Question about 2008 Ford Ranger

Open Question

2008 ford focus blend door actuator motor turns one way

Posted by Anonymous on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 13 Answers

SOURCE: trying to remove dashboard to access blend door actuator and

www.heatertreater.net

Posted on Jan 04, 2009

  • 30 Answers

SOURCE: where is the blend door actuator in a 2000 ford

look behind the glove box area to the left square motor

Posted on Mar 11, 2009

harley9701ha
  • 424 Answers

SOURCE: cant find the blend door actuator on 2003 ford f150 super crew

The temperature blend door actuator is located on the right side of the transmission hump under the evap. case. The floor ducts cover it.

Posted on Jun 22, 2009

  • 5 Answers

SOURCE: how to replace blend door actuator in a ford

I recently did mine, I hear you can do it without taking the entire dash apart but I had no luck with it myself. I have to get ready for work but, on mine it was located down and to the left of the radio. its a white box...are you hearing a clicking noise or something? I had to roll the entire dash back and it was still a major pain getting it out.

Posted on Dec 07, 2009

bunnydawg
  • 5158 Answers

SOURCE: 2002 Ford Crown Vic 4.6L. EATCM A/C, Heating

that clicking noise you hear is likely a relay in the fuse panel that needs to be replaced. the easiest way to find out which relay it is would be to put you finger on each relay as you actuate the device not working. once you locate the clicking relay replace it . to reset the computer just unhook the battery for about ten minutes. if you have an anti theft radio make sure you know the code for it and how to enter it before you unhook the battery.

robert

Posted on Nov 27, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is rhe air temp. Door actuator in a 2003 ford 450 truck


Ford Superduty Erratic Temp Blend Door Actuator Removal - YouTube

? 12:29
https://www.youtube.com/watch?v=dYPOtin3JUk
Dec 1, 2013 - Uploaded by FordTechMakuloco
Only buy the Ford Actuators, you can get them cheaper here- ...

Simple how to fix blend door heater a/c actuator 2002 - 2008 ford ...

? 7:12
https://www.youtube.com/watch?v=EEWuJuhCtmc Aug 24, 2013 - Uploaded by kirk colombo
Simple how to fix blend door heater a/c actuator 2002 - 2008 ford explorer noise .... I literary just finish ...

08-10 Super Duty Blend Door Actuator Location - Dual System ...

? 1:24
https://www.youtube.com/watch?v=s7awF2fTKf4 Mar 22, 2012 - Uploaded by srmastertech
Here is a quick view showing the location of the temp blend door actuators on the Ford Super Duty's with ...

Ford blend door fix - 15 minutes - YouTube

? 3:22
https://www.youtube.com/watch?v=wsjGxreGlkA Jul 21, 2013 - Uploaded by SoonersWarriors
Ford blend door fix - 15 minutes. SoonersWarriors. Loading ... Ford Vehicles: Frequent Blend Door Actuator ...

Blend Door Actuator Ford Super Duty 08-10 - YouTube

? 9:45
https://www.youtube.com/watch?v=mbzjCPYENZQ Oct 4, 2013 - Uploaded by MostExcellentDude
This applies to 2008-2010 F250 and F350 with the dual climate control. This video shows the locations for the ...
blend door actuator 2003 ford f450 Google Search




Aug 16, 2017 | Ford Cars & Trucks

1 Answer

No cold air inside the car


try rechecking the blend door actuator and its connections, fuse, etc. also if your AC system is overcharged it will blow warm air.

Mar 23, 2015 | 2008 Ford Crown Victoria

1 Answer

Ford Taurus X 2008 everytime I turn the heat off it clicks up under the dashboard when I turn the blower on it doesn't defrost my windshield I give off eat


possible problem with blend door actuators if you look under drivers dash to the right you may see the actuator turn off heat and watch it same with rs under dash to the left.

Jan 21, 2015 | 2008 Ford Taurus

1 Answer

2008 ford rangerhave vacuum but no heat


Air Temperature Control Blend Door Failure No Heat or no AC (dependes on where door sticks)

In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called (interestedly enough) the air temperature control blend door actuator. The motor that moves this door fails because the door starts sticking from warping, most common complaint is no heat but it can be no AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car. Always have this problem confirmed by a dealer or qualified repair shop as it is a very expensive repair.

Other causes of no heat in the cabin are engine thermostats that are stuck open (engine runs cold) or air bubbles in the cooling system.

Nov 09, 2012 | 1996 Ford Ranger SuperCab

1 Answer

Hot air not working


Air Temperature Control Blend Door Failure

In all modern cars there is a tiny DC electric motor driven gear drive that moves a plastic door that blends heated and cooled air from the AC and the heater core, this is called (interestedly enough) the air temperature control blend door actuator. The motor that moves this door fails because the door starts sticking from warping, most common complaint is no heat but it can be no AC as well. To replace these parts (blend door and blend door actuator) you must remove the entire dash from the car.



Oct 30, 2012 | 2000 Ford Focus

2 Answers

2004 f350 ford heater blows cool air but hoses are both warm-where do i start looking


check to see if the blend door is moving where you change the temperature setting. I think your blend door is behind the glove box. Here are instructions for removing the actuator. Take it off, plug it back in and see if the motor rotates. Also check to see if you can rotate the blend door by hand. If you can rotate it by hand, the motor is probably broken of the gears are stripped. Let me know if you have questions.
  1. Release the stops and lower the glove compartment door.
  2. Disconnect the connector.
f4b0b74.gif Fig. Blend door actuator-F-250 & 350


  1. Remove the two screws. Rotate the blend door actuator and bracket assembly. Remove the electronic blend door actuator and bracket assembly.
  2. To install, reverse the removal procedure.

Oct 17, 2010 | 2004 Ford F350

1 Answer

Heater not working on ford focus diezel year 2000


does your blower motor work or it just blowing cold air?
if it does not blow then check the fuse, the motor may be bad
if it blows cold air only then check your coolant level
check to see if the heater hoses are hot on both of them
if the hoses are hot then you may have a blend door actuator bad

Mar 08, 2010 | 2000 Ford Focus

1 Answer

Where is the blend door actuator in a 2000 ford focus


look behind the glove box area to the left square motor

Mar 08, 2009 | 2000 Ford Focus

2 Answers

Need to replace ac blend door motor inside dashby glove box does dash have to come out and how much trouble is it?


the bummer is removing instrument panel. big job.

A/C Electronic Blend Door Actuator Removal
  1. Disconnect battery ground cable (14301). Refer to Section 14-01 .
  1. Remove instrument panel (04320). Refer to Section 01-12 .
  1. Remove four A/C electronic blend door actuator retaining screws.
  1. Remove A/C electronic blend door actuator.


2c01b1e.gif
Item Part Number Description 1 18471 Heater Air Plenum Chamber 2 42141-S8 Screw (4 Req'd) 3 — A/C Electronic Blend Door Actuator 4 — A/C Air Temperature Control Door Shaft (Part of 18471) 5 19D842 A/C Air Temperature Control Door

Feb 23, 2009 | 1997 Lincoln Town Car

Not finding what you are looking for?
2008 Ford Ranger Logo

Related Topics:

65 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

fordexpert

Level 3 Expert

5501 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...