Question about Cars & Trucks

1 Answer

Where is control mod work on ford ranger - Cars & Trucks

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert who has written 50 answers of more than 400 characters.


    An expert who has written 20 answers of more than 400 characters.

  • Cars & Trucks Expert
  • 150 Answers

It is very hard to answer you question, when I don't know what control module you are looking for. Like, what Model is it, what engine size, Is the module for the engine, 4 wheel drive, emission control, is it Automatic,or standard.
Give me just a little more to go on and maybe I can help.


Posted on Mar 06, 2014


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Cen-Tech Mod.99722. I plugged it into 2001 Ford Ran. It would not work. I tried it in a 1996 Ford Ranger, it turned on immediately.Tried it again in the 2001 still would not turn on.

Is it a computer, plugged to the DLC? Runs off power from the DLC? If so check power to the DLC. Most power for the DLC comes from he cigarette /power point fuses.

Jan 20, 2017 | Ford Cars & Trucks

1 Answer

Wont start without starter fluid

it is the ignition module or a failed coil . It the spark is faster than cranking speed then it is most likely the module.

Apr 22, 2014 | 1994 Ford Ranger Supercab

1 Answer

1994 Ford Ranger Starts runs for 3-4 minutes then dies, changed ignition mod, fuel pump, fuel filter, fuel pump relay,checked vac hoses, totally lost!!!!!

As with any no-start or stall problem you will need to figure out if it is a fuel or ignition issue.
The high idle usually means you have a vac leak or a problem with the throttle body or idle air control valve. The control valve is how the computer controls the idle speed.
You'll need to watch the fuel system and spark to see which is being affected when the engine dies.
You might want to hook a test light up to the coil to see if it is loosing voltage for example.

Jul 31, 2012 | Ford Cars & Trucks

1 Answer

2005 ford ranger cruise control doesnt work

For ford ranger cruise control troubleshooting,click the link below :----
----------This will help.Thanks.Helpmech.

Feb 07, 2012 | 2005 Ford Ranger

1 Answer

Cruise control not working on 2001 ford ranger. will not turn on,plus overdrive will not work.

Check with a Ford Dealer about a possible recall to replace or install fusible link on cruise control cable located by master cylinder.

Jun 12, 2010 | 2001 Ford Ranger Regular Cab

1 Answer

Wondering if I can take a 3.0 engine and turn it straight?

assuming it is a 3.0 OHV then sure, you can get a trans from a ranger

however, mods will be extensive and costly
you will have to mod the bulk head, subframe, tunnel, exhaust, rear end adding a diff

but if you want anything is possible!

Mar 24, 2010 | 1998 Ford Taurus

1 Answer

I have a 1994 ford ranger, 4.0L. Cruise control

replace your brake light switch and it will all work

Sep 30, 2009 | 1994 Ford Ranger Supercab

1 Answer

Performance Chips

any modification has some degree of danger to it, but as long as it is installed correctly. there shouldn't be any danger. just keep in mind the limits of your vehicle. case in point by brother bought my dad a bully dog mod for a 06 ford f150 fx4. great system and will provide major gas and towing improvements but my dad mr computer illiterate just went and hooked it up without updating the mod controller....fried the computer in the truck. covered under warrenty with a few little white lies but still a 2400 dollar lesson that didnt needed to happen. final note just make sure you follor the instruction and if need be call the mod manufacturer if you have to.

good luck


Jan 17, 2009 | 2003 Ford Ranger Regular Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides