  1. Remove the wire clip.
  1. Disconnect the power outside rear view mirror electrical connector.




  1. Remove the three power outside rear view mirror bolts and the power outside rear view mirror.




Installation
To install, reverse the removal procedure. Tighten the three power outside rear view mirror bolts to 3-4 Nm (27-35 lb-in). Glass, Outside Mirror
Removal and Installation
Refer to the glass replacement procedures in Manual Mirror for power outside rear view mirror glass (17K707) Trim Cover
Removal
  1. Remove the front door trim panel. Refer to Section 01-05 for the removal procedure.
  1. Remove the two outside rear view mirror inside mounting hole cover screws.


    Remove the outside rear view mirror mounting hole cover.
Installation
To install, reverse the removal procedure. Mirror Control
Removal
  1. Use a small flat-blade screwdriver to pry the power outside rear view mirror control switch from the instrument panel (04320).


May 13, 2010 | 1995 Mercury Villager

1 Answer

Clock doesn't work. I put in an after market radio


Check your instrument panel fuses. #18 AC it controls your clock, antenna, radio, and power rear view mirror. If the fuse is OK then it is most likely an internal failure in the clock. I offer an affordable repair service and have the removal instructions. Check out
www.autoclockrepair.com

May 08, 2010 | 2000 Toyota 4Runner

1 Answer

Key tumbler removal


If you need to remove the whole switch key and steering lock, you need to drill or punch the mounting screw to loosen them, they are called tamperproof and when installed the top breaks of so they cant be removed. If you just need to replace the electrical part, they often come off the back of the key part with a couple of screws, check with a mirror and torch

Apr 20, 2010 | 1993 Toyota 4Runner

1 Answer

How do i replace left door mirior


remove trim panel, remove mirror fasteners.

Glass, Outside Mirror—Town Car

Removal and Installation
  1. Push upper edge of outside rear view mirror glass (17K707) into the outside rear view mirror to expose latch release.
  1. Using a small flat-bladed screw driver or equivalent, move latch release to released position.
  1. Remove outside rear view mirror glass mounting back and outside rear view mirror glass from outside rear view mirror.
  1. Disconnect heater wire connectors and auto dimmer connector, if equipped.
  1. To install reverse Removal procedure.
------------------------------------------------------------
Mirror, Power—Outside Rear View
Town Car

Removal and Installation
  1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
  1. Remove front door trim panel (23942). Refer to Section 01-05 .
Trim Panels, Door Front—Town Car
Removal
  1. Snap out two door pull strap retaining screw covers. Remove screws.
  1. Remove three screws on front and rear side and center of front door trim panel (23942).
  1. NOTE: The following procedure must be used during removal and installation of the door armrest and trim panel. Refer to the appropriate illustrations for component and vehicle model identification.

    Using the Trim Pad Removing Tool from Rotunda Windshield and Moulding/Trim Removal Kit 107-R0401 or equivalent, pry the trim panel retaining clips from the door inner panel.
  1. NOTE: Do not use front door trim panel to remove trim clips from door inner panel. Replace any bent, damaged or missing push pins.

    Remove window regulator control switch housing from front door trim panel. Lift up housing in front and disconnect all connectors.
  1. Disconnect wiring harness and heated seat switch electrical connectors if equipped.
  1. Remove the door trim panel.
  1. Disconnect two electrical connectors.
  1. Remove nut from outside rear view mirror mounting base.
  1. Swing outside rear view mirror (17682) toward driver door window glass to expose screw in mount base.
  1. Remove screw from outside rear view mirror base.
  1. Remove outside rear view mirror from front door (20124). Guide wiring and connectors through hole in front door.
  1. To install, reverse Removal procedure. Tighten nuts to 8-10 Nm (71-88 lb-

Nov 05, 2009 | 1996 Lincoln Town Car

1 Answer

How do I determine the correct fuse associated with the radio, clock, and side windows on my 1997 Toyota 4Runner?


Hello,

Check out the instrument panel fusebox. Fuse 18. ACC 15 A: Car audio system, power antenna, clock, power rear view mirror control.

I also have clock removal instructions on my website if you need them www.autoclockrepair.com

Oct 13, 2009 | 1997 Toyota 4Runner

1 Answer

How do you remove the rear view mirror from mount.


Is the mount made of metal or plastic? In either case, it will be attached to a "base" that is glued to the windshield. A metal mount should have a tiny little screw in it that pins it against the base. Loosen this crew and the mount should slide upwards (towards roof) off the base. A plastic mount should have a tab that you can pull on and slide it off upwards....

Aug 10, 2009 | 1994 Buick Park Avenue

1 Answer

Toyota avalon inside rear view mirror came off of mount


sliding the rear view mirror onto the metal tab on the window. look at the part of the mirror that slides over the peice on the window. one end is open and has grooves on the side. you have to put the base of the mirror above the metal mount and flat against the window then slide it down over the mount. there may be a screw to hold it in place.

Jun 25, 2009 | 1998 GMC Jimmy

1 Answer

I accidently knocked off my rear view mirror


Are you referring to the interior mirror mounted on the windshield? If so, did everything come off the glass? You can purchase a repair 'kit' at any parts store. Just follow the directions, the epoxy to 'glue' it back in place is fast setting, and will work well and quickly.

Jun 25, 2009 | 1994 BMW 3 Series

Not finding what you are looking for?
2005 Toyota 4 Runner Logo

Related Topics:

33 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7688 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...