Question about Chrysler Pacifica
Trunk had a latching issue where the trunk was latched but open. I had to manually reset the latch and then close. Since then , recurring issue then eventually the remote, manual button on trunk, and overhead button fail to open the trunk latch, it clicks when these buttons are pressed indicating electrical actuation but no motor/latch movement. I will spray wd-40 on it but would appreciate any insights.
Posted by Anonymous on
You need to replace that latch, I think the return spring must be broken.
Posted on Jul 28, 2017
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: Truck won't shut
Try sticking you finger or screw driver into the jaws of the latch, hit the button or use the key and pull your finger THRU the latch so the jaws open... happens to the latch on my glove box all the time!!!!
Posted on Feb 28, 2009
The small switch is the trunk by the pull down motor with the flap that depresses down is at fault. That is what you call the truck pull down switch. You can take this part and show it to a Cadillac or Ford parts department sales person and get a replacement for you car. Ford uses the same part for their Lincolns and Crown Vic's. The part is made by the very same supplier for Ford & GM. Ford will sell this part at a much lower cost as well compared to GM
Posted on Apr 03, 2010
Testimonial: "This is correct! "
SOURCE: The trunk latch on my
Look closely to see if anything was dropped or anything heavy placed on the latch. It may be bent ever so little. If not then your servo is losing its value and will have to be replaced.
I hope my suggestions helps and all the luck to you.
Posted on Dec 23, 2010
SOURCE: Trunk lid will not close.
check the rubber hose that the wires pass through from the vehicle in to the trunk lid it probably has a broken wire inside. Also check wiring to the boot lock for detachment.
A bit of WD40 or similar fine oil on the lock may free it up too ifs its just stuck which may be worth a try first.
Posted on May 04, 2011
Then you probably have a sticking trunk latch, a weak/partially shorted trunk latch actuator, or high resistance in the trunk latch actuator circuit.
Posted on Jun 03, 2012
Tips for a great answer:
Sep 15, 2014 | 2006 Chrysler 300
on Sep 17, 2015 | Toyota Camry Cars & Trucks
Jul 05, 2013 | Cars & Trucks
Jun 30, 2012 | 2010 Chrysler Town and Country
Jul 19, 2011 | 1999 Bentley Arnage
May 02, 2011 | 2008 Chrysler Sebring Convertible
Apr 21, 2010 | 2008 Volkswagen Jetta
Jul 06, 2009 | 2002 Honda Civic
Feb 21, 2009 | 1999 Mitsubishi Mirage
25 people viewed this question
Usually answered in minutes!