Question about 2009 Nissan Cube
Got fuel? Sounds crazy but you'd be surprised how many times I have poured a gallon of gasoline into someones car to get it to start.
No start condition is the most frustrating problem. More information on what happens when you turn the key would help......but basicaly you need 4 things to make a car start. Fuel. Air. Spark. Timing. - oops - 5 things - A key! Sure you are using right key? Had a couple once who had matching chevys and they swapped their keys and didn't know it. The key has a chip in it and only works on that car. Crazy, but the keys fit and turned in both cars. (Almost matching serial numbers? never figured that one out). Anyway, sorry. Fuel, Air, Spark and Timing are needed to start/run. Asked about fuel, but is the fuel getting to the cylinder? Do you have fuel pressure at the fuel rail(s)? When you turn the key to the "On" or "Run" position, do you hear a whining sound coming from the rear (fuel tank area)? That is your fuel pump priming the system. No sound? Check fuses and relays associated with the fuel system. Air. You need air to the cylinder to make it start and run. Check your air intake and filter. Really clogged and dirty filter? Pull it out and try to start. No go? Put it back (change ASAP) and look for Spark. Spark includes battery. Are there any loose connections to/from your battery? Really corroded terminals? Clean and tighten the connections. Try to start. No go? Pull the spark plug wire off an easily accessible spark plug (grasp the "boot" as close to the plug as possible and wiggle back and forth easily while pulling - these boots and wire connectors are fairly delicate). Remove the spark plug (be careful and dont break it or cross thread it when putting back in) and pop the wire back on it and set the plug on top of your engine (away from the spark plug hole). Have someone try to start the engine. You should see the spark plug fire its tiny bright blue spark. If not, you have found your problem. The problem is likely a bad coil, bad coil wire, distributor cap, rotor or a combination of these. If you have spark, then it has come down to timing. There are lots of things that affect timing in modern cars. There are a couple of sensors that jump out - Crankshaft and Camshaft position sensors. These will generally quit working while driving and you will likely notice the problem beforehand with it running really rough and getting crappy mileage, and the check engine light will come on and give you all kinds of hints. IF you turn the key and nothing happens, it might be a broken timing belt, but again, those usually fail under working conditions. It is possible (rare) the timing belt slipped/broke when you last shut off the engine, but I would point at the other 3 things first (Fuel, Air & Spark). Hope this helps. Good luck..
Posted on Apr 22, 2014
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Tips for a great answer:
Aug 19, 2017 | Nissan Cars & Trucks
Jan 11, 2017 | 2009 Nissan Cube
Mar 15, 2016 | Nissan Cube Cars & Trucks
May 26, 2014 | 2009 Nissan Cube
May 26, 2014 | 2009 Nissan Cube
Apr 22, 2014 | 2009 Nissan Cube
Feb 14, 2014 | 2009 Nissan Cube
not starting or turning over indicates towards multiple possibilities. It can
be issue with battery or weak battery. But if battery checks out ok, then it
can be starter issue or faulty alternator or problem with low fuel pressure or
no spark at spark plugs due to dirty spark plugs or faulty ignition
coil or injectors getting cracked or dirty and needs to be cleaned.
confirm the problem, the basic troubleshooting is required.
this link below and follow the troubleshooting:------
This will help.
Feb 19, 2012 | 2009 Nissan Cube
159 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: