Question about Cars & Trucks
When changing gear I get excessive engine revs
Posted by Anonymous on
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Suzuki, 00 Grand Vitara 2.0
escudo 2.0 V6, the idle is ok and the rpm quite ok, but smoke is so heavy when start in the morning, it dosent run smooth. can you help me to, i already change the spark plug but same stoyr, any solution?
Posted on May 09, 2009
If it's hard to get into gear you should check the clutch is disengaging properly.
Before changing the clutch plate, check that the clutch throw-out is adjusted correctly and the actuating hydraulics/levers have the correct amount of travel.
Posted on Oct 11, 2009
P0505 means the whole Idle Control system, not only the IAM. Check all related sensors (i.e. crankshaft sensor). Check with a voltmeter direct at the connector of the IAM if you get any signal. Remove the IAM from the TB, connect him, let someone switch your ignition key to ON. The IAM need to drive in/out for a short time to find the right position. Hold the IAM near a hard part, that they cant drive out completely! If IAM works fine, check the fuel pressure, check and clean your TB ( if not done yet). If that doesn't work, come back again please
Posted on Oct 27, 2009
Tips for a great answer:
Jan 16, 2017 | 2007 Suzuki Grand Vitara
Feb 29, 2016 | 2006 Suzuki Grand Vitara
Jan 03, 2014 | 2003 Suzuki Grand Vitara
Feb 21, 2013 | 2007 Suzuki Grand Vitara 4WD
This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve but always run a OBD2 fault code as well as the cleaning procedure. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control
Oct 25, 2012 | 1999 Suzuki Grand Vitara
Jan 18, 2010 | Suzuki Vitara Cars & Trucks
May 24, 2009 | 1999 Suzuki Vitara
Nov 08, 2008 | Suzuki Vitara Cars & Trucks
Aug 09, 2008 | 1999 Suzuki Grand Vitara
39 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: