Question about Mazda Cars & Trucks
Posted by Anonymous on
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
change the transmission fluid, replace the oil and oil filter check spark plug cables, check starter coilpak, and make sure there is coolant
Posted on Jul 25, 2008
SOURCE: need the fuse box diagram
the fuse box lid normally has a diagram on it there is a fuse box under the dash on the driver side and there is one under the hood as well.and if it does not have a diagram stop by the dealer in the parts department and they can print you one if you have an owner manual there is one in there also.
Posted on Feb 11, 2009
had the same prob on mine underneath the front seats are seat belt tensioner plugs 1 under driver and 1 under pass. seat unplug them and plug them back in , i found this solution on this site somewhere and it worked saved me a lot of money, almost took it to the dealer
Posted on Mar 27, 2009
1. Get in your Pathfinder and CLOSE the door. Turn the key on one click to
accessory mode so that all of the other lights on the dash are on but
do not start the car. Now open your door and push the the button inside
your door jamb that turns your interior light on 7 times. Close your
door and then turn your key off.
Now start the Pathfinder...it should be off. If not, repeat this series a couple of times and it will go off. I have had theis happen twice and this is the correct way to fix the problem.
2. Similar story, similar results here too with a 2007 Nissan Pathfinder. Got a new stereo installed, and got a bonus with the blinking airbag light on the instrument panel. Got nowhere with the 7x or 10x domelight press-the-switch voodoo. Bounced into this forum and got the fix that works for my SUV. For the 2007 Pathfinder owners out there: You'll notice the ignition key "beep" is heard only 4 times, not 5.
It took a little patience, as this procedure took me 2 attempts. This is a slight modification from the one mentioned above for the Frontier and the Maxima, but this definitely worked for my 2007 Nissan Pathfinder:
1. Key in, ignition turned to on (but don't start truck).
2. Pay attention to the 4 beeps and watch the dash lights. You're looking for the airbag light to go out just after the last beep.
3. As soon as the light goes out (but BEFORE it begins blinking on you) QUICKLY switch the key back to OFF. Don't remove the key yet.
4. After about 2 or 3 seconds, repeat steps 1 - 3. In total you will do this procedure about 3 times. I say "about" because this all took a couple of attempts, but it was at least 3 cycles.
5. After your last cycle, wait about 5 seconds and turn the key to ON again, and just observe the dash for the airbag light. It should go out and stay out. If not, try it again but maybe add an additional cycle.
Like I said, it took me a couple of attempts but it worked. All credit must go to this website, with special thanks to the poster "LB" ( http://www.carsforums.com/nissan/7423-nissan-airbag-light-reset-fix.html#post65692 )
I hope help you with this. Good luck.
Posted on Sep 14, 2009
first things first is you need to know what code(s) have set
The system readiness indicator light (AIR BAG warning light) is used in diagnosing malfunctions or faults in the air bag system. A fault code will be displayed when the ignition switch is in the RUN position and the diagnostic monitor detects a system fault. Certain faults may not be displayed until approximately 30 seconds after ignition switch has been turned to RUN position. This is the amount of time required for diagnostic monitor to test and verify all system faults.
AIR BAG warning light flashes a series of 2-digit fault codes. For example, a fault Code 32 will be displayed in the following manner: flash flash flash, one-second pause, flash flash, 3-second pause, then the cycle would repeat.
Once you have the code(s) post them here
Posted on Mar 21, 2010
Tips for a great answer:
Dec 10, 2017 | Mazda Cars & Trucks
Oct 22, 2016 | Mazda Cars & Trucks
May 11, 2015 | Mazda Cars & Trucks
Feb 19, 2014 | 1998 Mazda Protege
Dec 27, 2017 | Mazda MX-5 Miata Cars & Trucks
Dec 30, 2012 | 2002 Mazda Protege
Jan 26, 2010 | 1999 Mazda Protege
Aug 27, 2009 | Mazda 626 Cars & Trucks
May 01, 2009 | 1995 Mazda Protege
Apr 05, 2009 | 1997 Mazda Protege
12 people viewed this question
Usually answered in minutes!