Question about Cars & Trucks

Open Question

Not starting no power to the engien - Cars & Trucks

Posted by Anonymous on

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


get an engine diagnostic test

Dec 12, 2013 | 2006 BMW 320d

1 Answer

When i try to start the car the engiene tries to start but its like the petrol is not going through? Therefore the car did not start!!

No initial combustion (engine does not start)
1. ECM power source circuit
2. Crankshaft position sensor
3. Camshaft position sensor
4. Ignition system
5. Fuel pump control circuit
6. ECM
7. Voltage output circuit
Engine cranks normally but difficult to start
1. Fuel pump control circuit
2. Compression

Dec 08, 2012 | 2005 Toyota Yaris 1.3

1 Answer

2008 dodge grand caravan wont start. is low on gas but would that be a factor why the engien wont try to start? it does like when the battery is dying it just produces a noise on the engien. battery has...

Car no start problem is sometimes very difficult to confirm. You try all the possible things, but still you get no fault and problem is still the same.--------
In that case, you need to check few things individually.
Check the spark,the battery,the crank, the fuel and other most possible parts. Click this link below for more details:--

Oct 04, 2011 | 2008 Dodge Grand Caravan

1 Answer

97 nissan quest gxe won't start, engien & rotor turns

pressure should be 40 psi. change pump in tank if bad.

go here for help

May 31, 2010 | 1997 Nissan Quest

1 Answer

2006 malibu, the is shaking gas no power the

start by checking fuel filter, then spark plugs, wires, and the coils, if these are good then it will run fine.

Dec 22, 2009 | 2006 Chevrolet Malibu

1 Answer

Nassin navrar d22

Probably dirty fuel

Oct 03, 2009 | 2005 Nissan King Cab

1 Answer

99 vr6 eurovan engien dies when hot but minits

sounds like its the water pump needs changeing

Aug 14, 2009 | 2004 Volkswagen Eurovan

1 Answer

2007 acura mdx - engiene seems like its over reving. When I accelerate the engiene sounds strange like the power is reving the engiene but not resulting in more power.

sensor fault but which one ?? or could be a fuel pressure problem.You will need the dealer to plug it in because engine management is now classed as security to prevent theft ?? so software is encrypted

Aug 02, 2009 | Acura MDX Cars & Trucks

1 Answer

Engien wont start!?!

You might need a new starter or a new alternator. Get it checked at a shop to make sure you find the right thing that you need to change.

Oct 23, 2008 | 1984 Ford Mustang

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

10 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides