Question about Cars & Trucks

1 Answer

Starting problem my 93 ford ranger is having a starting problem only when u get in it with the engine cold the fuel pump sounds like its stays running it idols rough in gear and in park

Posted by on

Ad

1 Answer

  • Level 1:

    An expert who has achieved level 1.

    MVP:

    An expert that gotĀ 5 achievements.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that hasĀ over 10 points.

  • Contributor
  • 24 Answers

Change fuel filter. Check fuel pump in tank.

Posted on Feb 14, 2014

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 58 Answers

SOURCE: 1992 ford ranger 3.0

i was once pulling a trailer with a ranger when it suddenly lost power and the engine died. turns out the problem was with the fuel shut off inertia switch. the switch is supposed to activate in case of accident. on my model the inertia switch is located in the passenger side under the glove box. dont know where yours is located. once you find it, just push the button and see if it resets. good luck.

Posted on Sep 26, 2008

michigan man
  • 3533 Answers

SOURCE: Truck Won't Start At All

before replacing the starter get a volt meter and test the voltage coming out of the voltage regulator which the power comes from the battery to the regulator down to the starter also make sure all wires on the starter are clean and what I mean is from rust because I had an f150 that did the same thing

Posted on Jan 09, 2009

  • 651 Answers

SOURCE: 1992 Ford Ranger XLT V6 wont start without ether

first go to an auto partstore and have the code checked. most do it for free. could be coil, fuel pump, fuel filter, air filter or even a bad gas cap. but the dianogstic test should pin point the problem.

Posted on Jul 01, 2009

  • 83 Answers

SOURCE: i have a 2001 Ford Ranger extra cab. v6, 3.0 auto.

You may have a bad idle control valve. If you want to replace fuel pump yourself you will have to remove bed of truck or fuel tank.

Posted on Aug 26, 2009

bhshark84
  • 5 Answers

SOURCE: 1991 ford ranger stalls when in gear...

if it runs fine in park and neutral and stalls in gear it sounds like your torque converter is staying locked up which would make it stall when you put it in gear. the torque converter connects your engine to the transmission, and should only lock up (like a releasing the clutch on a standard shift) at crusing speeds to help fuel economy, a quick and dirty way to tell is to remove the drive shaft and start and run the truck and put it in gear with the drive shaft completely removed, and if it stays running then you know it is in the torque converter.

Posted on Sep 18, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ford ranger 1996 4.0L v6 single cab long bed it runs but you have 2 have your foot on the gas it does not stay in idle for more than 5min less than that usually it does not take much gas pedal pressure to...


I would suspect that you have a failing fuel pump, the fuel pump pressure is bleeding off due to a faulty check valve, this causes hard starting esp when cold or after sitting. The fuel pump is located inside the fuel tank, the fuel tank must be removed to replace the fuel pump assembly.

Feb 09, 2012 | 1996 Ford Ranger SuperCab

1 Answer

99 4.0 started running real rough under load


sounds like a weak fuel pump.Check fuel pressure if not within specs replace pump.It should be 56-72 psi with key on engine off.

Apr 26, 2011 | 1999 Ford Ranger SuperCab

1 Answer

Son's 91 ranger idols fine you can rev engine.but as soon as you take off in a few seconds it starts to shake and die.


this sounds like it is not getting enough fuel to engine. change fuel filter, and check to make sure air filter is clean. also check the fuel pressure regulator if need be.

Jan 27, 2010 | 1991 Ford Ranger Supercab

2 Answers

86 Ranger 4X4 2.9 fuel inj runs rough when warmed up


1988 ranger 2.9 runs great cold then after a few minutes when warmed up hesitates with intermittent black smoke from the tail pipe until i hit the the throttle then clears and will repeat this behavior...

Jan 26, 2010 | 1986 Ford Ranger 2WD

1 Answer

1992 Ford Ranger XLT V6 wont start without ether


first go to an auto partstore and have the code checked. most do it for free. could be coil, fuel pump, fuel filter, air filter or even a bad gas cap. but the dianogstic test should pin point the problem.

Jul 01, 2009 | 1992 Ford Ranger

1 Answer

87 ford ranger wont start without starting fluid


It sounds like you aren't getting fuel out of the cold start injector... remove the injector when engine is cold and switch on ignition... you should get a fine spray pattern for a few seconds... if not then there is probably a problem with the cold start circuit (Temp sensor fault), or the injector is faulty. pull electrical connectors one at a time and look for corrosion... Hope this helps...;-)

Apr 15, 2009 | 1987 Ford Ranger

6 Answers

Missing & Spudering


looks like you need a fuel pump. your current pump is dying.
and wont send enough pressure.

May 15, 2008 | 1993 Ford Ranger SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

111 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...