Spark plug wiring on distributer cap on firing order

You have a plug wire crossed check the firing order, you can look on the net for your make, model and engine size to locate the correct order. I hope this helps. Take Care.

The firing order is 1 6 5 4 3 2 for 4.3L engine.

Answer to firing order

Firing order for 1992 chevy astro 4.3L, From front of engine driver's (left) side No.1, to right front, No.2. left side middle cyl. No.3. Right side mid. cyl. No.4. Rear cyl. left side, No.5. Rear rihgt No.6. On the Distributer cap from No.1 (should be marked) plug tower order is 1,6,5,4,3,2.


Read more: http://wiki.answers.com/Q/What_is_the_firing_order_for_a_1995_Chevy_Astro_4.3L#ixzz1OeLSDOuP

It should be .060

You need 3 things.
Compression
Good hot blue spark to all plugs.
Good gasoline and proper fuel pressure. 13-13.5 lbs on your TBI
If you have all 3 then move on to injector pulse to both injectors.

Keep me posted and recheck your spark plug wire to make sure they are not crossed. firing order 1-2-3-4-5-6 cylinder # passenger side 1-3-5 front to back. cylinder # drivers side 2-4-6 front to back
distributor #1 is located at the 7 o"clock and rotates clock wise so next distributor post on the right working clock wise is #2. Good luck and hope this helps.

FIRING ORDERS

To avoid confusion, ALWAYS replace spark plug wires one at a time.

The most important thing to remember about the removal and installation of a distributor, cap or spark plug cable is that all wires MUST be labelled before they are disconnected. Keep in mind that these figures depict a firing order where the distributor cap terminals are relative to EACH OTHER only and they do not necessarily depict the tower positions in relation to the rest of the engine. This is true because any distributor which has been removed and reinstalled may have been installed with the No. 1 spark plug tower at any position (360 degrees) in relation to the rest of the motor, as long as the rotor aligned to the No. 1 tower when the No. 1 cylinder was at TDC of the compression stroke (valves closed, ready for the plug to fire). As long as the remaining wires were connected in the correct firing order sequence (depending on direction of distributor rotation) the engine will run. DO NOT EVER remove more than one wire from the distributor cap at a time unless you tag ALL wires and towers to assure proper installation.



Fig. 1: 1.9L engine . Firing order: 1-3-4-2 . Distributor rotation: counterclockwise



Fig. 2: 2.0L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise



Fig. 3: 2.5L engine . Firing order: 1-3-4-2 . Distributor rotation: clockwise



Fig. 4: 2.8L engine . Firing order: 1-2-3-4-5-6 . Distributor rotation: clockwise



Fig. 5: 4.3L engine. Firing order: 1-6-5-4-3-2 . Distributor rotation: clockwise

I hope help you with this (remember rated this help) Good luck.

Since you didn't state whether it is a V6 or V8, I'll give you both.

V6 -4.3Liter
Firing Order is 1-6-5-4-3-2
Distributor rotor turns Clockwise
Number 1 spark plug tower on distributor cap, faces the front of the engine.

->Drivers side, spark plug order in engine, starting from the Front going back:
1-3-5
->Passenger side, spark plug order in engine,
starting from the Front going back:
2-4-6

If it's Electronic, the distributor cap has a Left side, (Drivers side), and a Right side, (Passenger side)
Starting from the Front, going back on the Left side,
3-1-5
Starting from the Front going back on the Right side,
2-4-6

V8-5.0, 5.7, and 7.4Liter
Firing Order is 1-8-4-3-6-5-7-2
Distributor rotor turns Clockwise
Number 1 spark plug tower on distributor cap,
faces Front, towards the Drivers side.

Electronic distributor cap has two sides. Drivers, (Left), side and Passenger, (Right), side.
Starting from Front going back on Drivers side,
1-7-3-5
Starting from Front going back on Passenger side,
8-2-4-6

Spark plug order in engine, starting from Front going back, Drivers side:
1-3-5-7
Spark plug order in engine, starting from Front going back, Passenger side:
2-4-6-8

Is it the firing order tht u require or?
If it's the firing order and if it's a 4 cylinder engine thm its 1-3-4-2 and remember the distruibutor rotor travels anti-clockwise.
Good luck.

3.9L V6 Engine. Engine Firing Order: 1-6-5-4-3-2. Distributor Rotation: Clockwise.............did i guess the right motor? let me know/rate me