Question about Nissan Cars & Trucks

Open Question

What is the tolerance for nissan sentra 2003 for warped head

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 8 Answers

SOURCE: engine head torque settings for 2005 nissan sentra 1.8

email me ill send you it via email cant post here too bigg!!

Posted on May 29, 2009

NismoMaster
  • 146 Answers

SOURCE: torque settings for cylinder head nissan sentra

Tighten in sequence to 29ft.lbs then tighten in sequence to 58ft lbs. then loosen all bolts. Then tighten in sequence to 33ft lbs. then tighten each bolt in sequence 90 degrees then tighten each bolt again 90 degrees

Posted on Jul 26, 2009

  • 4 Answers

SOURCE: my 2003 Nissan Sentra spec v dies when idling

try replacing the crankshaft and camshaft sensers, my 2004 sentra spec v had the same problem.It cost me $122 for both the sensers and can be done in 20mins

Posted on Aug 19, 2009

CaptainHawk1
  • 345 Answers

SOURCE: Nissan Sentra reverse light not working

I would attempt to check the fuses.

Posted on Nov 28, 2009

  • 67 Answers

SOURCE: 2003 Nissan sentra 2003 gxe, had 4 yrs, no

Start the car up when it is cold and rev the engine up for 30 seconds,loosen up the radiator cap and see if there is pressure there..If there is you probably have a bad head gasket...Caution do not open cap if engine is warm...

Posted on Mar 01, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My check engine light came on three days ago and it over heated and had no water in it ,


Have a compression test done to ascertain the extent of engine damage. Head gasket---warped head---cracked head-- broken rings etc.. Manufactures put these funny lights in the dash to save you money and you ignore them at your dollar cost.

Aug 24, 2013 | 2003 Nissan Sentra

1 Answer

White smoke comes out during high speed?


Yes,Nissan's are prone to head gaskets going bad,aluminum head,must keep coolant and thermostat changed regulary.check to see if head is warped,use straight edge,if warped must be machined.Your looking at 800 to 1000 at shop.Stay away from dealer.

Feb 18, 2013 | 1998 Nissan Sentra

1 Answer

2003 nissan sentra no heat, over heating


If the engine has overheated, chances are pretty good that you now have a warped or cracked cylinder head and a blown head gasket. Those engines are very unforgiving when it comes to being overheated.

Jan 08, 2012 | 2003 Nissan Sentra

1 Answer

Nissan LEC 1994 sentra water leak problem


check your radiator if theres a bubbles while your engine runnin, if theres bubble, it means you overheat. check your cylinder head for warps... also check your fans...

May 09, 2010 | 1996 Nissan Sentra

1 Answer

Seem to have the same problem as lindag1003's with my 2001 Sentra. No heat in the car, or heat on passenger but not on driver's. Engine temp guage went above limit. Coolant was bubbling. Mechanic checked...


Parts are cheap for these cars...Problem is that labor is expensive...If you did it yourself it would cost you about 200$...Providing that the deck and the head are not warped...Tolerance is .004. If the car is still in good shape rust wise,has good compression,and not burning alot of oil,it is worth it..My advice is to find a shade tree mechanic to give you a hand ....

Feb 10, 2010 | 2001 Nissan Sentra

1 Answer

2003 Nissan sentra 2003 gxe, had 4 yrs, no problems, blows cold air only, had lines flushed to remove air, thermostat works fine, is it the head gasket?


Start the car up when it is cold and rev the engine up for 30 seconds,loosen up the radiator cap and see if there is pressure there..If there is you probably have a bad head gasket...Caution do not open cap if engine is warm...

Dec 21, 2009 | 2003 Nissan Sentra

2 Answers

Does the 2005 nissan sentra 1.8L have problems with head gasket blowing ?


Not generally, unless the engine's been run hot, if even only for a moment. If the head gasket is blown prepare for major out of pocket expenses because if the engine overheated it will bend every valve and usually warp the head beyond repair. I honestly hope this is not your problem, it's an extremely expensive fix. Hope this helps, good luck!

Sep 02, 2009 | 2004 Nissan Sentra

1 Answer

2003 Cuts off when hot, will not start untill cool


My 2003 nissan sentra would get hot and stall out even in middle of highway doing 70 mph. The guages would go up and down. Would not start up all the time after stalling. had to cool down first. Nissan said it was head gasket, and wanted to charge 1000.00 for the job. I took to local dealer who charged me 550.00. Works fine ever since. Nissan dealer said they do like 3 head gaskets a week on the sentras. They have crappy ones in original parts. They have not recalled though.

Jul 10, 2009 | 2003 Nissan Sentra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Nissan Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Phil Lovisek
Phil Lovisek

Level 3 Expert

705 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a Nissan Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...