Question about 1995 Honda Odyssey

1 Answer

When I start my odyssey it starts surging. I found a small rubber hose on the right side of the engine, but don't know where the other end of the hose goes....Help

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 20,706 Answers

WHAT COUNTY???????????????????????????????????
hot engine, cold or both?/// a key question
WHAT ENGINE: ( usa list , ONLY)
2.2 L F22B I4
2.2 L F22B6 I4
2.3 L F23A I4 2.3 L F23A7 I4
the fsm covers this. hose thing.... all hose can be followed,
unless its axle vents on 4wd cars. (they go no where, special)
is surging the only symtom.?
no engine stalls.?
lack of power in any gear or hills.
no misfiring?
no flooding.?
starts easy/?

ok what is surge, that it really is idle controls bad or out of comtrol
1: idle controls bad. (isc dead?)
2: or engine is running way too lean, and ISC cant keep a grip on idle.

easy huh?
and #3 misfiring so bad the idle controls fail.
are all fuses good?
is the CEL lamp glowing , then goes out running engine.
no , the scan it. or do the flash DTC codes trick.

a good tech ,first finds out if the engine holds closed loop status
hot. at idle, if not, he fixes that first.
as he/she knows that idle is the last thing to work right, in EFI.

one other way to get surge is air leaks (aka. vacuum leaks)
if the engine (unsaid option) is MAP based, it will race fast
with any vacuum leak, and it dont take much of a leak
to make the ISC idle controller go nuts.

so repost , hot/cold both questions
and actual RPM numbers. we need numbers
is the dash Tachometer missing. ????
and what engines in car.

all lean engines surge.
all ISC systems can surge if out of control , not all do this. just 1/2
if the ISC surges, it means its trying hard to gain back control.
this is called a software servo loop.
The ECU is programmed to hold rpm near say 800 RPM hot.
and is very digressive in that role.
I have a 91 car that will surge, with any vacuum leaks.
(by design) depends on which engine.

Posted on Feb 15, 2014

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Stiff brakes


Sounds like the power brake booster is bad, that is what the master
cylinder is bolted too. There is a rubber hose that has a plastic valve
in it were it snaps into the booster, Pull that rubber hose out of the
booster and off of the engine, Now the end that you took off the engine.
You should be able to suck through the line, but not be able to blow
through it. If you can then replace the valve, It is a one way valve.

If that is all right then hook hose back up to the engine and start
engine, You should hear a major vacuum leak at the valve end, put you
finger over the valve and it should stop making noise and engine should
smooth out. If it don\'t the rubber hose must be leaking or the tube on
the engine were the hose hooks to is stoped up.

Jun 19, 2013 | 1985 Cadillac Seville

1 Answer

Small z or s hose by fire wall on passender side. I don't know where to connect the other end to?


Not the air-conditioner drain hose,is it? They usually have a pinched end to keep dirt and insects out. don-ohio

Oct 08, 2011 | 1999 Cadillac DeVille

1 Answer

I have a 2001 ford winstar mini van, I drove it about 700 miles on a vacation, I parked the car at my sister's house it sat for about 4 hours, then started to drive for another 2 hours. I noticed some...


There are 2 cooling hoses that go to the radiator from the transmission. Hopefully it's one of these. The hoses are at the front of the vehicle or the right side standing in front of the vehicle. the stretch across the front to the left side. They are mostly metal ,but there is some rubber hose to it. The hoses connect to the radiator on the left side at the top and bottom of the radiator. If the hose blew out you can fix this with some new transmission hose. You will need a tube cutter, two hose clamps,a screwdriver, a razor blade/knife and 2 feet of hose just to be safe. Cut the metal tubing on each side of the rubber hose, cut enough new hose to go in it's place and use the hose clamps to secure it. If for some reason the metal tubing is bad,rust, you can do the same thing.

Jul 04, 2011 | 2001 Ford Windstar

1 Answer

2002 ford ranger starts cold. will idle fine but dies after i rev it up, then will not start again. replaced plugs, plug wires, and battery.


When the engine is idling, listen very carefully to with the hood open for something that sounds like rushing air. There might be a vacuum leak on the engine (all you need to do is make sure the vacuum hose is tight). This should be a rubber hose that plugs onto a hose barb or into a small hole in the engine. There is a piece call the pcv valve that you probably need to replace if you don't hear any air leaks.

Jun 09, 2011 | 2002 Ford Ranger Regular Cab

1 Answer

When I start the car it runs fine but when i put it into gear it dies and i have to restart the car. Right before this when I applied the brakes the car would jump ahead instead of stopping.


Sounds like you may have a vacuum leak. You need to look closely around the carb/intake area for any disconnected small rubber hoses. Also check a fat rubber hose (1 inch or so) which goes to the big drum looking thing drivers side firewall - part of the brakes power booster system.

Look for hanging loose tubes/hose or worn through by rubbing etc.. Try to replace tubes to closest point where it looks like it goes. May have to cut a small peice off the end if it's stretched out and loose fitting.
Hope this helps

Apr 10, 2011 | 1990 Oldsmobile Eighty Eight

1 Answer

Hyundia sonata glx auto 1997cc. 1996 model year. approx 53000 miles Engin starts and reves up to about 2000 + rpm then after a short time may be a miniut drops back to 900 to 1000 but surges to 1500 every...


the surge is caused by a high idle situation where the computer pulls it down but it goes back up again,hence the surge.Hopefully it is just pure bad timing that it played up after the brakes being done as nothing needs to be disturbed by it.One came into my shop like this and the idle air bleed had been tampered with.this is located on the throttle body(this is where your accelerator cable goes to).It should have a black rubber plug in it about the diameter of an aaa or aa battery end.remove this(some are already missing),inside this is a flat screw type head.Using the right size screwdriver slowly turn this clockwise while the engine is running in park.You should only have to turn this 1/2 to 1 turn in to alter the idlespeed.if no change or it slows then surges again,we will have to check some other areas.Also check your coolant level in your radiator,as these have 2 small hoses that feed coolant through the throttle body,this can give same symptons.There are a few other things to check but at this stage just check these 2 items and of course look for any hoses or sensor plugs that are not on,or any loud hissing of air escaping anywhere.Hope this helps.

Mar 22, 2011 | Hyundai Sonata Cars & Trucks

2 Answers

Where is the thermostat on a 1995 Honda Odyssey?


Check where the top radiator hose comes into the rad.Trace it back to the motor, it should be right there at that end of the hose. Because when the vehicule heats up, the thermostat opens up and the top rad hose gets warm to the touch. Some cars have them turned on the side instead of horizontal.

Feb 12, 2011 | 1995 Honda Odyssey

1 Answer

2002 Nissan Frontier. Vacuum problem


jjgabrovic,

The windshield washer hoses have nothing to do with any electical componenents on the car. You simply won't get water to the windshield.

I suggest locating, and purchasing if necessary a repair manual for this truck. These newer engines have so many wires, and hoses and can be hard to trace.

All vaccum lines start from the engine area, tranny area, and lead to the firewall (back) and other compenants.

Start looking at different compenants that have small rubber hoses and try to trace them as far as you can. Search top and bottom, front and back, side to side. These hoses are sometimes linked with others by T's, and V's and such as vacuum operates several different components at once from one source.

I highly suggest getting a repair manual; CHILTON is the best, as it is more details and descriptive, and provides clear pictures to show particular components and such.

Please, let me know if you need any further assistance with this matter.

Cordially,

carsandcomps,

Guru, Premium Expert @Fixya.com

Apr 25, 2010 | 2001 Nissan Frontier Crew Cab

1 Answer

2006 Honda Odyssey Hot Air on driver side, cool air on pass. side


The only thing I can think of other than the AC control unit being bad is the small tube under the drivers right knee. If you look down at your right knee you will see a small area that is vented. There is a hose hooked to this vent that pulls air from inside the cabin to tell the ac what the temp is. If this hose is off or pinched the ac unit is not getting the information it needs in order to run correctly. Hope this helps.

Aug 04, 2009 | 2006 Honda Odyssey

2 Answers

1998 grand cherokee drivers floor keeps getting soaked


first, when I read your post I remembered that if the ac drain hose (small hose stub on the engine side of the firewall, usually on the passenger side) gets plugged this can happen. If that doesnt fix it, get a friend to spray with a hose and start looking for where the water is entering the cabin. Leaks are a real pain to find, even for shops, so don't get discouraged if it takes a while to beat this!

Dec 13, 2008 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
1995 Honda Odyssey Logo

280 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8172 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...