Question about Hyundai Motor 2002 Sonata

Open Question

Egine light came on

My wheel barring went bad on my front wheel drive 2002 hyundie one off them was messed up pretty bad ond the other on one was going out will this cause my speed sensor to go bad i can unhook my battery cable and it gose out but *** soon as i drive fore a short distance it comes back theirs nothing jerking don't have any problem with my car changing gears could this be a bad sensor

Posted by Anonymous on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
Ajkill
  • 2035 Answers

SOURCE: 2002 Hyundai Accent lost power

Just the change dipstick and the oil in the car and also check if there is any debris in the car as the broken dipstick which may cause damaged to the engine ,You found the problem it was the oil burn which is causing the loss of power ,and also clean the alternator ..


Good luck....

Posted on Dec 30, 2008

Ad
csmock132
  • 4669 Answers

SOURCE: 2000 Hyundai Sonata jerking and causing poor performance

The turbine shaft speed sensor can cause this problem, It is also know as the transmission input shaft speed sensor. It will cause the transmission to **** and also stick in 3rd gear, which wound cause slow acceleration.

Posted on May 18, 2009

CGYaprentice
  • 58 Answers

SOURCE: replacing output speed sensor on 2002 sonata

Agreed, your sensore is telling you somethings wrong with the trany. replace the sensor last. from what you describe you have a worn out fritchion cltuch plate. check your trany fluid for shiny particles in the oil or paper like material. this is telling you your tranys clutch plates are going and going fast.

and to find the sensor it will be on the out put shaft part of the trany. it will be on the out side with 2 wires going to it. (this is a hall effect type sensor) it will have a retainer holeing it into place.(possibly an 8 mm bolt) sohuld be the same front and rear wheel drive. front wheel drive is harder to find but look at the axle shalfts and where they conect to the trany. this is the ddifferential. it should be close to this location if not look closer to the main body of the trany. along the back side closest to the fire wall.

Posted on May 29, 2009

  • 47 Answers

SOURCE: check engine light flashing, car shaking and smells like gas

it could be anything have the code checked odds are it is a bad sensor

Posted on Sep 26, 2009

  • 1 Answer

SOURCE: 2001 Hyundai Santa Fe - Engine Code P1602, stuck in gear

Im having the same problem with my 02 Santa Fe. How do i go about fixing this problem? And is it costly? Please help

Posted on Jan 31, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

3 Answers

How can i tell if the ball joints are bad on a


you have to jack up the lower control arm out by the wheel then using a bar pry up on the wheel there should be very little if any play then grab the top and bottom of the wheel and try to move the wheel back and forth there should be no movement at all. the up and down movement is measured in thousands of an inch.

Oct 05, 2014 | 2002 Ford Taurus

1 Answer

Something fishy


First check the fuse box for any fuses related to the 4x4.

Mar 04, 2014 | 2002 Chevrolet Silverado 2500HD

1 Answer

2002 explorer has a thumping noise in the front end


Check the radius arm bushings or the lower balljoint .

Mar 04, 2013 | 2002 Ford Explorer

1 Answer

Does a 2002 taurus have wheel barrings


Possibilities are:
  1. Bad wheel bearing
  2. Bad tie rod
  3. Bad ball joint
  4. Bad strut
  5. Loose lug nuts
Most cases it's a wheel bearing but since you're getting a loud noise too, it could very well be a bad ball joint or tie rod end.

Oct 18, 2011 | 2002 Ford Taurus

1 Answer

What causes my ABS brake lights to come on. (2003 Dodge 3500 Dually)


This abs light may be on due to a bad wheel seed sensor, this is the most common reason, some dodges use the rear sensor inside the top of the rear diff, or one at each rear wheel but the front is one at each wheel, whenever the abs light is turned on by the computer it stores a code of what went wrong, for example the code may read b1022 right front wheel sensor, this would tell you there a problem with that sensor, this is pretty simple the only thing is getting the codes, a scan tool needs to be hooded to truck in order to get the codes,the most common one that goes bad is the rear one in the differentail,once the problem is fixxed theres no need for scan tool, just drive down the road and light will reset, check the front sensor wiring and if they look good and you dont want to scan it then start with the rear, but i would have it scanned and get the correct one from the start. hope this helps.

Feb 18, 2011 | 2004 Dodge Ram 3500 Truck

1 Answer

2002 2500 silverado - 4-wheel drive makes clicking noise some times, mainly when cornering. Now the nose went away, and no 4 wheel drive anymore. 4-wheel drive light is on, but no 4 wheel drive. Vehicle...


well typically is there is a noise when making a turn its caused by a bad cv-joint but if your having problems with the 4 wheel drive i would look at the linkage to the transfer case and make sure there is not to much play or bent or broke rods and stuff.

Dec 04, 2010 | 2002 Chevrolet Silverado 2500HD

1 Answer

Service egine light comes one when I drive aggressively and now and then a light that says reduce engine speed comes on.


there is a really cheap tool its about 60$ Its called an OBD tool you get it at the AUTOPART store and plug in under steering wheel dash

Jul 19, 2009 | 2002 Chevrolet TrailBlazer

2 Answers

Airbag light flashing


As long as the light is on the airbag system is disabled.

I would suspect that your clockspring behind the steering wheel is going bad. I would have someone with a scan tool that is able to retrieve trouble codes from the airbag system check it for codes to verify this. If so then steering wheel and steering column trim would have to be removed to access the clockspring to replace it.

Apr 01, 2009 | 2002 Lincoln LS

Not finding what you are looking for?
Hyundai Motor 2002 Sonata Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...