Question about 1989 Peugeot 405

Open Question

Bonnet problem on my 406 coupe the lever clicks but wont release the bonnet its a 2002

Lever inside car works but wont release my bonnet

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
germcelchar
  • 389 Answers

SOURCE: problem with windscreen washers on 1998 peugeot 406

The washer pipe comming from the tank to the jets is probably folding over of touching something between the bonnet and the check the pipe is in place where it folds with the going up and down

Posted on Aug 11, 2009

Ad
  • 1 Answer

SOURCE: Peugeot 406 Coupe v6 . Speedometer Problem

i had the same problem, in behind the glove box there is a black cigarette sized box, this was faults on my 406 coupe and the speedo didn't owrk, or suddenly it shot from 0 while dribing up to 30 or what ever my speed was, it also wrecked my powersteering rack trying to drive it, as it made terrible noises as its speed sensitive. you local peugeot dealer will be able ot get you one. i can't remember how much it cost, sorry.

Posted on Feb 16, 2010

TDISLine
  • 1874 Answers

SOURCE: how to change the spark plugs on peugeot 406 v6 3l

1. Spark plugs removal

1.1. Front cylinder bank spark plugs removal:
1.1.1. Disconnect the battery from car terminals.
1.1.2. Remove the engine plastic cover.
1.1.3. Disconnect the ignition coils electrical supply cable and all three coils connectors.
1.1.4. Remove all three ignition coils screws.
1.1.5. Remove all three ignition coils out from cylinder head.
1.1.6. Remove all three spark plugs out from cylinder head (straight forward).

1.2. Back cylinder head bank spark plugs removal:
1.2.1. Remove the inlet manifold out from cylinder head.
1.2.2. Disconnect all three ignition coils connectors.
1.2.3. Remove all three ignition coils screws.
1.2.4. Remove all three ignition coils out from cylinder head.
1.2.5. Remove all three spark plugs out from cylinder head (straight forward).

2. Spark plugs installation

2.1. Refit all in reverse order.
2.2. Spark plugs tightening torque = 2,8 +/- 0,3 daN.m
2.3. Ignition coils tightening torque = 0,8 +/- 0,2 daN.m

Posted on Nov 16, 2010

Testimonial: "cheers"

  • 2002 Answers

SOURCE: hi my mums got a

It sounds like the cable is dry. With the car turned off spray a lubricant like WD-40 on the exposed end of the cable and work it back and forth as you do. It should free up. It wouldn't hurt to spray the throttle lever either. Hope this helps.

Posted on May 09, 2011

johnf1aresti
  • 1104 Answers

SOURCE: how do i get a car owner's manual for peugeot 406 coupe

why don't you try to get a Haynes Manual for the peugeot 406? It has more advises and mechanical and electrical directions

Posted on Sep 09, 2012

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where is the release catch situated on a 54 plate hyandai coupe ?


in the drivers side its a grey square thing near the bottom near the door frame just above the gas pedal and the over one is under the bonnet in the middle you have lift and feel for a little lever and lift the bonnet and its got a little arm at the side of the wing to put in bonnet to hold it up and make sure you keep the enjectors clean I had the coupe I loved iv got a cdx now 2005 if you more help .mwilliams@gmx.co.uk

Jan 23, 2017 | Cars & Trucks

1 Answer

Im having trouble trying to open the bonnet on my territory, the lever inside the car works, but it doesn't free the latch mechanism inside the bonnet, the wire isn't broken either.???


try coming up in front of the radiator with a long lever and release the bonnet latch
when you have the bonnet up then adjust the cable and tighten up the cable clamp

Aug 21, 2015 | Cars & Trucks

1 Answer

Carnt open bonnet on my audi a4 2002 model, the realease pull works but doesent seem to release fully only a couple inch! any idea's anyone regards mike


There is another lever at the front of the car that you need to release too. This is to prevent the hood flying open if you accidentally pull the release while driving. After you release the latch inside the car, go to the front of the car, near the Audi rings, in the center of the grill there is a small black tab that pops out when the internal hood release is pulled. Pull up on it and the hood will open. Let us know if that works.

Oct 23, 2013 | 2002 Audi A4

1 Answer

Front bonnet catch wont release fully,i pull lever from inside and it releases bonnet just a couple inch, then when try to lift bonnet up it wont open. regards mike, and thanks in advance


There is another lever at the front of the car that you need to release too. This is to prevent the hood flying open if you accidentally pull the release while driving. After you release the latch inside the car, go to the front of the car, near the Audi rings in the center of the grill there is a small black tab that pops out. Pull up on it and the hood will open. Let us know if that worked.

Oct 23, 2013 | 2002 Audi A4

1 Answer

2002 C-Class Mercedes driver-side hood latch stuck and will not release. Cable is not broken...passenger-side and middle opens perfectly fine. How do I fix this problem?


i have the same problem on my Merc C200k coupe 2002 i have been told you have to go through the grill but i cant work out how to get the gill off with out opening the bonnet lol

Jul 18, 2012 | 1988 Mercedes-Benz 300

1 Answer

S864XOP Ford Fiesta Zetec cannot open bonnet - when I pull release lever under steering wheel bonnet does not release completely (when push down on bonnet I can hear the catch click closed). Any...


get assistant to push down on bonnet whilst you pull the lever ,then once you pull back the lever and hold it back they try to lift it so it clicks up a bit then you open it by the safety catch

Apr 24, 2011 | Ford Fiesta Cars & Trucks

1 Answer

Bonnet wont lock


Bonnet is held separately: mechanisms front left and front right. Suggest one latch only is operating/secure in your case; non-secured side will float and sit slightly proud of front wing line. Unscrew mechanism, detatch release cable and free-up "spring and pawl"; refit etc.

Dec 29, 2009 | 2002 Jaguar X-Type

2 Answers

Bonnet won't release on passenger side


try pushing the bonnet down then assistant pulls the lever and release the pressure on the bonnet,might work if your luck is in ,if not look at another one then constructive engineer a length of fence wire to pull the mechanism

Oct 20, 2009 | 2002 Jaguar X-Type

2 Answers

Cant open bonnet on my vauxhall astra 1.4


It sound like it i out of adjustment. I had this same thing occur n my car. Ask an assistant to pull the release lever inside the car all the way, then try to open the bonnet while they are pulling on the lever.

Jul 25, 2009 | 2004 Volkswagen Golf

2 Answers

Bonnet release in grill broke renault megane scenic


when you say the bonnet has been pushed in do you mean like in a traffic accident if this is the case then is your grill damaged,the reason i say this is the only way you are going to open your bonnet is through your grill so a replacement grill will be needed.if you take this course of action,take a torch and look up under the bonnet you will se the bonnet realease at the very front of your bonnet it will have the bonnet realease cable attached you might need help at this stage,get a friend to push down on your bonnet,put your hand in and push or pull the lever until it releases as this works on a hook system and with the damage it might need a pretty stronge screwdriver to force it always remember the radiator is very easly damaged and very costly to replace .Hope this will help you get your bonnet open .adrian

Jan 23, 2009 | 1986 Renault Sport

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

mike hayward

Level 2 Expert

279 Answers

lloyd cole

Level 2 Expert

250 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...