Question about 2004 Chevrolet Avalanche

Open Question

I need to remove the drivers side air bag in the steering wheel on a 2004 chevy avalanche

How do you remove the air bag from the steering wheel on a 2004 chevy avalanche

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
tripletauto
  • 1450 Answers

SOURCE: 04 Chevy Avalanche Driver's heater blowing cold all the time

your mode actuator is stuck. try unhooking battery for a few minutes when you hook back up actuators will do a relearn.if this does not work will need to have replaced

Posted on Oct 20, 2008

Ad
  • 61 Answers

SOURCE: chevy steering wheel controls

You first have to disarm and remove the air bag (unscrews with bolts from behind the steering wheel) and then you will see the screws for the switches. Only the silverado awitches will work.

Posted on Jan 29, 2009

countrysi248
  • 443 Answers

SOURCE: I need to remove the door panel on my 2004 Avalanche

There are plastic clips that hold the door panel inplace .. First look for any hidden screws near the door handle . there might be a little plastic cover that you need to remove with a small screw driver to find the screws.. look under the handle also to see if there are any hidden screws . next take a flat blade screw driver and start at the bottom corner and try gently prying the door panel off . try to stay close to the plastic clips not to damage them by prying real hard .. once you have snapped them loose all the way around .. lift up on the door panel to remove it from around the window lip and out it should come.. holler if you have any problems.. usually The mirrors on the chevys are up above the panel and there is a triangle plastic cover over it on the inside .. it will pry off also gently and there are 3 nuts there that need to be removed .. use caution these fall behind the door panel ... holler if you need more. Jerry

Posted on Apr 24, 2009

  • 15 Answers

SOURCE: remove air bag

disconnect battery, and remove the bolts behind the steering wheel. the airbag will be plugged into to the clocksping just unplug it.

Posted on Jun 07, 2009

  • 1986 Answers

SOURCE: I need to remove the door panel on my 2004 Avalanche

You'll need to remove screws that are by the door handle, arm rest, under door and side of door and then gently pull back on the panel as there will also be retaining clips attached and you don't want to break them.

Posted on Aug 14, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

What the location of air bag computer on a 98 Mitsubishi mirage and after air bag has been replaced start light still on do I need to change computer? ??


airbag movie_0002.wmv - YouTube

? 4:30
www.youtube.com/watch?v=3ZMoCRcmZBs
Apr 6, 2010 - Uploaded by merlefyshwick Repairing stuck horn switch in 1999 MitsubishiPajero/Shogun/Montero ... Up next. Airbag & Steering Wheel Removal from Silverado Tahoe Avalanche ... How to Remove DVD Player from 2004 Mitsubishi Montero for Repair.

Sep 17, 2015 | Mitsubishi Cars & Trucks

1 Answer

How do I remove the front soft cover/air bag on a 2003 Chevy Cavalier steering wheel to gain access to the horn components? Does this require a special tool?


Disarming the System

Print

CAUTION The Supplemental Inflatable Restraint (SIR) system must be disarmed before performing many in-vehicle service procedures. Failure to do so may cause accidental deployment of the air bag, resulting in unnecessary SIR system repairs and/or personal injury.

  1. Turn the steering wheel so the vehicle's wheels are pointing straight-ahead.
  2. Turn the ignition switch to the LOCK position.
  3. Remove or disconnect the following:

    Ignition key AIR BAG fuse from the instrument panel fuse block Left-hand sound insulator Connector retainer and yellow 2-way connector at the base of the steering column. Right-hand sound insulator, if equipped with passenger side air bags Connector retainer and yellow 2-way connector from the passenger inflator module pigtail, if equipped with passenger side air bags

    0996b43f80208efb.jpg enlarge_icon.gifenlarge_tooltip.gif

    Fig. Driver-s side Yellow 2-way air bag connector retainer location

May 24, 2012 | Chevrolet Cavalier Cars & Trucks

2 Answers

Steering wheel adjustment , the steering whell is 90degrees off but the car does not pull eather direction. car was stolen no damage just steering whell truned


jack front of car up then turn steering wheel full lock to full lock and count the number of turns from either side then divide by 2 so you have the straight ahead position then remove the steering wheel and replace in the straight ahead position ,iam saying this because the vehicle may have been re tracked and only one track rod end adjusted so you have say 2 turns to the left and 2 and half to the right if you follow me .or remove the steering wheel then just hold it on and slowly drive forewards and lift wheel and refit to the correct position

Feb 10, 2011 | 1999 Mercury Grand Marquis

1 Answer

Remove ignition switch for a 2004 kia optima


Ignition Switch Removal & Installation To Remove:
  1. Disconnect battery negative cable.
  2. Disarm air bag system.
  3. Remove driver air bag module.
  4. Loosen screw and lift horn pad to remove.
  5. Remove lock nut and washer. CAUTION
    Do not hammer on steering wheel. Damage can occur to the energy absorbing portion of the steering column.
  6. Pull dynamic damper forward and lift up to remove.
  7. Remove steering wheel.
  8. Remove steering column shrouds.
  9. Remove lower cover.
  10. Remove multifunction switch.
  11. Remove entire lower portion of dash.
  12. Remove mounting fasteners and lower steering column.
  13. Remove bolts and separate ignition switch from steering column.
To Install:
  1. Install ignition switch to steering column and install bolts.
  2. Raise steering column and install mounting fasteners.
  3. Install lower portion of dash.
  4. Install multifunction switch.
  5. Install lower cover.
  6. Install steering column shrouds.
  7. Install steering wheel.
  8. Install dynamic damper.
  9. Install washer and lock nut.
  10. Lift horn pad and install screw.
  11. Install driver air bag module.
  12. Connect battery negative cable.
prev.gif next.gif

Jul 17, 2010 | 2004 Kia Optima

1 Answer

Need teke oof the air bag s10 chevy 1995


turn wheel so tires are straight-turn key to lock remove key -disconnect neg term at battery- remove air bag fuse in panel by drivers door-remove left side dash knee panel- unplug the connector position assurance(cpa) and yellow 2 way connector at base of steer/column--un lock steer/wheel and turn 90 deg --using a screw driver at the back of s/w is an opening push screw driver in opening releasing clip-turn wheel 180 deg other way and do same -tilt air bag up to access wiring connector disconnect inflator module and cpa clip

Oct 21, 2009 | 1995 Chevrolet S-10 CA Edition

1 Answer

Remove the steering wheel or airbag from a 2004 Volvo XC90?


You need a steering wheel puller. You may be able to rent this from your parts house. Disconnect the battery for no less than 1/2 hour before disconnecting the air bag or the air bag could deploy. Place air bag facing up or it could become a projectile if set off.

Aug 14, 2009 | 2004 Volvo XC90

1 Answer

Remove air bag


disconnect battery, and remove the bolts behind the steering wheel. the airbag will be plugged into to the clocksping just unplug it.

Jun 06, 2009 | 1999 Chevrolet Silverado 1500

1 Answer

Airbag deployed


SECTION 501-20B: Occupant Restraints — Passive — Supplemental Air Bag System 2000 Villager Workshop Manual REMOVAL AND INSTALLATION Module —Driver Air Bag Removal
syv~us~en~file=ani_caut.gif~gen~ref.gif WARNING: The backup power supply energy must be depleted before any air bag component service is performed. To deplete the backup power supply energy, disconnect the battery ground cable and wait three minutes.
NOTE: Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic procedure again. If the vehicle was in a frontal collision and the air bag did not deploy, the air bag may not have been needed. Complete a diagnosis of the air bag system before installing a new driver side air bag module (043B13). Refer to Diagnosis and Testing in this section.
  1. Disconnect the battery ground cable (14301). For additional information, refer to Section 414-01 .
  1. Remove the two driver air bag module retaining bolt access covers (one shown).
  1. Remove the steering wheel bottom cover to access the driver air bag module electrical connector.
  1. Disconnect the driver air bag module electrical connector.
  1. syv~us~en~file=ani_caut.gif~gen~ref.gif CAUTION: After removing, discard the driver side air bag module bolts and install new driver air bag module bolts during installation.
    Remove the two driver air bag module retaining bolts (one shown) and discard.
  1. Remove the driver air bag module.
    1. Separate the driver air bag module from the steering wheel and disconnect the horn pad switch.
    1. Remove the driver air bag module.

Apr 16, 2009 | 2000 Nissan Quest

1 Answer

Chevy steering wheel controls


You first have to disarm and remove the air bag (unscrews with bolts from behind the steering wheel) and then you will see the screws for the switches. Only the silverado awitches will work.

Jan 29, 2009 | 2002 Chevrolet Avalanche

1 Answer

Air bags


There are nuts on the back of the steering wheel for the driver side, they are in holes sunk down in there, the passenger side is retained buy nuts behind the air bag, you may have to remove the glove box liner to get at these nuts.

Sep 08, 2008 | 1997 Chevrolet Suburban

Not finding what you are looking for?
2004 Chevrolet Avalanche Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76630 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8516 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...