Question about 2000 Acura TL
When ever I put my Acura 1999 TL in park it gets stuck I can't get it to move out of park nothing works it won't move.
Are you on flat ground? are brakes free of ice. and wheel not stuck
against a curb? if on flat ground release hand brake, to make this more easy. if on a hill, say so and post. for answers.
this is a feature,,,, (it's failing.) and runs off brakes.
its called the PARK lock out , feature, most older cars
have bypass port, on the console, new cars this idea is illegal.
this is covered in you operators guide, lost that?
the console has either a hidden or side port, a cover of sorts.
or has a key slot that is for Bypass. All A/T owners must learn to use this , so when this happens you are not stranded, RTM
yes, read the manual, see the page on starting a A/T car?
this is just one fail path there are others.
the shifter release botton.
the tranny dont want to exit park (inside)
the cable is seized.
some have a cable to the ignition switch, that can fail.
if the bypass fails, then post. for steps to isolate true case.
Posted on Feb 15, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: blower motor for a 1997 acura tl
one of 2 places either under the dash behind the glove box or under the hood on the passengerside. first i would check the fuse and or fan motor relay. these are located in the box under the hood or under the dash on the drivers side. also i would check the reostat which controls the fan speed this is located near the motor and is held in place by 2 screws and has 2 wires hooked to it. one more thing to check is to make sure the switch is still good
Posted on Aug 29, 2008
You can turn off the Check Engine light by either disconnecting the battery or by using a code reader to clear the codes. However, if the problem still exists it will come right back on. Instead you should get the code read, find out what the problem is, and fix it. Your local autozone or checker auto parts store will read them for free.
Posted on Dec 31, 2008
Below are the proper steps to removing your vehicle's fuel tank..
Disconnect the negative battery cable.
Relieve the fuel pressure
Remove the rear seat cushion.
Remove the plastic grommet from the floor pan.
Detach the fuel pump electrical harness.
Disconnect the fuel lines from the fuel pump by compressing the tabs on both sides of each nylon push connect fitting and easing the fuel line off of the fuel pump.
Raise and safely support the vehicle securely on jackstands.
Remove the muffler mount.
Remove the heat shields.
Remove the fuel tank cover.
Remove the drain plug and drain the gasoline into a approved container.
Disconnect the fuel lines and remove the fuel filter and base.
Loosen the fuel tank filler pipe clamp at the fuel tank.
Support the fuel tank using a hydraulic jack and a block of wood or other suitable device.
Remove the two fuel tank support strap bolts and position the straps out of the way.
Partially lower the fuel tank to access the fuel tank filler pipe vent tube and disconnect the vent tube and filler pipe from the tank.
Disconnect the fuel vapor tube from the tank.
Lower the tank from the vehicle.
Installation is the reverse of the removal procedure.
Posted on Apr 23, 2010
Tips for a great answer:
Jan 08, 2016 | 1998 Acura CL
Apr 05, 2014 | 2004 Acura TL
May 17, 2017 | 1998 Acura TL
Jun 27, 2012 | 1999 Acura TL
Jan 21, 2011 | 1999 Acura TL
Dec 29, 2008 | 1999 Acura TL
Oct 21, 2008 | 1999 Acura TL
142 people viewed this question
Usually answered in minutes!