Question about Cars & Trucks

1 Answer

Power steering hi i have a saab 95 year 1999 when turning all the steering till the end the rpms drop and oil light turns on. either engine oil and steerng are at level. while driving nothing happens, and if light goes on, the moment i accelarate or release the steering light goes off also. any suggestion? thanks

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Renaissance:

    An user who is expert in 3 categories / brands.

  • Cars & Trucks Master
  • 803 Answers

Possible fault areas; oil pressure sender not accurate,
low oil pump pressure output,
RPM dropping below 300rpm under load,
computer not compensating fast enough,
dirty throttle body,
oil viscosity too thin,
I would probably start with an oil change going with a thicker grade especially if you have high mileage.

Posted on Feb 15, 2014

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 6 Answers

SOURCE: saab 95 headlights dont work high work and drive lights stay on

IF THE BULBS ARE OK CHECK THE HEADLIGHT MODULE(IT LOOKS LIKE A RELAY, ORANGE CASE I THINK) TRY WIGGLING IT,IM PRETTY SURE THATS IT. THEY GO BAD ALOT ON SAABS. IT SHOULD BE IN THE ENGINE CONPARTMENT

Posted on Jan 30, 2009

jgwhomeequip
  • 1902 Answers

SOURCE: Oil Pressure Warning light

Sounds like possiblity of the oil pump being bad, and is setting off other sensors on your car.

Posted on Feb 10, 2009

  • 17 Answers

SOURCE: oil light comes on under deceleration.oil levels are fine

I would guess your oil pump is going out causing it to loose oil pressure. If you continue to drive your car in this condition it will most likely ruin the engine. If it is not your oil pump it is something else causing you to loose oil pressure and I would have it looked at soon.

Posted on May 23, 2009

  • 521 Answers

SOURCE: Oil light in 1999 Toyota camry comes on when idling.

bad to worn out oil pump or excessive oil passage clearances that allowing more oil to pass thru them at a lower pressure due to the bigger opening. It can be a sign of an emminant engine failure due to oil starvation.

Posted on Aug 04, 2009

  • 2 Answers

SOURCE: 2004 Saab 9-3 key STUCK in central console ignition - car

try disconnecting the battery briefly and then reconnecting it. I had this happen to me on my 04 9-3

Posted on Jan 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Saab 2001 95 the oil light flickering after driveing 60 miles and i have\r\noil in it.


This is an known issue with this engine. The Oil pickup screen is clogged from using non full synthetic oil and / or not being perfect with oil changes. a sludge builds up and clogs the oil pump screen starving the engine from oil. If you continued driving it after the oil light came on you likely need a new engine. Otherwise you need to have the oil pan dropped and the screen cleaned and the engine checked out for damage.

Nov 12, 2010 | 2001 Saab 9-3

2 Answers

My saab 95 won't start I think its the Direct Ignition how can I check it


Need year and 4 or 6 cyl. Assuming 4 cyl, need to know year and miles. Is the check engine light on? Easiest way is to swap out. Have to be careful with the DIC. Must be attached to plugs, must be upright. Could get 4 plugs, make sure it is up right and attached to computer. See if there is spark. Usually foul electrical smell if DIC fails. Also could be CPS (Crank Shaft Positioning Sensor).

Jul 18, 2010 | 1999 Saab 9-5

2 Answers

Car won't start. It turns, but doesn't start.


If you tolk about camshaft position sensor-YES.Located on a back side of the engine , next to the gear box.Have metal cover .Use diagnostic equipment to find the problem or code reader.I also had the same problem in my SAAB 95.In 6 monts time I have change two sensors.Made in China

Apr 28, 2010 | 1999 Saab 9-5

1 Answer

Po444 code for 1999 saab 95 se. 3.0 engine


The code is....
Evaporative Emission Control System Purge Control Valve Circuit Open

Nov 06, 2009 | Saab 9 5 Cars & Trucks

2 Answers

I have a check engine light and I am reading two codes P1171 and P1181. I have a 1999 95 SAAB


Don't know if it is any help but I had the same problem and it turned out to be the intercooler hose was split and sucking air. Fixed it and know problem now.

Jul 03, 2009 | 1999 Saab 9-5

1 Answer

Power steering pump failure


there may have been air trapped in the power steering system. Keep a close eye on the system & your oil. Make sure your not leaking (wrong filter etc.)

Apr 09, 2017 | 1999 Saab 9-5

1 Answer

Saab 95 headlights dont work high work and drive lights stay on


IF THE BULBS ARE OK CHECK THE HEADLIGHT MODULE(IT LOOKS LIKE A RELAY, ORANGE CASE I THINK) TRY WIGGLING IT,IM PRETTY SURE THATS IT. THEY GO BAD ALOT ON SAABS. IT SHOULD BE IN THE ENGINE CONPARTMENT

Jan 30, 2009 | 1999 Saab 9-5

3 Answers

My saab 95's reverse lights are not working


probally the reverse switch,on the trans,check wires or switchand rear globes

Jan 06, 2009 | 1999 Saab 9-5

3 Answers

Saab 95 1998 - wont start


The most common problem is the Direct ignition cassette, followed by the crankshaft position sensor. I am assuming that it cranks, but won't start.

Dec 26, 2008 | 1999 Saab 9-5

1 Answer

I have a 1999 Saab 93. When I am trying to turn there is a noise coming from the steering (I guess). Yesterday I saw a leakage of fluid. What is going on?


the hidrolic pump for your power steringing has a warn seal and this might have to be changed. you might to feel simtoms of stiffness in the turning of the wheels. is had this same problem a while back . but just make sure the level of the power stering fluid is kept toped up till you fix if.


Jul 16, 2008 | 1999 Saab 9-5

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

83 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...