Question about 1994 Toyota Camry

1 Answer

Hard vibration at or below 1,000 rpms,changed motor mounts,serviced transmission, ran compression check and engine strong.

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Toyota Master
  • 20,706 Answers

That is called MISFIRE.
it is caused by 50 things, (misfire and flooding)
why guess.?
vibration parked?
vibration racing in neutural?
hot or cold engine or both.?
only moving , ? at what speed, what gear, is it autotrans or sticK shift.
a mech sees all this in 5min flat, me never.
making me blind.
see, and anyone else too. id bet.

Posted on Feb 19, 2014

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 205 Answers

SOURCE: Excessive vibration of the steering column

Sound more like out of balance tires, or bent wheel. Unless this vibration is even in park. Then I would say something is up against a part of the steering that shouldn't be.. Or your exhaust system is bent or touching part of the undercarriage that it shouldn't be. Was the car ever wrecked?

Posted on Mar 28, 2009

MauiRentaCar
  • 288 Answers

SOURCE: Car trembles while on Drive as soon as one halts by applying brakes

The most important engine mount for reducing vibration is the right front engine mount, which attaches the timing belt cover to the inside fender. Make sure this one has been replaced. The result is very noticeable. If defective or cracked, this mount can be difficult to diagnose visually, so usually it will still look ok even when it is not. In many cases I've seen mechanics replace only the front mount which is under the radiator - usually this does not give any appreciable reduction in vibration. The rear mount and left mount can reduce vibration a little bit further, especially when the car is in reverse. However the right front mount will usually take out 99% of your vibration. This is usually one of the first things I get done when overhauling a car for my rental fleet to Toyota Corollas.

Frank
Frank's Friendly Cars Maui Car Rental
www.MauiCarRental.biz

Posted on Aug 30, 2009

  • 347 Answers

SOURCE: 2000 toyota corolla ce motor trembling when on drive holding down brakes.

check the brake disks. surface should be cleaned. also check the brake pads.

Posted on Sep 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 2004 Mazda tribute has started shuddering in all gears, not contuously but seems when it drops below the 2 on rpms. Had just had it serviced and oil changed 2 weeks ago


Did you have the motor oil changed or the transmission oil? Your check engine light should be on and you should have it scanned by a professional. Did it start to shudder immediately after the service? Its very hard to tell without seeing the car to diagnose myself.

Mar 09, 2016 | Mazda Cars & Trucks

2 Answers

Hard engine vibration in toyota 2.2 engine at 1,000 rpms or less


run fault codes and look for misfiring cylinder. Vibrations are from engine misfires normally consistent with one cylinder . IT may be spark or HT lead or a faulty injector

Feb 14, 2014 | 1994 Toyota Camry

2 Answers

It takes several try to run my suzuki van f6a automatic transmission and after running in the idle speed the engine is vibrating for several minutes before running normal. Many thanks


you might have a broken motor mount or ****** mount,as for the overheating you might need a new thermostat or water pump,but check your antifreeze first to make sure its strong enough for this time of year

Jan 19, 2013 | Cars & Trucks

1 Answer

2006 galant vibrates badly at idle


how many miles on it? how long have you had it? it sounds like the ICS sensor . that is idle control actuator it is on the thottle body

Oct 30, 2012 | 2006 Mitsubishi Galant

3 Answers

Why does a 2006 Ford Fusion have a strong vibration when stopped and in Drive?


If there are no check engine lights could be a bad motor mount or two. Would have them checked. Try putting car in neutral and see if vibration disapates a little.

Aug 23, 2012 | 2006 Ford Fusion

3 Answers

I believe that I have either a bad transmission mount or mounts, and possible a bad motor mount or mounts because the car vibrates in drive while running and also vibrates in neutral while running but not...


Get a friend to open the hood and look at the engine go up or down in the engine compartment when the brakes are firmly applied and switching between reverse and drive. Look for the motor mounts for behavior where tears exist in the rubber.

Nov 09, 2011 | 2003 Dodge Neon

1 Answer

Whn i push on the gas the car shakes have replaced the tires so i knw they are not the problem, the faster i go the worse the car shakes... could it be the engine or transmission?


There are a bunch of possibilities that it could be, so you will have to better diagnose this before spending money on repairs.

The car shaking can be from a long list of faulty or worn equipment.
1. Check the wheel balance. Your wheels can make your whole car vibrate if they are not balanced.
2. Check your wheel bearings. (Both 1, and 2 will increase with the speed of the car, not the engine.)
3. Motor and Transmission mounts (This will usually be with the RPMs of the engine)
4. CHeck your brakes.
5. You may need a transmission service too. (sometimes a fluid change will iron everything out)

Enjoy.

-Jackson
http://urbanscooters.com/

Oct 11, 2010 | 2004 Pontiac Grand Prix

2 Answers

WHAT IS MAKING MY 04 NEON VIBRATE SO MUCH??? ITS WHEN EVER I HIT THE GAS IT VIBRATES LIKE A CHEAP HOTEL BED!!! PLEASE TELL ME..I THINK IT MIGHT BE THE MOTOR MOUNTS OR TH HALF SHAFTS...


It's your motor & transmission mounts - relatively inexpensive.
Here is where you can get all 4 mounts for your car - AUTOMATIC transmission: http://dodge-car-parts.yogiautoparts.com...11_17_2012_8_13_31_pm.jpg
If you feel like reading, here is a bit of information about the function of these mounts on a car:

The purpose of engine motor transmission mounts: Most mounts made of metal and rubber, many newer model mounts are filled with hydraulic fluid, some advance hydraulic mounts come with electronic variable speed control by ECM engine control module. The basic design are the same to support between engine, transmission and subframe. They work hard to keep engine and transmission running smooth minimizing the amount of rattling and vibration from acceleration and stops. At the same time mounts are supporting all major power train systems keeping all mechanical components in balance level and position. Motor mounts are extremely important vehicle parts that stabilize and align a vehicle engine inside the engine compartment. Although small in size and relatively cheap in cost, motor mounts can cause tremendous mechanical problems if they break or go bad. Engine motor mounts are small parts that are used to stabilize and properly align a vehicle engine. When motor mounts go bad, they can cause a variety of symptoms, ranging from mechanical damage to excessive engine noise.

Sep 27, 2010 | 2004 Dodge Neon

2 Answers

Unknown Vibration


motor mounts can be changed without pulling the motor the load percent change that the other guy posted is normal and a vaccum leak would cause the engine idle to wander when in neutral. if you need info on how to change mounts let me know

Sep 17, 2009 | 2004 Ford Focus

1 Answer

Transmission problem


The transmission is most likely going out, you need to have it serviced and checked for metal shaving in the pan, if thats present you might need the transmission serviced or buy Synthetic Transmission Fluid to put into it which can help restore it somewhat, but a rebuild kit might solve your problem

Jul 05, 2008 | 1991 Toyota 4Runner

Not finding what you are looking for?
1994 Toyota Camry Logo

93 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76109 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8270 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...