Question about 2004 Mazda 6

Open Question

Window goes down about 4inches then gets stuck pullthe window up then it will go up it gets to the top then makes a poping nose

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 3.3 L stuck lifter


I'm pretty sure this is an overhead cam engine. More than likely, the cam lobe is worn down ,or the rocker arm is worn down, or the valve is worn down. The oil pump may be going also and not supplying enough pressure .

Feb 17, 2013 | Chrysler Town & Country Cars & Trucks

1 Answer

Lockmechanism


possible latch became diconnected in door , do you hear lock activate
when unlocking or locking door to see if motor is working ,did you try using manual lock button should move up and down,try this while using power locks ,it may be just stuck,

Oct 02, 2012 | 1999 Ford Expedition

1 Answer

Drivers window wont go up or down properly and makes a funny noise


The teeth on the arm might be stripped or the window motor might be dying. You will have to take off the door panel to see.

Oct 21, 2011 | 1999 Subaru Forester

1 Answer

2003 audi a4 cabrio top wont open. thinking the trunk piece doesnt drop down as it should


Before anything you have to make sure the lever in the trunck is in the correct position. Assuming it is...

...does the top start to open or it doens't even move? Does the hatch where the top goes into start to open? If so, stop the top after you see that the hatch has completely opened, then manually push that piece down. Be carefull not to get stuck and make sure nobody is operating the top while you're attempting this so you don't get your arm stuck there for any reason.

You could also try to access it from the truck and pull it down manually. I may just snap back into place and the problem will go away. On my car, one of the sides was stuck UP and the other was working. Once it snapped back into place it works every time.

Oct 02, 2010 | 2003 Audi A4 Cabriolet

1 Answer

How can you tell if you have a bad theromast


First you need to see if the engine is overheating or if the engine is running cool. The job of the thermostat is to maintain a set operating temp, usually 190-200 deg f. If it overheats everytime it is ran then your thermostat may be stuck closed. If you start it up and it heats up to like 220 deg and then goes back down to 190 that tells you that the thermostat is sticking closed and poping open when its really hot. If you cant get to 190 deg f that means that the thermostat is stuck open.

Mar 07, 2010 | 1998 Cadillac DeVille

1 Answer

1987 jeep yj 6 cyl manual trans. New fly wheel, clutch, presure plate, and batt. Starter is one month old on old worn flywheel with bad ring gear. Inspected starter gear before reinstalled on the new fly...


check to make sure the starter is seated correctly to the bell housing also check for a cracked! nose cone on the starter as well and make sure the front nose casting bushing isn;t worn out and make sure they sold you the correct tooth count flywheel

Jan 19, 2010 | 1987 Jeep Wrangler

2 Answers

I have a 1994 jeep grand cherokee and the left passenger window has been "stuck", in the up position, for some time. Today, my daughter hit the power button and the window went down. Unfortunatly, it won't...


sounds like a loose wiring around the switch. take off the door panel accesorys untill u get to the switch panel check the connections and if good and problem persists then install another switch

Jan 06, 2010 | 1994 Jeep Grand Cherokee

1 Answer

2003 rondezvous stuck in reverse. so put it in emergency brake and turned off engine in driveway. the gearshift moves up and down but it never goes out of reverse. when moving the gearshift forward it goes...


the linkage might have popped off the tranny must of those are on a ball socket, if you open the hood and find the cable that goes to the transmission. and you will most likly find that it popped off. if you have someone in the car when you are ready to pop it back on have them move the shifter until in the right spot and then push it back on. if it keeps poping off you will have to replace the cable.

Nov 23, 2009 | Buick Rendezvous Cars & Trucks

Not finding what you are looking for?
2004 Mazda 6 Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mazda Experts

yadayada
yadayada

Level 3 Expert

74896 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7689 Answers

Are you a Mazda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...