Question about 2007 Honda CR-V

1 Answer

HONDA CRV CRUISE CONTROL DON'T WORK - 2007 Honda CR-V

Posted by on

Ad

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Honda Master
  • 20,706 Answers

The tests are in the FSM. get that and read........
(IIRC end of book)

buy the FSM from , Honda.
or
login to alldata.com BINGO !

Posted on Feb 13, 2014

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

Ad
  • 563 Answers

SOURCE: I have a 2008 Honda CRV and for the life of me I

The cruise-controls have 2-buttons that must be activated before it gets the car going when you remove your foot off the gas-pedal.
The cruise button is essentailly a switch that turns 'on' the cruise servo-motor that tells the sytems that you wants to use it, so it gets ready.
There are other three switches on the right-side of the steering wheel namely: resume accel; cancel; set decel.
To get your car to cruise: you must steady your speed and foot on the gas-pedal. You cannot just press the switches and expect the car to cruise. It takes about two-to-three seconds for the system to respond to a set cruising speed.
How to do it: accelerate to a speed of about 30-mph. Press the 'cruise' button on the dash first. Next you press 'set decel' button. This will turn 'on' the cruise control light on the instrument panel. Then wait a second or three and you would feel the cruise engagement. Any touch on the brake pedal will slow down the car and turns the cruise off. The 'cancel' button turns off the cruise light on the instrument panel.
If you hit the brake-pedal at any time for any reason, and you would like to continue cruising again, simply press the 'resume accel' button.
The cruise system works in conjunction with the braking system of the car. So all major parts of the braking system must be in good condition, otherwise the cruise system could shut off itself.





Posted on Dec 14, 2009

  • 77 Answers

SOURCE: I have a 2005 honda crv, after changing the

There is a cable reel (clock spring) in the steering column. If it was not centered when you put in the rack than it probably broke.... Is the SRS light on too? This cable reel allows electrical connection to the air bag and the cruise control switch (mounted to the steering wheel), so you can turn the wheel. Its operating range is two and a half turns from center in both direction. When you disconnect the steering coupler from the rack the steering wheel moves, now the cable reel is not centered. If you put it back on in this position and turn the steering wheel fully to one side the cable reel breaks. That could be what happened, however the cable reel is very expensive so make sure that's it before replacing. I recommend performing an input test on the cruise control unit to confirm.

Posted on Feb 04, 2010

  • 1 Answer

SOURCE: Want to replace fuse for cruise control on honda crv 2005

The cruise control suddenly stopped working and lites did not come on either, was working fine one day then next day it didnt'. Is there a fuse that might have gone out and if so where is it located?

Posted on Apr 10, 2010

johnjohn2
  • 5763 Answers

SOURCE: replacing cruise control bulb on honda crv 2006

JUST POP SWITCH OUT AND BULB GOES INTO SWITCH USE SMALL SCREW DRIVER TO REMOVE YOU WILL HAVE TO TWIST IT COUNTERCLOCKWISE TO REMOVE, TWIST CLOCKWISE TO INSTALL.

Posted on Apr 21, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2006 honda crv cruise control bulb


Take out the old one.
Remove new bulb from packaging.
Fit new bulb.
Test.

Apr 06, 2014 | 2006 Honda CR-V

1 Answer

2004 crv cruise control


Did you adjsut the cable on the cruise control? Check the cable and the socket to the cruise control actuator in the engine.

Mar 23, 2014 | Honda CR-V Cars & Trucks

1 Answer

Honda crv alarm


If there's a light that says cruise main when lit up, that means your cruise control system is turned on but not active

Jan 23, 2014 | 2007 Chrysler PT Cruiser

1 Answer

2001 Honda CRV cruise control doesn't after getting timing belt replaced


Very likely, the repair shop botched the repair, and failed to reconnect some kind of connection which is critical to the cruse control. Very typical in repair shops these days! I would take it back and complain!

May 11, 2017 | Honda CR-V Cars & Trucks

1 Answer

2003 CRV: light is out on dash cruise control on-off switch, how to fix?


try looking at your brake light switch. My CRV did the same thing, and a new brake light switch later everything works!

Apr 16, 2011 | 2003 Honda CR-V

2 Answers

Replacing cruise control bulb on honda crv 2006


JUST POP SWITCH OUT AND BULB GOES INTO SWITCH USE SMALL SCREW DRIVER TO REMOVE YOU WILL HAVE TO TWIST IT COUNTERCLOCKWISE TO REMOVE, TWIST CLOCKWISE TO INSTALL.

Apr 21, 2010 | 2006 Honda CR-V

1 Answer

I have a 2005 honda crv, after changing the steering rack the cruise control is not working


There is a cable reel (clock spring) in the steering column. If it was not centered when you put in the rack than it probably broke.... Is the SRS light on too? This cable reel allows electrical connection to the air bag and the cruise control switch (mounted to the steering wheel), so you can turn the wheel. Its operating range is two and a half turns from center in both direction. When you disconnect the steering coupler from the rack the steering wheel moves, now the cable reel is not centered. If you put it back on in this position and turn the steering wheel fully to one side the cable reel breaks. That could be what happened, however the cable reel is very expensive so make sure that's it before replacing. I recommend performing an input test on the cruise control unit to confirm.

Nov 09, 2009 | 2005 Honda CR-V

1 Answer

I have a 2008 Honda CRV and for the life of me I cannot engage the Cruise control- I press the Cruise Button on the right of the steer wheel and nothing happens - nothing Help anyone ? Tks Nancy


The cruise-controls have 2-buttons that must be activated before it gets the car going when you remove your foot off the gas-pedal.
The cruise button is essentailly a switch that turns 'on' the cruise servo-motor that tells the sytems that you wants to use it, so it gets ready.
There are other three switches on the right-side of the steering wheel namely: resume accel; cancel; set decel.
To get your car to cruise: you must steady your speed and foot on the gas-pedal. You cannot just press the switches and expect the car to cruise. It takes about two-to-three seconds for the system to respond to a set cruising speed.
How to do it: accelerate to a speed of about 30-mph. Press the 'cruise' button on the dash first. Next you press 'set decel' button. This will turn 'on' the cruise control light on the instrument panel. Then wait a second or three and you would feel the cruise engagement. Any touch on the brake pedal will slow down the car and turns the cruise off. The 'cancel' button turns off the cruise light on the instrument panel.
If you hit the brake-pedal at any time for any reason, and you would like to continue cruising again, simply press the 'resume accel' button.
The cruise system works in conjunction with the braking system of the car. So all major parts of the braking system must be in good condition, otherwise the cruise system could shut off itself.





Sep 28, 2009 | Honda CR-V Cars & Trucks

1 Answer

Want to replace fuse for cruise control on honda crv 2005


The cruise control suddenly stopped working and lites did not come on either, was working fine one day then next day it didnt'. Is there a fuse that might have gone out and if so where is it located?

Mar 28, 2009 | 2005 Honda CR-V

Not finding what you are looking for?
2007 Honda CR-V Logo

Related Topics:

119 people viewed this question

Ask a Question

Usually answered in minutes!

Top Honda Experts

yadayada
yadayada

Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Honda Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...