Question about Cars & Trucks

Open Question

Instruction Manual AG12 ford smith hoist - Cars & Trucks

Posted by Anonymous on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My Manuel 95 ford probe is stuck in 5th gear and shift knob is in the neutral position , any ideas ?


Hi Chris:
If you can get at the linkage and pull it back into neutral it should function for a while.
I found that on older vehicles with manual transmissions the "gates" in the linkage shift assembly got worn so that when a fast shift was attempted, the shift knob (lever) would move, but the pin connector would slip out.
Be safe. Work off a hoist or have the vehicle on jack stands so that you can safely get at the transmission where the linkage levers are attached.

Sep 18, 2015 | Ford Cars & Trucks

1 Answer

How many hours to pull and replace engine on a 2001 ford focus


With the proper tools (i.e hoist, engine hoist, etc...) you should allow a day for this. Unhooking hoses, wiring, cables, etc...takes time. Be sure to tag or write down where everything goes in case it takes more than a day. Also, TAKE PICTURES of everything under the hood before you do anything.
The hours it will take will depend a LOT on your experience doing a project like this. It could take DAYS if you break bolts, etc... or don;t have the proper tools for the job. Be sure to have someone else there as there will be times when you need an extra pair of hands..
Good Luck

Jan 02, 2015 | Ford Cars & Trucks

1 Answer

Front wishbone replacement 1999 ford focus 1.8 petrol


Im not sure if you have Haynes repair manuals in Europe but buy a repair manual and you will need a hoist and air tools

Sep 18, 2013 | 2001 Ford Focus

1 Answer

Need the diagram for a 1996 Ford Explorer , need too change the freeze plug in the back of the engine its leaking water


you can access a manual at you library or you parts store some freeze plugs are hard to get at you should have a hoist the removal and replacement procedure is important you may want to hire this done

Sep 17, 2012 | 1996 Ford Explorer

1 Answer

Water Pump Replacement Instructions on a 07 ford edge 3.5 . where can i find this info at thanks


Unless you got a hoist DO NOT DO IT! The entire powertrain has to be removed.

Sep 04, 2011 | 2007 Ford Edge SEL Plus

1 Answer

How do you take a motor out of a 1998 ford escort ls?


first get a manual, you will need a hoist, an engine lift, a good tool box, and time, you will have to be able to get underneath with room to spare, and make notes of all parts as you remove them

Dec 18, 2010 | Ford Escort Cars & Trucks

1 Answer

How to install new clutch


This is way beyond typical owner maintenance. Go to ebay and buy yourself a repair manual for the car, it will cost less than a tank of gas. You will need a lift or a hoist to pull the engine and transmission out, and a good selection of tools. There will be step by step instructions and photos in the manual

Nov 23, 2010 | 2000 Suzuki Esteem

1 Answer

How do you change the transmission fluid on a 2002 ford explorer, v8


Look on pages 269 and 270 of the owners manual.

Checking and adding manual transmission fluid (if equipped)
1. Make sure the vehicle is on a
level surface or level hoist.
2. Clean the filler plug or dirt and
debris.
3. Remove the filler plug and
inspect the fluid level.
4. Fluid level should be at bottom of
the opening.
5. Add enough fluid through the
filler opening so that the fluid level
is at the bottom of the opening.
6. Install and tighten the fill plug
securely.
Use only fluid that meets Ford specifications. Refer to the Lubricant
Specifications in this chapter.

Nov 13, 2010 | 2002 Ford Explorer

1 Answer

I need to replace my Cigar lighter (I belived that is what Ford calls it). I would like to know how to do this. I have a new one to install just not sure how to go about it.


Hi...
On the back side of the socket there is one wire. Remove this wire by carefully pulling it off the connector. The back of the lighter socket will unscrew from the lighter well. Should be a standard right hand thread. go to parts store and buy a new replacement part comes with directions and installation instructions.

Thanks for using fixya
Smith

Jul 26, 2009 | Ford Escape Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

84 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...