SOURCE: PCM Troubleshooting Check light on with no code reader power
You can't jump the connector to get codes on OBD II. (Pre 1996) Try hooking back up you code reader. If it doesn't communicate, check the fuse for the cig lighter. This fuse should also power up the diagnostic plug.
SOURCE: 1990 wrangler YJ speedometer doesn't work ( electrical?)
Ok...if i have this right, you have a cable driven speedometer with a gizmo connected in between which you bypassed with one continuous cable. and the speedometer still does not work? If so, find another working unit and replace it. If you find a unit with a reading close to what yours reads, that's fine. keep the reciept for the unit and just make a note on what actual miles were at the change. A dealer would need to be more precise but its over 20 years old! no one is going to care waht the miles are and it's more important to know hwo fast you are going!!!
SOURCE: 2002 Buick Rendezvous - Rear Wiper, Back Up & Rear Plate Lights
look for rear wiper fuse and relay.because both circuits is tie together . look in glove compartment for the manual .it will show where all fuses and relays located.
SOURCE: 2001 F250--Instrument panel lights don't work
check your operators manual under fuses and find the one for the instrument cluster,it may also feed the cruise.
SOURCE: 2003 Mazda tribute cruise control stopped working
the problem is more likely the cruise cable its self. if you pull the engine cover you will probably fine the cable has fallen off at the throttle body. the only way to fix this problem is to go to the dealer and buy a new cable.
53 views
Usually answered in minutes!
×