Question about Cars & Trucks
It appears that the security immobiliser is not programmed to the key as the signals will be different to the old computer. You may have to go to a dealer service centre to have the key reprogrammed to the computer.
Posted on Feb 14, 2014
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
you need a 6 inch extension, short 3/8 ratchet, 5/8 plug socket, 3/8 swivel "u" joint, (sold at sears) 8mm 1/4 drive socket deep well and 1/4 inch ratchet.
find the coil packs (6 total, three in each head.)
remove the two retaining nuts holding each coil pack using 1/4 8mm socket and ratchet.
twist the pack to break the sticking boot below.
pull up (be careful to not rip the boots however it may still happen but rare.)
remove coil packs, the rear is a little more difficult with the intake.
use 6" extension and u joint and ratchet to remove plugs and replace.
reverse order to assemble. Good luck, and hoped this helped.
Posted on Jan 04, 2009
The easiest way to remove the radio from a 1997 Acura TL is from the front. Assuming you know your anti-theft radio code, disconnect the negative side of your battery. See the last paragraph if you have lost your anti-theft radio code.
Next, remove the plastic wood trim from the dashboard surrounding the radio. To do this open the glove box, reach up inside and push out on one of clips holding the wood trim, as it comes loose grasp the trim from the front and carefully pull the trim until each clip unsnaps from the dash. The attached Heater/AC control panel above the radio comes off with the wood trim, so just unclip the 2 wire harnesses from the back and set trim panel aside.
Next, using a phillips screw driver, remove the 4 screws holding the black plastic radio frame into the dash, then pull the radio forward to remove it. Disconnect the 2 wire harnesses and antenna cable from the back of the radio to complete the removal. If you are putting in a replacement radio, just loosen the two small bolts holding the radio on the back of the frame, and then slide the radio out of the frame.
Posted on Jun 15, 2009
I dont know about your other problems with the solenoid or etc., but i recently replaced the starter on my cousin's Acura TL (98yr.).Now if this is your problem I can help,1st. disconnect your battery so you dont get fried!!! LOL,next you have to remove the cv boot or cv axel from the tranne no exceptions.Then you remove the lower bolt (which you get to under the car by the driverside tire)the last bolt is in the back by the fire wall (facing the oppesset side of the stater) they dont tell you that @ the dealers. Hope that the information I provided will help GOD BLESS!!!!!
Posted on Aug 07, 2009
SOURCE: ACURA TL SERVICE DUE SOON B1
It's a service interval reminder light that you should take your car to acura and have them perform the "b1" service. I would ask for an estimate first, and ask what that service includes. You may be surprised to find necessary and unecessary services. Some people view the b1 light as a way for Acura to get you car in there, quite possibly be charged for things you could probably do yourself.
Posted on Apr 16, 2010
Tips for a great answer:
Aug 06, 2016 | 2003 Acura 3.2CL
Jun 03, 2016 | 1999 Acura TL
Dec 10, 2013 | Acura Cars & Trucks
Oct 25, 2013 | 1999 Acura TL
Sep 12, 2012 | 1996 Acura TL Series
Jun 27, 2012 | 1999 Acura TL
Jan 06, 2010 | 1999 Acura TL
52 people viewed this question
Usually answered in minutes!