Question about 1991 Eagle Talon

1 Answer

How do you remove the distributor cap from a 1991 Eagle Talon?

Posted by Anonymous on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert who has achieved Level 3.

  • Eagle Master
  • 400 Answers

They have a coil pack; no distributor cap.

Posted on Jan 12, 2016


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 331 Answers


here is the locations for the turbo and non-turbo models
ebf96e3.jpg 90fef7c.jpg

Posted on Aug 20, 2008

  • 65 Answers

SOURCE: 1995 eagle talon wont start


You did not specify if its petrol or Diesel I am assuming it is diesel. It might be the glow plugs. Get them checked as you will need these to get it started. If its petrol its a different issue. It might be the ignition coil (no spark) coming to the distributor. Whichever the type of car make sure that there is fuel coming to the engine. In the case of diesel you should have a primer rubber fuel pump which you press in order to bring fuel to the engine.

Hope this was of help to you :)

Posted on Jan 07, 2009

  • 37 Answers

SOURCE: up my boost on 97 eagle talon

Hello, I wouldn't up the boost without supporting mods. The stock motor will take 18psi of boost, but you run the chance of over heating your internals, hitting fuel cut, leaning out your fuel mixture to much, and all sorts of other bad news.

Posted on Mar 26, 2009

  • 1 Answer

SOURCE: Replacing timing belt on 95 eagle talon How do I

just did one this week, if your talking about the mount plate you have to jack the motor up as high as you can comes out one way and goes back the same have to play with it... bad designe on uniboby for a mataince project.

Posted on Apr 24, 2009

  • 8269 Answers

SOURCE: How to put the Starter


See Figures 5, 6, 7, 8, 9 and 10

  1. Disconnect the negative, then the positive battery cables from the battery.
  2. For 1990-94 vehicles, remove the battery and battery tray from the engine compartment.
  3. For 1990-94 vehicles, detach the speedometer cable connector from the transaxle.
  4. For 1995-98 2.0L turbo engines, remove the air hose.
  5. For 1995-98 2.4L engines, remove the air cleaner and air intake hose.
  6. If equipped with 1.8L engine, remove the bracket on the lower side if the intake manifold.
  7. Detach the starter motor electrical connections.

Fig. Fig. 5: Exploded view of the starter motor and related components-1990-94 vehicles, others similar


Fig. Fig. 6: Unfasten the BAT terminal connector from the starter motor


Fig. Fig. 7: Unplug the starter motor electrical connector

  1. Unfasten the starter motor mounting bolts, then remove the starter from the vehicle.

Fig. Fig. 8: Unfasten the starter mounting bolts

Fig. Fig. 9: Remove all of the starter mounting bolts ...

Fig. Fig. 10: ... then remove the starter motor from the vehicle
To install:

  1. Clean both surfaces of starter motor flange and rear plate. Install the starter motor onto the engine and secure with the retainer bolts. Tighten the retainers to the specifications shown in the accompanying figure.
  2. Attach the electrical harness connector(s) to the starter.
  3. If removed, install the intake manifold stay and tighten the retainers to 18 ft. lbs. (25 Nm).
  4. For 1995-98 2.4L engines, install the air cleaner and air intake hose.
  5. For 1995-98 2.0L turbo engines, install the air hose.
  6. For 1990-94 vehicles, attach the speedometer cable to the transaxle. Install the battery tray and battery.
  7. Connect the positive, then the negative battery cables.
Operate the starter to assure proper operation.

Posted on Oct 29, 2010

Testimonial: "Very happy AAAAA++++++"

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the distributor on a 94 eagle talon located

It should be under the hood. The spark plug wires goes to towers on distributor cap. I don't know litre size of engine?

Oct 21, 2016 | Eagle Cars & Trucks

1 Answer

How do I remove the distributor cap from a 1991 Eagle Talon?

on the cylinder head passenger side of the cam sensor yhis is what controls whitch plug get fire and when ,it may be wet but should be dryed out by its self by now, I would look more at the plug in connector from the crankshaft sensor it is located on the top of the transsmisson were the eng. block meets the trans

Feb 13, 2014 | 1995 Eagle Talon

1 Answer

1991 eagle talon wont rev past 2500rpm

May not be getting enough fuel to the engine

Mar 16, 2013 | 1991 Eagle Talon

1 Answer

My 1991 eagle talon will crank but has no firer i have changed the coile pack and still no spark

Have you checked inside the distributor cap? Sometimes on older vehicles the seal will go bad and allow moisture in and corrode the contacts just enough to not allow a spark. Try taking some brake cleaner or simply wiping off the corrosion and putting the cap back on. Hope this helps. Good luck.

Sep 01, 2011 | 1991 Eagle Talon

3 Answers

Firing order for a 1991 eagle talon

info and printed diagram available at your local auto parts store

Sep 07, 2010 | 1991 Eagle Talon

1 Answer

What do i have to remove to get to the water pump in my 1991 eagle talon

I just did this and it was a pain in the a**. You must remove the timing belt and pulleys. If your not mechanically inclined I would have a professional do this job.

May 10, 2010 | 1991 Eagle Talon

1 Answer


remove the battery and the battery mount remove the positive cable from the batery look on the back side of motor where you removed the mount and you will see the starter remove the two bolts faceing you and it will come right off then simply removethe cablr on it and reverse the whole deal to reinstale

Nov 29, 2009 | 1991 Eagle Talon

1 Answer

1991 eagle talon speedometer not working

Possibly bad vehicle speed sensor causing problem

Mar 29, 2009 | 1991 Eagle Talon

1 Answer



Initially, pls check:
  • ECU;
  • cam/crank position sensor;
  • ignition module, distributor, rotor, distributor cap;
  • alarm, security and/or immobilizer.
Try checking likewise the electrical connectors and verify that your ignition system is receiving +12VDC when the ignition switch is turned to ON.

Worst case scenario is timing belt

Hope this be of initial help/idea. Pls post back how things turned up or should you need additional information.

Good luck and kind regards.

Thank you for using FixYa.

Jul 26, 2008 | 1991 Eagle Talon

Not finding what you are looking for?
1991 Eagle Talon Logo

Related Topics:

165 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eagle Experts


Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Stewart Dibbs

Level 2 Expert

308 Answers

Are you an Eagle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides