Question about 1997 GMC Sierra

Open Question

1997 gmc sierra blower motor making a noise - 1997 GMC Sierra

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: 2003 GMC Sierra heater Blower wont shut off

My 2003 Sierra's blower came on by itself in the garage while I was sleeping and ran the battery completely down. I had to replace the blower switch located under the glove box next to the blower at the bottom of the right corner of the dash. The switch is in front of the blower and held in by two screws. Disconnect the two wire connections. This is a "dealer only" part and cost me 65.00. Also check the wire harness with seven wires connected to it for melted plastic. It will be marked "ABCDEFG". If it has melted, you'll need to replace it. Pay attention when reinstalling either part, that the wires "ABCDEFG" match the switch in that order.

Posted on Jan 17, 2009

  • 59 Answers

SOURCE: 1997 GMC Sierra Ignition Switch Replacement

take off the cover on the top and bottom of the steering column just behind the wheel. pop the tilt lever out simply just by grabbing it and give it a good tug. then once you have the new switch and you get in there your going to need an inverted torx socket to remove the small bolts that hold the switch to the column. do not move the gear on the new switch make sure it lines up exactly as the old one did!!!!!!!!!!!!

Posted on Mar 15, 2009

  • 10 Answers

SOURCE: fuel pump fuse located on 1997 gmc sierra

The fuse is actually a Relay Switch and its located in the Fuse Relay Center on the driverside of the engine compartment. The Black Box is labled Fuse Relay Center, the diagram on the cap displays which Relay is the Fuel Pump relay...the Relay switch is usually $8-$15 depending on where you shop

Posted on Jul 28, 2009

ministock48
  • 258 Answers

SOURCE: 1996 GMC blower motor only works on high speed.

more than likely yes the resistor

Posted on Oct 22, 2009

  • 11 Answers

SOURCE: como hago para poner a tiempo el motor de gmc

you need to disconnect the wire in the rh floor board of cab and then you can check timing.

Posted on Nov 13, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to replace the blower motor on a 1997 gmc sierra k1500 with a/c


go to the next web and proceed according :
http://www.ehow.com/how_5815954_replace-gmc-a_c-control.html

God bless you

Jun 30, 2012 | 1997 GMC Sierra

1 Answer

How to replace blower motor on 1994 gmc sierra


My fan motor quit working. Is there a site I can get pictures and instructions to replace myself. Thanks.

Feb 19, 2012 | 2000 GMC New Sierra 1500

1 Answer

Air condition is cold but the fan is not blowing air on a 1997 gmc 1500 truck checked the fuses in truck..


the first thing i would check is the relay for the blower motor. if the relay is operating properly the blower motor or the resister may have failed. on your vehicle the blower motor and the resister are a single assembly. its behind the glove box, fairly easy to replace.

Aug 21, 2011 | 1997 GMC Sierra

1 Answer

1997 GMC Sierra Truck - how to change the heater motor?


the blower motor is located under the dash on the passenger side, should be able to see it with no problem , think there is 8 screws u have to take out then the blower motor should slip right out

Feb 04, 2011 | 1997 GMC Sierra

1 Answer

Clicking sound from the dash from behind the blower motor in the vent on 94 GMC Sierra


I see this problem is listed as a 2000 GMC 1500, yet you discribe the problem as on a 1994 GMC. The two trucks are very different, if it's a '94, them there are relays mounted on the passengers side firewall under a plastic shield, these will make clicking noises. If it's a 2000, the most common cause for that type of noise is the heat shields on the exhaust manifolds . If the noise is only present after [and sometimes while ] the motor is running, that's the most likley the problem.

Feb 01, 2011 | 2000 GMC New Sierra 1500

2 Answers

1996 GMC Sierra Heater blower motor only works on high speed. How do you change resistor?


The blower motor resistor is located within a foot of the blower motor in the duct that the blower motor blows into. The resistor is actually cooled off by the blower motor blowing across it. It has a wire harness that connects it to motor & fan switch. It is held in place by 2-4 retaining screws. Disconnect wire harness,unscrew retaining screws then lift out. Reverse order to install.

Jan 24, 2011 | 1997 GMC Sierra

3 Answers

How doi locate the resistor for a blower motor on a 1997 gmc sierra 1500


Hi!!
Check under dash, passenger side, if necessary, remove cover to access Blower Housing Assy., the harness has two terminals, one for the Blower Motor and one for the Blower Motor RESISTOR which is fastened by two 7 or 8 mm. screws to the Housing.
Here is a picture of the Blower Housing Assy. showing the Resistor.
1kbron_100.gif
Good Day!! A HELPFUL - 4 THUMBS - rating for this solution would be greatly appreciated. Thank you for using FixYa.

Dec 18, 2010 | 1997 GMC Sierra

1 Answer

2004 gmc sierra 1500 blower motor location


The blower motor is on the passengers side under the dash.You might have to remove the a lower panel.This is the insulator panel.If the blower works at all just turn it on and follow the noise.Hope this helps.Good luck.

Apr 08, 2010 | 2004 GMC Sierra 1500 Crew Cab

1 Answer

How do u get the fan off the motor on my 1997 gmc sierra 4x4


You will need the fan removing tools. I think the manufactures keep making it harder for the do-it-yourselfers. You should be able to buy them at almost any parts store or some will even rent them to you. Either way life will be easier for you with the fan tools. Also I assume you are talking about the fan on the engine and not the fan on the blower motor... however just in case you mean the fan on the blower motor dont try to remove it. Its pressed on and usually breaks trying to take off, just get a motor with a fan already on it! Which ever fan you are trying to remove I hope this helps! Good luck!

Mar 13, 2010 | 1997 GMC Sierra

Not finding what you are looking for?
1997 GMC Sierra Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Freddy

Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...