Question about Dodge Cars & Trucks

Open Question

Fuel leaking some where on 1992 dodge 5.9l cummins ve injection pump

Posted by Anonymous on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

  • 52 Answers

SOURCE: 97 dodge nostart no power coil, injecter, fuel pump run with key on.

Semi electronic system--replace the brain..full electronic --same.

Posted on Oct 12, 2008


SOURCE: 1999 dodge cummins 2500 front axel seals

you need to pull off wheels,brakes, rotor /unit hub bearing, both axles and intermediate shaft, as well as the vac disconnec ton the front axle tube. if only the right side leaks then only then only pull the right axle and intermediate shaft and vac disco. it is a trick with a miller tool to replace the seal. the left side seal is inside the diff and the carrier has to come out to replace it. pete

Posted on Jun 26, 2009

  • 52 Answers

SOURCE: 2001 Dodge Truck, cummins, should the fuel pump

absolutely will, for 30sec or so... The ECM sends power when keyed on and when it senses engine rotation.The VP44 has to have possitive psi to self lube, at least 6psi.

Posted on Aug 30, 2009

  • 159 Answers

SOURCE: 2000 dodge ram diesel 2500 . what is a fuel inject...

This usually happens when the lift pump gets worn and fuel pressure drops below 7lbs and the injection pump has to work harder by pulling in the fuel and will destroy the pump,your is probably a vp44 fuel injection pump it needs replaced and they are expensive 1200.00+ but also change the lift pump or change to a fass fuel system,if the lift pump went out and you replace the injection pump it will ruin it in a short time.
The injection pump is not an easy job to change or for a novice mechanic as it has to be set in time with the engine at top dead center,and then the whole fuel system needs to be bleed of air.

Posted on Jun 05, 2010

  • 2 Answers

SOURCE: 2001 dodge cummins no power to

2001 does not have a crank sensor.... just a camshaft sensor in front of motor. no crank sensor st starter. I have a 2001 dodge cummins 3500 automatic .... when i bought it i had it checked out at dealership it had 20 psi on lift pump but they said lift pump was bad. truck loses throttle response at low rpm and speed after 55 runs fine. now its having trouble starting acts like its flooding and diesel fuel is getting in the oil. i changed lift pump still had 20 to 22 psi so that was wasted money. have also spent 4 hours hunting the engine over with starter and exhaust off trying to install a crank sensor the dealer sold me .... i tell ya its BAD when the guys at ADVANCE AUTO know more than the dealer.. they said it dont have a crank sensor but it does have a cam sensor. right above the injection pump in a hard to get to hole!!! let me know if yall got any ideas... think my code is a 0160 something about injection timing is wrong... dont remember right now and the paper is in the shop.... thanks for any help maybe i can find this fourm again i am new to this.

Posted on Aug 08, 2012

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

I have a 98 dodge cummins: the truck will be a full power and the lose power for a few seconds (almost like shutting the key off) and the will pick back to normal power and repeat this sequence about

this may help:

I have a 97 Cummins. Lots of warnings about lift pump failure or cracks in fuel hose leading to problems with injector pump - $$. There are several really good cummins forums that can be very helpful as well - just google "ram diesel forum" lots of sharp cummins guys.
this is one of my favorites

Turbo Diesel Register

Jan 03, 2015 | Dodge Cars & Trucks

1 Answer

Will a 8.3 p7100 injection pump fit on a 5.9L 12v cummins. 1992. and how much added hp will it give the truck?

The 8.3 p1700 pump was fitted to a cummins 6ct 8.3 l which was rated at 275 hp
the 5.9 was fitted as a v6 or 6.7 v8 cummins fitted to Dodge and is currently available with up to 385hp
as the two engines are not of the same generation, I doubt if you will experience much of an improvement for the time and money. The best people to answer this question for you will be the technical division of cummins engines on the wed.

Dec 28, 2013 | Dodge Cars & Trucks

1 Answer

Checking timing on bosch ve type injection pump

put some fuel in it then turn the pu,p ovedr till you see fuel spit from no1 ,also if this is a rotary pump you remove the little cover on the side of the pump and look at the letters ,i cannot for the life of me remember what they are and all my notes from the ford training centre in daventry got eaten by mivce when i moved to spain ,you could ask in your local bosch agent /repair centre they would know

Dec 28, 2013 | Dodge Cars & Trucks

1 Answer

Where is the oil pressure sensor on a 1992 dodge cummins?

It's mounted in the engine block under the injection pump on the driver side of the engine. It's right up against the power steering pump, above a motor mount.

Mar 17, 2013 | 1992 Dodge Ram 250

2 Answers

My 5.9 dodge cummins diesel won't start, I've replaced the fuel lift pump, and the fuel filter, turns over. But will not start?

Most likely you just have air in the lines.Crack them open one at a time and bleed them with the fuel pump off and on till you get fuel.If it fires dont hit the throttle let it sit and idle and close the line.Does it fire up with a small whif of starting fluid?

Mar 17, 2013 | 1999 Dodge Ram

2 Answers

92 dodge ram cummins power steering?

Yes they have power steering.

Apr 22, 2010 | 1992 Dodge Ram 250

2 Answers



Jul 21, 2009 | 2000 Dodge Ram 3500

1 Answer

1999 dodge diesel 2500 seems to have a fuel related problem.

Please clarify the "loosing power" does it lose power and shut down or does it loose power but will idle? Your Cummins is electronically controlled so oil condition is important, fuel leaks, oil leaks, leaks in the air ducting between the turbo and the intake, sensors, water in the fuel. Do you get an engine light when this trouble happens? Dodge uses a lift pump to carry fuel to the the injection pump, is it working?

May 31, 2009 | 1999 Dodge Ram 2500 4WD

1 Answer

Engine replacement

any of the non computerized aka 12 valve cummins will interchange going from the p7100 pump on the 94 to the ve injection pump on the 92 may mean rerouting some of the fuel lines to hook it up. make sure you use all the sensors from the 94 engine though so all your gauges read correctly other than the fuel system the engines are identical though so should have no issues doing this

Apr 27, 2009 | 1994 Dodge Ram 3500

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

30 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides