Question about 1997 Toyota 4Runner

Open Question

How to replace cupholder in 96 tacoma - 1997 Toyota 4Runner

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

My 96 tacoma isnt getting spark


Time to replace the battery & or Plugs

May 26, 2014 | 1996 Toyota Tacoma

1 Answer

Replace dash cupholder


Hi. This is an easy do. With the cup holder fully extended, slide a flat puddy knibe into the top **** between the cupholder and the the dash. slide it side to side to disengage the stops that are part of the cupholder while pulling out lightly on the cupholder. It should come out without much effort. To reinstall, just push the replacement cupholder into the slot. Good luck!

Sep 20, 2012 | 1996 Toyota Corolla

1 Answer

DOES A 96 TOYOTA TACOMA CLUTCH HAVE AN ADJUSTMENT


it is a self adjusting hydraulic clutch, if the clutch is engaging high on the pedal the clutch is worn out.

Nov 02, 2009 | Toyota Tacoma Cars & Trucks

1 Answer

96 tayota tacoma, 2.7 4 wd, the engine is hard to start when the engine is hot. When cold the engine starts fine.


1. air filter dirty. 2. bad engine ground. 3. fuel filter 4. loose connection in ignition system. 5.faulty idle control system.

Aug 30, 2009 | 1997 Toyota Tacoma

1 Answer

96 Toyota Tacoma lacks take off power and stumbles


Any trouble light? Sounds like it might be misfiring during acceleration which is more related to ignition quality than timing. Check the spark plugs--if badly worn, replace them. Might need new spark plug wiring. Check the air cleaner. Replace the O2 sensor if the truck has a lot of miles. Look for loose or cracked vacuum hoses.

Jul 14, 2009 | 1996 Toyota Tacoma

1 Answer

96 tacoma failed inspection because O2 sensor was ''missing bolt''


i heard failing inspection if your HC AND CO emissions is high.not bolts.take it some where else.

May 29, 2009 | 1996 Toyota Tacoma

1 Answer

E-brake is stuck on 96 toyota tacoma


the rear brake pivots maybe seized. look at the back of the brake drums see where the brake cable meets the brakes, there is a leaver there that is suppost to pivot if it is seized. you will need to remove the drums unbolt the e-brake leaver and take it apart to clean the rust out. you maybe able to unseize it by spraying wd-40 into it and working it, but you will need to take it apart to prevent it happening again.

Apr 19, 2009 | 1996 Toyota Tacoma

1 Answer

96 Tacoma 4x4 2.7 engine cuts out randomly, like its trying to get air or fuel. just installed cold air intake, full tune up, fuel filter, mass air flow sensor, battery cable, hoses, tps(sensor), and...


dont look for air when the car cuts out its most likley spark or fuel when it cuts out ranomly its usually a sensor or relay that is faulty check fuel pump relay and camshaft or crankshaft sensors but first narrow it down to spark or fuel if possible also if check engine lite is on check codes

Mar 26, 2009 | 1997 Toyota Tacoma

1 Answer

96 tacoma 2wd humming noise at 40+


Might be your tires, have them rotated and maybe balenced

Jan 09, 2009 | 2000 Chevrolet Tracker

Not finding what you are looking for?
1997 Toyota 4Runner Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Toyota Experts

yadayada
yadayada

Level 3 Expert

76164 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8273 Answers

Are you a Toyota Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...